6
KOMPERNASS GMBH · BURGSTRASSE 21 · D-44867 BOCHUM
ID-Nr.: KH4077-11/07-V1
Download from Www.Somanuals.com. All Manuals Search And Download.
Download from Www.Somanuals.com. All Manuals Search And Download.
KH 4077
w
q
e
g
r
f
t
d
y
u
1!
a
o
i
Download from Www.Somanuals.com. All Manuals Search And Download.
Download from Www.Somanuals.com. All Manuals Search And Download.
Download from Www.Somanuals.com. All Manuals Search And Download.
CONTENT
PAGE
Safety instructions
Description of the appliance
Assembly
2
3
3
4
4
4
4
5
5
5
5
Removing the halogen lamps.
Inserting the halogen lamps
Cleaning
Troubleshooting
Disposal
Technical data
Service
Importer
Read these operating instructions carefully before using the appliance for the first time and preserve this
maual for later reference. Pass this manual on to whoever might acquire the appliance at a future date.
- 1 -
Download from Www.Somanuals.com. All Manuals Search And Download.
HALOGEN WORK
SPOTLIGHTS
ƽ Danger of injuries
• If they have not previously been supervised or in-
structed in its correct usage, do not allow indivi-
duals (including children) to use the appliance
whose physical, sensorial or mental abilities or
lack of experience and knowledge hinder their
safe usage of it if they have not previously been
supervised or instructed in its correct usage.
• Inform children about the appliance and its
potential dangers and that they should not play
with it.
Safety instructions
ƽ Danger of electrical shock!
• Only connect the Stand Halogen Floodlight to
correctly installed wall sockets having a mains
current of 220 - 240 V at 50 Hz.
• Unplug the Stand Halogen Floodlight from the
socket if you notice any faulty operation and
when you decide to clean it.
• Under no circumstances may the Stand Halogen
Floodlight be immersed in liquids, or liquids be
permitted to permeate into the housing.
Should liquids nonetheless gain entry into the
appliance housing, immediately unplug the ap-
pliance from the mains supply and arrange for it
to be repaired by qualified specialists.
ƽ Attention
• Always remove the plug from electrical sockets
before exchanging the halogen lamps.
• Allow the halogen lamps to cool before
removing them.
• Switch the Stand Halogen Floodlight off only
with the ON/OFF switch.
• Never touch the glass covering, the power cable
or the metal housing whilst it is in operation.
These parts of the appliance will become very
hot during use.
• Never touch the Stand Halogen Floodlight,
power cable or plug with wet hands
• To unplug the appliance, always pull the plug
from the socket, do not pull the cord itself
• Do not crease or crimp the power cable and
place it in such a way as to prevent anyone from
stepping on or tripping over it.
• To avoid the risk of injury, arrange for defective
power plugs and/or cables to be replaced as
soon as possible by a qualified technician or by
our Customer Service Department to avoid the
risk of injury.
To avoid burn injuries, do not touch these
surfaces!
• Arrange for a defective glass cover to be imme-
diately replaced by a suitable new one.
• Never direct the halogen floodlights towards
each other. The appliance could be damaged
by the large generation of heat.
• Always ensure that the Stand Halogen Flood-
light is sufficiently distant from yourself and easi-
ly meltable items.
• Separate your Stand Halogen Floodlight from
the mains supply immediately after use.The
appliance is only completely switched off after
having been unplugged.
• To avoid eye damage, do not look directly into
the Stand Halogen Floodlight.
• Never place the Stand Halogen Floodlight in the
close proximity of easily inflammable materials.
• Use exclusively halogen lamps up to 500 Watt.
• Never touch the lightbulb with bare hands.
Always use a dry lint-free cloth.
• Read and observe all safety and operating
instructions.
• Ensure that the Stand Halogen Floodlight has
cooled down before storing it away.
Download from Www.Somanuals.co-m2.-All Manuals Search And Download.
Description of the appliance
Assemble the protective grill on to
r
the halogen spotlights
e
ON/OFF Switch
Floodlight lever
Halogen floodlight
Protective grill
Knurled screw
Crossbeam
³ Insert the lower pegs of the protective grill
q
w
e
r
t
y
u
i
o
a
s
d
f
g
r
into the recesses on the corners before the glass
covering
.
g
³ Squeeze the protective grill
so far together
r
that the pegs on the other side of the protective
grill can be inserted into the recesses there.
³ Do the same with the second halogen spotlight
Telescopic stand
Power cable
Knurled screw
Fixing ring
Mounting the halogen floodlights
on the crossbeam.
e
Distributor box
Knurled screw
Fixing screw
³ Insert the knurled screw
with the washer
t
through the hole in the bracket of the halogen
floodlight
.
e
Glass cover
³ Insert the halogen floodlight
with the knurled
e
screw
in the pre-drilled hole on the crossbe-
t
am . Ensure that the Stoppers are located be-
y
Assembly
hind the halogen floodlights
.
e
³ Turn the knurled screw until it is tight.
t
ƽ Danger of electrical shock
Assembling the crossbeam on the
telescopic stand.
