Klipsch Speaker WF 35E User Manual

Klipsch Icon Series  
Owner's Manual  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Bi-Wire Connections (See Figure 5.)  
Center Channel Speaker (See Figures 2A and 2B.)  
• The WF-35 and WF-34 are equipped with two pair of  
connection terminals for bi-wire hookup and enhanced  
performance.  
• Place immediately above or below the center of your video display.  
Surround Channel Speakers (See Figures 2A, 2B and 3.)  
• Remove the metal coupling straps.  
• Place above seated ear height on side or rear walls  
• Connect one speaker wire (+ and -)to the top pair of binding  
posts and a second speaker wire (+ and -) to the bottom pair  
of binding posts.  
(approximately 4-5 feet above the floor).  
• Use the attached wall brackets to hook to appropriately sized  
screw heads screwed into a wall stud and wall anchor or two  
wall anchors with a suitable weight bearing capacity. (See  
Figure 3.)  
Bass Management  
When using your speakers in a home theater system, consult  
the owner’s manual of your surround electronics for proper  
application of bass management settings.  
On Wall Placement  
• Klipsch Icon bookshelf models may be wall-mounted using  
the 1/4-20 threaded insert on the rear of the speaker. Be sure  
the mounting hardware you are using has the necessary load  
bearing capabilities before hanging any speaker. If you use  
a bracket, see the bracket owner’s manual for mounting details.  
• As a general rule, compact speakers (Bookshelf, Center  
Channel and Surrounds) are set to the “Small,” or bass-  
limited setting.  
• Floorstanding speakers are typically set to the “Large,” or  
full-range setting.  
• Also refer to the electronics instructions for adjusting the  
relative volume levels of the speakers so they are at the same  
level when listened to from the primary listening position.  
Never use the wall bracket for mounting the speaker to  
the ceiling.  
Care and Cleaning  
Connecting  
• Occasional dusting or wiping of the cabinet with a cloth  
is all that is required. Never use abrasive or solvent type  
cleaners or harsh detergents.  
• A vacuum cleaner with a soft brush attachment may be used  
to clean the grille fabric.  
Turn your amplifier off before making any  
connections.  
• Your loudspeakers are equipped with positive (Red) and negative  
(Black) connection terminals on the rear of the cabinet. These  
correspond to the positive and negative terminals on the  
• Never spray polishes or cleaners on the drive units (woofers,  
midranges or tweeters).  
appropriate channel (left, right, center, rear etc.) of your amplifier.  
Standard Connections (See Figure 4.)(All Models)  
• All speakers in your system must be connected in phase with  
the positive speaker terminal connected to the positive  
amplifier terminal. Repeat this for the negative speaker  
terminal and amplifier terminals. Most speaker wire has  
distinguishing markings on the insulation of one of the  
conductors to assist in correct hookup.  
• Use 16 gauge (AWG), two conductor, copper wire at a  
minimum and larger gauge wire for longer runs. The  
connection terminals on your loudspeaker will accommodate  
bare wire, spade terminals, and banana plugs.  
With all connection types, take care that there is no  
contact between the positive and negative terminals  
at the speaker and amplifier. Damage to your equipment  
may result.  
WF-35 and WF-34 Standard Connections  
• Use either pair of positive and negative terminals keeping the  
metal coupling straps in place.  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
EU Compliance Information  
Eligible to bear the CE mark, Conforms to European Union Low Volt-  
age Directive 73/23/EEC and 2006/95/EC; Conforms to European  
Union EMC Directives 89/336/EEC and 2004/108/EC.  
WEEE Notice  
Note: This mark applies only to countries within the European Union  
(EU) and Norway.  
This application is labeled in accordance with  
European Directive 2002/96/EC concerning waste  
electrical and electronic equipment (WEEE). This label  
indicates that this product should not be disposed of  
with household waste. It should be deposited at an  
appropriate facility to enable recovery and recycling.  
Product Registration Benefits  
• Klipsch will keep you up-to-date on new products and promotions  
• Your personal information will never be resold  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
Figure 1  
Speaker Bottom  
Figure 2A - Traditional Front Speaker Placement  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
Figure 2B - On-Wall Front Speaker Placement  
Figure 3  
Correct placement  
for wall bumpers  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
Figure 4  
AMP  
Left Speaker  
Right Speaker  
All Power Off!  
Figure 5  
AMP  
Left Speaker  
Right Speaker  
All Power Off!  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
Power.  
Detail.  
Emotion.  
For over 60 years, we’ve made speakers for people who are as passionate about  
great sound as we are. That’s why every Klipsch speaker is horn-loaded to create  
a remarkably accurate listening experience for your music and movies. From our  
smallest satellites to our acclaimed professional theater installations, our speakers  
deliver sound that’s so lifelike, you have to feel it to believe it.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Indesit Refrigerator TA5 TA5S User Manual
Insignia MP3 Docking Station 09 0663 User Manual
Jenn Air Dishwasher DW711 User Manual
John Lewis Clothes Dryer JLTDH14 User Manual
JVC Flat Panel Television GGT0220 001A H User Manual
Kambrook Fan KFH270 User Manual
Kenmore Clothes Dryer 110C8508 User Manual
Kobe Range Hoods Ventilation Hood IN2636SQB User Manual
Kodak Digital Camera 1385483 User Manual
Korg Microcassette Recorder CR 4 User Manual