GPS NAVIGATION SYSTEM
DNX8220BT
MONITOR WITH DVD RECEIVER
DDX8022BT
INSTALLATION MANUAL
© B54-4650-00/00 (EW/E2W)
Download from Www.Somanuals.com. All Manuals Search And Download.
Installation Procedure
•
If your vehicle’s ignition does not have an ACC position, or
if the ignition wire is connected to a power source with
constant voltage such as a battery wire, the power will not
be linked with the ignition (i.e., it will not turn on and off
along with the ignition). If you want to link the unit’s power
with the ignition, connect the ignition wire to a power
source that can be turned on and off with the ignition key.
Use a commercially available conversion connector if the
connector does not fit in the vehicle connector.
Insulate unconnected wires with vinyl tape or other similar
material. To prevent a short circuit, do not remove the caps
on the ends of the unconnected wires or the terminals.
If the console has a lid, make sure to install the unit so that
the faceplate will not hit the lid when closing and opening.
If the fuse blows, first make sure the wires aren’t touching
to cause a short circuit, then replace the old fuse with one
with the same rating.
1. To prevent short circuits, remove the key from the
ignition and disconnect the - terminal of the
battery.
2. Make the proper input and output wire
connections for each unit.
3. Connect the wire on the wiring harness.
4. Take Connector B on the wiring harness and
connect it to the speaker connector in your vehicle.
5. Take Connector A on the wiring harness and
connect it to the external power connector on your
vehicle.
6. Connect the wiring harness connector to the unit.
7. Install the unit in your car.
8. Reconnect the - terminal of the battery.
9. Press the reset button.
•
•
•
•
•
Connect the speaker wires correctly to the terminals to
which they correspond. The unit may be damaged or fail to
work if you share the - wires or ground them to any metal
part in the car.
2WARNING
•
If you connect the ignition wire (red) and the battery wire
(yellow) to the car chassis (ground), you may cause a short
circuit, that in turn may start a fire. Always connect those
wires to the power source running through the fuse box.
•
After the unit is installed, check whether the brake lamps,
blinkers, wipers, etc. on the car are working properly.
Mount the unit so that the mounting angle is 30° or less.
This unit has the cooling fan (page 5) to decrease the
internal temperature. Do not mount the unit in a place
where the cooling fan of the unit are blocked. Blocking
these openings will inhibit the cooling of the internal
temperature and result in malfunction.
•
•
Acquiring GPS Signals
The first time you turn on the DNX8220BT, you must
wait while the system acquires satellite signals for
the first time. This process could take up to several
minutes. Make sure your vehicle is outdoors in an
open area away from tall buildings and trees for
fastest acquisition. After the system acquires satellites
for the first time, it will acquire satellites quickly each
time thereafter.
•
•
Do not press hard on the panel surface when installing the
unit to the vehicle. Otherwise scars, damage, or failure may
result.
Reception may drop if there are metal objects near the
Bluetooth antenna.
¤
•
Mounting and wiring this product requires skills and
experience. For safety’s sake, leave the mounting and wiring
work to professionals.
•
•
Make sure to ground the unit to a negative 12V DC power
supply.
Do not install the unit in a spot exposed to direct sunlight
or excessive heat or humidity. Also avoid places with too
much dust or the possibility of water splashing.
Do not use your own screws. Use only the screws provided.
If you use the wrong screws, you could damage the unit.
If the power is not turned ON (“PROTECT” is displayed),
the speaker wire may have a short-circuit or touched the
chassis of the vehicle and the protection function may
have been activated. Therefore, the speaker wire should be
checked.
Bluetooth antenna unit
•
•
•
Make sure that all wire connections are securely made by
inserting jacks until they lock completely.
|
English
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Connection
Connector A
Ground wire (Black)
Battery wire (Yellow)
Ignition wire (Red)
8
7
6
5
4
3
2
1
FM/AM antenna
input (JASO)
8
7
6
5
4
3
2
1
Antenna Cord
Connector B
(Orange/White)
Dimmer control wire (Orange/White)
ILLUMI
Connect to the vehicle's parking brake
detection switch harness.
