MR64 Keypad
Operating
Instructions
MR64
LCD display
Line 1
Line 2
Input
Volume up
and down or
source select or
sets backlighting
select
button
Congratulations and thank you for choosing this
Knoll product. The MR64 keypads are the power
behind an advanced music control system that is
easy-to-7use with top quality sound available in up
to six or more rooms.
INPUT
Volume
select
button
All button for
whole house
functions
VOL
Mute
button
MUTE
ALL
OFF
The MR64 is only for use with the MVP44, MVP64 and
MR640 controller.
Shut off this room
or shut off whole
house (press for
5 seconds).
Infrared
receiver
The MR64 is available with two LCD colors, yellow-
green with black lettering and blue with white
lettering (model MR64b). Both versions are available
with Decora™ style bezel plates in white, almond,
black or ivory colors.
Adjusting Backlighting. MR64’s are backlit for
easy nighttime operation. To
adjust the backlighting make
sure the power for the keypad is
on and the MR64 is displaying:
System
The music system consists of:
1. Rooms with stereo speakers, a MR64 or MR60
keypad or infrared receiver and a remote control.
2. One or more MVP44a, MVP64a or MR640
controller(s).
3. One or more multi-zone amplifier if the MR640 is
used.
4. Stereo source components such as tuners, CD
players, satellite dish receivers, cassette decks, and
other components.
Off
Without pressing any other buttons press the UP or
DOWN button to increase or decrease the
backlighting illumination. The level selected will
remain in the memory even if the power is
disconnected.
Turning on a source to this room with the MR64
keypad. After the system is completely installed, if
the system is not yet turned on, turn the sources on
and then turn the MVP controller amplifier on. If this
system has a MR640 controller and another
amplifier, make sure they are turned on and
powered up.
While the MR64 evolved after years of research, its
use is straightforward and direct. Some rooms may
have more than one pair of speakers but only one
keypad or possibly even no keypad.
The music system is controlled by the MR64 and
MR60 keypads, RB8 or universal remote, the source
components and possibly a whole home controller.
The source components are controlled by their
individual remote controls by aiming the remote
control at the keypad or infrared receiver and
pressing the appropriate remote control button.
After power has been turned on
the MR64 keypad will display its
software revision followed by
“Knoll Systems” and then:
System
Off
To turn a source on in this room press the INPUT
button. The volume is always set at about 30% when
the room speakers are first turned on. This room will
always revert to the source it was switched to when
it was turned off last time. To change to another
source, see changing sources below.
Please read about the MVP44a, MVP64a or MR640
with the manual shipped with that product.
MR64 Keypad Operation
The MR64 keypad is relatively easy to operate and
within a short period of time should be very intuitive.
Turn on a source in this room using the RB8
Remote Control. To turn on a source in this room
using the RB8 remote control press the RB8 remote
control 1, 2, 3 or 4 button corresponding to which
source you want to listen to. You do not need to
press the POWER button on the remote first.
Please ensure that keys are not pressed too fast as
the controller or keypad may be confused. If this
happens reset the system powering it off and then
on again.
Whole house source selection is not available from
the RB8 remote.
Download from Www.Somanuals.com. All Manuals Search And Download.
|