I N S T A L L A T I O N I N S T R U C T I O N S
Part No. 055523
1-800-KEATING
INSTALLATION FOR CUTTING BOARD
WITH BRACKETS ON KEATING GRIDDLES
What’s needed to
complete this installation?
• Drill Gun
• #19 Drill Bit
• Phillips Screw Driver
Perimeter Front
FLUSH
What’s included in your package?
A
B
C
D
E
PRE-ASSEMBLED MOUNTING BRACKET FOR SECURING CUTTING BOARD TO SIDE BRACKET (2x)
END SUPPORT BRACKET (2x)
RICHLITE CUTTING BOARD (1x)
#10 SCREWS FOR ATTACHING BRACKET TO CABINET (6x)
CUTTING BOARD CENTER SUPPORT FOR 48" AND LARGER GRIDDLES (1x)
1) HOLD END SUPPORT BRACKETS IN PLACE AND MARK 3 HOLES ON EACH SIDE
OF CABINET. TOP EDGE OF BRACKET IS TO BE FLUSH WITH UPPER EDGE OF
CABINET SIDE. 90° FORM ON THE BRACKET WILL EXTEND OUT FROM THE
PERIMETER FRONT.
2) DRILL THREE HOLES ON EACH CABINET SIDE WITH THE #19 DRILL BIT.
3) ATTACH END SUPPORT BRACKETS WITH #10 SHEET METAL SCREWS PROVIDED.
4) SLIDE CUTTING BOARD IN PLACE. EXISTING BRACKETS ON CUTTING BOARD
SHOULD MATE WITH FORMED EDGES ON END SUPPORT BRACKETS.
5) CUTTING BOARDS 48" AND LONGER ALSO HAVE A CENTER SUPPORT WHICH
ATTACHES ON THE BOTTOM SIDE OF THE PERIMETER FRONT (UNDER THE
"CAUTION HOT" WARNING LABEL) WITH EXISTING 1/4–20 SCREWS.
CutbrdInstll
6/05
Download from Www.Somanuals.com. All Manuals Search And Download.
|