Parking sensor wire (Light Green)
PRK SW
For the sake of safety, be sure to connect the parking sensor.
Reveres sensor wire (Purple/White)
Connect to vehicle's reverse lamp harness when
using the optional rear view camera.
Steering remote control input
(Light Blue/Yellow)
To steering remote
To use the steering wheel remote control feature, you need to an
exclusive remote adapter (not supplied) matches your car is required.
When this terminal is not in use, leave its cap on.
Mute wire (Brown)
Connect to the terminal that is grounded when either
the telephone rings or during conversation.
To connect the Kenwood navigation system,
consult your navigation manual.
Power control/ Motor antenna control wire
(Blue/White)
Connect either to the power control terminal when using the optional
power amplifier, or to the antenna control terminal in the vehicle.
External amplifier control wire (Pink/Black)
To "EXT.AMP.CONT." terminal of the amplifier
having the external amp control function.
If no connections are made, do not let the cable come out from the tab.
|
4
DNX8220BT/DDX8022BT
Download from Www.Somanuals.com. All Manuals Search And Download.
Bluetooth Microphone
(Accessory 9) (see page 10)
Cooling fan
GPS Antenna (Accessory 7)
(DNX8220BT only) (see page 10)
FUSE ( 15A )
Accessory 1
REVERSE
REMO.CONT
MUTE
ANT. CONT
EXT.CONT
P CONT
|
English
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Connecting Wires to Terminals
Connector Function Guide
Pin Numbers for Cable Colour
ISO Connectors
External Power
Connector
2WARNING
Functions
Connecting the ISO Connector
The pin arrangement for the ISO connectors depends on
the type of vehicle you drive. Make sure to make the proper
connections to prevent damage to the unit.
A-4
A-5
A-6
A-7
A-8
Yellow
Battery
Power Control
Dimmer
Ignition (ACC)
Earth (Ground)
Connection
The default connection for the wiring harness is described in
1 below. If the ISO connector pins are set as described in 2,
make the connection as illustrated.
Please be sure to reconnect the cable as shown 2 below to
install this unit to the Volkswagen vehicles etc.
Blue/White
Orange/White
Red
Black
Speaker
Connector
B-1
B-2
B-3
B-4
B-5
B-6
B-7
1(Default setting) The A-7 pin (red) of the vehicle’s
ISO connector is linked with the ignition, and the A-
4 pin (yellow) is connected to the constant power
supply.
Purple
Purple/Black
Gray
Gray/Black
White
White/Black
Green
Rear Right (+)
Rear Right (–)
Front Right (+)
Front Right (–)
Front Left (+)
Front Left (–)
Rear Left (+)
Rear Left (–)
Ignition cable (Red)
Unit
Battery cable (Yellow)
A-7 Pin (Red)
Vehicle
A-4 Pin (Yellow)
B-8
Green/Black
2The A-7 pin (red) of the vehicle’s ISO connector is
connected to the constant power supply, and the
A-4 pin (yellow) is linked to the ignition.
Ignition cable
A-7 Pin (Red)
(Red)
Unit
Vehicle
A-4 Pin (Yellow)
Battery cable
(Yellow)
|
6
DNX8220BT/DDX8022BT
Download from Www.Somanuals.com. All Manuals Search And Download.
System Connection
USB terminal (iPod)
USB terminal
USB device
(commercially available)
USB device
(commercially available)
iPod
■
■
Visual input (iPod)
Resistance-free mini plug (3.5φ)
Audio input (iPod)
Resistance-free stereo type mini plug (3.5φ)
Accessory
2
Accessory
3
Accessory 4
■
■
■
Audio/Visual Output
• Visual output (Yellow)
• Audio left output (White)
• Audio right output (Red)
Audio/Visual input1
• Visual input (Yellow)
• Audio left input (White)
• Audio right input (Red)
Audio/Visual input2
• Visual input (Yellow)
• Audio left input (White)
• Audio right input (Red)
■
■
Rear View Camera Input
• Visual input (Yellow)
Front Preout
• Audio left output (White)
• Audio right output (Red)
Rear Preout
• Audio left output (White)
• Audio right output (Red)
■
■
Subwoofer Preout
• Audio left output (White)
• Audio right output (Red)
■
Center Preout
• Audio output (Black)
To Relay Box
|
English
7
Download from Www.Somanuals.com. All Manuals Search And Download.
