Programming The Klipsch HD Theater SB 3 To Your TV Remote
The Klipsch HD Theater SB 3 soundbar has four control buttons under the status indicator lights on its front panel. From the
top button down, they are Source, MuTe, VoluMe up, and VoluMe Down. MuTe, VoluMe up and VoluMe Down can easily be
programmed to your TV, Satellite or cable box remote control so that you can use that remote to control these functions.
NOTE: The SB 3 model comes with its own remote and controls not only the four control buttons but has a separate button for
the 3D Surround Mode on/off feature. The four control buttons can be programmed into other remote controls using the built-in
learning remote feature, but the 3D Surround mode on/off button cannot be learned by any other remote and must be controlled
with the included remote.
STATUS LIGHTS
SOURcE
MUTE
VOLUME DOWN VOLUME UP
IMPORTANT NOTE: There is not a power on/off button on the front of the soundbar (there is a Main power switch on the soundbar’s rear
panel). You do not need to turn off the soundbar (or subwoofer) when finished watching TV. when finished, turn off your TV (or Satellite or
cable box if the soundbar is connected to that). The soundbar (and the subwoofer) will automatically go into a Standby or “sleep” mode
if they do not receive an audio signal from your TV, Satellite or cable Box for approximately 10 minutes. Standby mode is indicated by a
solid red status light on the soundbar front and on the subwoofer rear panel. when your TV, Satellite or cable box is turned back on and a
signal is again received, the soundbar (and subwoofer) will automatically come out of Standby mode and turn on.
Easy, Three-Step Remote Programming
The following 3 steps should be used to program each function of your TV or cable box
remote control buttons (MuTe, VoluMe up, and VoluMe Down). IF THE SOUNDBAR IS
IN STANDBY MODE (solid reD status light), push the <Source> button on the sound-
bar until the status light is solid Green.
1
Red and Green (alternating)
STEP ONE (Place the unit in learning mode): with the status light showing solid Green,
press and hold the <Source> and <MuTe> buttons on the front of the soundbar at the
same time (approximately 3 seconds) until the status light flashes reD and Green.
2
Solid Orange
STEP TWO (Select the function to learn): press the <MuTe> button once on the soundbar
(the status light changes to solid orAnGe). (Substitute the VOLUME UP, and VOLUME DOWN
in place of <MUTE> when programming the other buttons during this step)
3
x4
STEP THREE (Learn the function): Hold your remote control within one foot (30m) of the
soundbar. Slowly press the <MuTe> button on your remote control four times. on the
first three presses, the status indicator light will flicker orAnGe with each press. If the
unit has successfully learned the function, on the fourth press of the button, the light
will flash Green several times and then turn to solid Green. (Remember to use the
VOLUME UP, and VOLUME DOWN in place of <MUTE> when programming the other
buttons during this step)
1 Foot
To program the remaining functions, simply repeat all steps, substituting <MUTE>
with the new function and button presses (VOLUME UP, and VOLUME DOWN) on steps
TWO and THREE.
© 2012 Klipsch Group, Inc.
Download from Www.Somanuals.com. All Manuals Search And Download.
|