Lanier Worldwide, Inc.
2300 Parklake Dr., N. E.
Atlanta, GA 30345-2979
Emergency Telephone: (800)526-4371
MATERIAL SAFETY DATA SHEET
Section 1: Chemical Product and Company Information
Identity:
Product ID: 117- 0235
MSDS No.
Issued: 12/16/97
7214 Black Toner
CP-310
Supersedes:
none
Synonyms
& Common
Date:
12/16/97
Names:
Toner, Black Toner
Prepared by:
Lanier QA/EH&S Department
Uses:
M7214 Copier
Mixture
European
Contact:
Lanier Worldwide, WSM Europe,
Walter Fricke,
Im Taubental D-41468 Neuss,
Germany +49-2131-387-177
Chemical
Formula:
Section 2: Composition / Information on Ingredients
PERCENT
CAS No.
29497-14-1
EXPOSURE LIMITS
SOURCE
Styrene butylacrylate-
butylmethaacrylate
copolymer
not listed
n/a
> 90.0
Polystyrene
Carbon black
Polypropylene
Organic ammonium salt
9003-53-6
1333-86-4
9003-07-0
102561-46-6
not listed
n/a
3.5mg/m3 3.5mg/m3
OSHA PEL ACGIH TLV
< 6.0
< 1.0
< 2.0
not listed
not listed
n/a
n/a
*PEL as the product: 15mg/m3 (total dust), 5mg/m3 (respirable dust)
*TLV as the product: 10mg/m3 (total dust), 5mg/m3 (respirable dust)
Section 3: Hazards Identification
Hazard Rating:
FIRE = 1
HEALTH = 1
REACTIVITY = 0
SPECIAL = none
Health Hazards (Acute, Chronic, Immediate and Potential): Minimum irritation to respiratory tract may occur as with exposure to
any non-toxic dust. May cause gasping if inhaled. Inhalation should be avoided. May cause temporary eye discomfort.
Health Hazards of Long Term exposure (Chronic): A manufacturer sponsored chronic inhalation study in rats using a special test
toner revealed there were no lung changes at all in the lowest exposure level (1mg/m3), the most relevant level to potential human
exposures. A very slight degree of fibrosis was noted in 25% of the animals at the middle exposure level (4mg/m3), while a slight
degree of fibrosis was observed at the highest exposure level (16mg/m3) in all animals. These findings are attributed to “Lung
Overloading”, a generic response to excessive amount of any dust retained in the lungs for a prolonged interval. The special test
toner was ten times more respirable than commercially available toner to comply with EPA testing protocol and would not function
properly in xerographic equipment.
Section 4: First Aid Measures
Remove to fresh air if effects occur. Consult
local medical personnel
Inhalation:
Eye Contact: In case of contact, immediately flush eyes with
water for 5 minutes.
Ingestion: Rinse mouth with water. Call a physician.
Skin Contact:
Wash with soap and water.
1
Download from Www.Somanuals.com. All Manuals Search And Download.
|