Optional Accessory Connection
iPod
(commercially available)
KCA-iP300V
(Optional Accessory)
Audio Output (Black)
Visual Output (Yellow)
Navigation System Input
(DDX8022BT only)
USB terminal
USB terminal (iPod)
USB terminal
iPod cannot be connected.
TV Tuner
(Optional Accessory)
Navigation System
(Optional Accessory)
T V A N T E N N A I N P U T
R O U N I T
M O O T N I T
Connection cable
(Included in the TV tuner)
Connection cable
(Included in the Navigation System)
|
8
DNX8220BT/DDX8022BT
Download from Www.Somanuals.com. All Manuals Search And Download.
Installation for Monitor/Player Unit
Firewall or metal support
Screw (M4X8)
(commercially available)
Bend the tabs of the mounting
sleeve with a screwdriver or similar
utensil and attach it in place.
Self-tapping screw
(commercially available)
Metal mounting strap
(commercially available)
Make sure that the unit is installed securely in place. If the unit is unstable,
it may malfunction (eg, the sound may skip).
Installing the Escutcheon
1. Attach accessory 6 to the unit.
Accessory 6
|
English
9
Download from Www.Somanuals.com. All Manuals Search And Download.
Installing the GPS Antenna
(DNX8220BT only)
Installing the Microphone Unit
GPS antenna is installed inside of the car. It should
be installed as horizontally as possible to allow easy
reception of the GPS satellite signals.
1. Check the installation position of the microphone
(accessory 9).
2. Remove oil and other dirt from the installation
surface.
To mount the GPS antenna inside your vehicle:
1. Clean your dashboard or other surface.
3. Install the microphone.
2. Peel the backing off of the adhesive on the bottom
4. Wire the microphone cable up to the hands-free
box with it secured at several positions using tape
or the like.
of the metal plate (accessory 8).
3. Press the metal plate (accessory 8) down firmly on
your dashboard or other mounting surface. You can
bend the metal plate (accessory 8) to conform to
a curved surface, if necessary.
4. Place the GPS antenna (accessory 7) on top of the
metal plate (accessory 8).
Accessory 9
Accessory 7
Accessory 8
Fix a cable with a commercial
item of tape.
¤
•
Depending on the type of car, reception of the GPS satellite
signals might not be possible with an inside installation.
The GPS antenna should be installed at a position that is
spaced at least 12 inch (30 cm) from cellular phone or other
transmitting antennas. Signals from the GPS satellite may be
interfered with by these types of communication.
Painting the GPS antenna with (metallic) paint may cause a
drop in performance.
Peel the release coated paper of double-face adhesive tape
to fix on the place shown above.
•
•
Adjust the direction of the microphone to the driver.
Install the microphone as far as possible
from the cell-phone.
|
10
DNX8220BT/DDX8022BT
Download from Www.Somanuals.com. All Manuals Search And Download.
Removing Monitor/Player Unit
Removing the Hard Rubber Frame
(escutcheon)
1. Engage the catch pins on the removal tool 5 and
remove the two locks on the lower level.
Lower the frame and pull it forward as shown in
the figure.
Removing the Unit
1. Remove the hard rubber frame by referring to the
removal procedure in the section <Removing the
Hard Rubber Frame>.
2. Remove the Hex-head screw with integral washer
(M4 × 8) on the back panel.
3. Insert the two removal tools 5 deeply into the
slots on each side, as shown.
Accessory 5
Accessory 5
Catch
Lock
⁄
•
The frame can be removed from the top side in the same
manner.
4. Lower the removal tool toward the bottom, and
pull out the unit halfway while pressing towards
the inside.
2. When the lower level is removed, remove the
upper two locations.
⁄
•
Be careful to avoid injury from the catch pins on the
removal tool.
5. Pull the unit all the way out with your hands, being
careful not to drop it.
|
English
11
Download from Www.Somanuals.com. All Manuals Search And Download.
Download from Www.Somanuals.com. All Manuals Search And Download.
|