Never insert the plug into an electrical socket until
the appliance has been completely assembled.
³ Insert the knurled screw
first of all through the
d
hole in the distributer box , then through the
s
ƽ Danger of burns
hole in the crossbeam
³ Now assemble the crossbeam
.
y
Only touch the halogen lamps when they are in a
switched-off and cooled-down condition. The halo-
gen lamps will get very hot. Never touch the light-
bulb with bare hands, always use a clean and dry
lint-free cloth.
and the distri-
y
butor box
with the assistance of the knurled
s
screw
on the telescopic stand
.
u
d
³ Turn the knurled screw until it is tight.
d
Adjusting the height of the Stand
Halogen Floodlight
Opening up the pedestal base
³ To set up the telescopic stand , loosen the
³ Loosen the fixing ring
by turning it in an
u
a
knurled screw, . The pedestal base can now
anti-clockwise direction.
o
be opened out to the floor.
³ Adjust the telescopic stand
to the desired
u
³ Turn the knurled screw until it is tight.
height.
o
³ Retighten the fixing ring
by turning it in a clok-
a
kwise direction.
- 3 -
Download from Www.Somanuals.com. All Manuals Search And Download.
ƽ Important!
Inserting the halogen lamps
To adjust the halogen floodlight , use the knurled
e
screw , the fixing screw
and the floodlight
1. Ensure that the Floor Halogen Floodlight is
switched-off and completely cooled down.
2. Take the new halogen lamp from its packaging
with a dry cloth. Place a ceramic end on the
appropriate retainer.
t
f
lever
.
w
The horizontal position is adjusted in that the knur-
led screw is loosened and, with the assistance of
t
the floodlight lever , it is placed in the desired
3. Place the other ceramic end on the opposite
retainer. Ensure that contact has been made
on both sides. The retainers should now hold the
halogen lamp securely, such that the halogen
lamp can no longer move itself.
w
position. Retighten the knurled screw
optimal position has been found.
when the
t
The vertical position is adjusted in that the fixing
screw is loosened and and, with the assistance
4. Now close the glass cover
retighten the middle screw.
and replace and
f
g
of the floodlight lever , it is placed in the desired
w
position. Retighten the fixing screw,
optimal position has been found.
when the
5. Switch the Floor Halogen Floodlight on with the
ON/OFF switch
f
.
q
6. Should it not function, repeat steps 1- 5.
ƽ Important!
During the adjustments always hold the floodlight
lever
firmly.
Cleaning
w
ƽ Important!
Do not use extension cables that are longer than
15 m.
ƽ Danger of electrical shock
Always remove the plug from the socket before cle-
aning the Stand Halogen Floodlight.
Under no circumstances may the appliance be
immersed in water or held under running water
during cleaning.
Removing the halogen lamps.
1. Switch the appliance off with the ON/OFF
Clean the exterior of the Stand Halogen Floodlight
with a moist cloth.
switch , remove the plug from the socket and
q
allow the Floor Halogen Floodlight to cool
down.
ƽ Attention!
2. Remove the middle screw on the top of the lamp
Ensure the Floor Halogen Floodlight is inaccessible
for children.
housing. Loosen the glass cover
.
g
3. Use a dry cloth to take out the halogen lamp.
4. Remove the halogen lamp.
Download from Www.Somanuals.co-m4.-All Manuals Search And Download.
Troubleshooting
Technical data
Symptom:
Mains voltage: 220 - 240 V / 50 Hz
~
Rated output: 2 x 500 Watt
Protection rating:IP44
The Stand Halogen Floodlight will not switch on.
Possible cause and remedy:
Check if the Stand Halogen Lamp has been correct-
ly assembled or if it is possibly damaged. Replace
the halogen lamps if necessary.
Service
DES Ltd
A domestic electrical fuse is defect.
Check the domestic fuses and, if necessary, renew
them.
Units 14-15
Bilston Industrial Estate
Oxford Street
Bilston
The power socket is defective.
Try another wall socket.
WV14 7EG
Tel.: 0870/787-6177
Fax: 0870/787-6168
e-mail: [email protected]
The Floor Halogen Floodlight is possibly defect.
Check the connecting lead and the power plug for
damages. Have the Floor Halogen Floodlight chek-
ked over by specialists.
Irish Connection
Harbour view
Howth
Co. Dublin
Disposal
Tel: 00353 (0) 87 99 62 077
Fax: 00353 18398056
e-mail: [email protected]
Do not dispose of the appliance in your
normal domestic waste.
Importer
Dispose of the appliance through an approved dis-
posal centre or at your community waste facility.
Observe the currently applicable regulations.
In case of doubt, please contact your waste disposal
centre.
KOMPERNASS GMBH
BURGSTRASSE 21
D-44867 BOCHUM
Dispose of all packaging materials in an
environmentally responsible manner.
- 5 -
Download from Www.Somanuals.com. All Manuals Search And Download.
|