Assembly Instructions
Description:
iPod® Adapter Cable
MP3/Audio Adapter Cable
Model:
Vulcan 1700 Voyager
15 min.
Part Number: K10400-040
K10400-041
Approximate
Assembly Time:
Before you begin installation, read through the installation instructions and check to be sure all parts are
present.
If you are in doubt as to any part of the installation, please ask your authorized Kawasaki dealer to
complete the installation. Please note that Kawasaki cannot assume any responsibility for damage
resulting from incorrect installation.
Parts List
Seq.
1.
Description
iPod® Adapter Cable (K10400-040 only)
Cushion
Qty
1
2.
1
3.
MP3/Audio Adapter Cable (K10400-041 only)
1
Installation Instructions
Installation
Install cable
z Open left fairing pocket and locate the vehicle harness with
dual plug connectors. One plug is triangular 3-pin and the
other is square 4-pin.
z Connect your adapter cable to the mating vehicle harness
connectors. You will use both connectors for an iPod adapter
cable and the 3-pin connector only for the MP3/media adapter
cable.
Attach cable
Connect your media player to the adapter cable as follows:
z The iPod connects to the large flat receptor (Apple® refers to
this as a 30-pin dock connector) at the bottom of the device.
z Insert the iPod charging module into the space provided in the
cushion.
Download from Www.Somanuals.com. All Manuals Search And Download.
Voyager Radio Accessory Instructions
Description:
Intercom
Model:
Vulcan 1700 Voyager (all)
iPod®/Aux Connectors
XM Radio
K10400-027/028/032/035/036
K10400-040/041
Part-Number:
K10400-038
These instructions supplement the above accessory installation instructions and Vulcan 1700
Voyager Owner’s Manual Audio System section.
Important Notice
Some states prohibit the wearing of “headphones” or “headsets” while operating a motor vehicle.
Mounting audio speakers in motorcycle helmets does not convert them to “headphones” or
“headsets”, some states may prohibit the use of this helmet sound system under other statutes.
Kawasaki advises you to determine the legality of this helmet sound system prior to using it in any
state.
OPERATING PRECAUTIONS
There are a number of important precautions that must be heeded when operating the audio system.
Learn and observe all of the following rules below.
Keep both hands on the handlebar at all times while riding. Don’t remove your hands from
the handlebar to adjust audio system controls. Make these adjustments before riding.
Do not operate the audio system at volumes so loud that they interfere with your ability to
hear sirens, horns, or other warning signals.
Do not operate the audio system at volumes so loud that they disturb other people.
With the exception of genuine Kawasaki Parts and Accessories, Kawasaki has no control
over the design or application of accessories. Kawasaki Parts and Accessories have been
specially designed for use on Kawasaki motorcycles. We strongly recommend that all parts
and accessories you add to your motorcycle be genuine Kawasaki components.
Download from Www.Somanuals.com. All Manuals Search And Download.
]iPod® Adaptor (Accessory K104400-040)
The optional iPod harness allows an iPod to be controlled through the Vulcan 1700 Voyager audio
system. The display will show song and artist information from your iPod and allow you to select
songs and play lists. The iPod battery is charged whenever the audio system has power.
Note
○Only one media player can be connected to the sound system. This means that you will be able to
use either an iPod or a portable media device, but not both at the same time.
○Kawasaki is not responsible for any damage to iPod or other media player due to storage in the
saddlebag, trunk or other location on the vehicle.
Only Apple iPods with the 30-pin dock connector will allow radio interface using the K10400-040
iPod Adaptor Cable
All other media players including the iPod Shuffle will require the K10400-041 Auxiliary Adaptor
Cable.
This functionality is described in the auxiliary input section.
Press the MODE button to cycle through audio sources. The display will show AUX until
communication is established with the iPod. To confirm the communication link, the dashboard
display will show the iPod name.
iPod Tuning
Press the TUNE +/- buttons to change songs on the iPod. Press and hold the TUNE +/- buttons to
access the song selection screen. Use the TUNE +/- buttons to select a song and then press the P
button to start playing that song.
iPod Browsing
Press and hold the P button to browse through song selections on your iPod. After you press P, use
the TUNE +/- buttons to select browsing by Album, Artist, or Playlist. To select one of these
categories, press P again. After you have selected a category, use the TUNE +/- buttons to scroll
through the category. To select a title, press P again.
Download from Www.Somanuals.com. All Manuals Search And Download.
|