Operational Check
After installing your keypad, check the operation by entering the door number and
pressing Open, Close or Stop. Operation should be reliable. However, environmental
conditions and the location of the keypad and or receiver will affect distance.
• If the keypad doesn’t activate the operator check the door number. The door
by
MVP Commercial
number entered must exactly match the door number by the receiver.
• Press the STOP/ON button and wait a seconds before entering your door
number. Press the keys slowly.
Keypad Transmitter
• If the distance is inadequate check the battery and replace if necessary.
Installation Instructions
• To maximize the operating distance move the keypad to different locations
until a satisfactory distance is achieved. Metal and some types of construction
will affect distance.
Model CKT-240
Proper installation of your radio controls will assure years of
trouble-free operation
READ THE FOLLOWING INSTRUCTIONS THOROUGHLY
BEFORE STARTING INSTALLATION
• If system does not work at any distance, check that the operator is properly
operating from the wall station and any other hand-held transmitters.
• Try to erase the receiver and re-lean the door number and any additional hand-
held transmitters.
The MVP Commercial Keypad Transmitter is designed to remotely operate MVP
Quik-Code Receivers. When used with a 3-channel receiver, the keypad permits
the user to operate up to 240 different door operators with open, close and stop
functions. The radio frequency of the remote controls is fixed and tuned at the
factory; adjustments are not required and should not be attempted by the end user.
WARNING
WARNING
Manufacturer’s Limited Warranty
Features of the Commercial Keypad Transmitter
Allstar warrants its radio controls to be free from defect in material and workmanship for a period of one (1) year from the
date of purchase. To obtain service, contact your dealer.
ON/STOP: This key turns on the keypad and light system allowing you to
operated the system as well as to see the keys in the dark. The keypad will remain
active and lights will remain lit for 45 seconds after the last key is pressed.
To obtain service under this warranty the buyer must obtain authorization instructions from Allstar for the return of any
goods before returning the goods. The goods must be returned with complete identification, with copy of proof-of-purchase,
freight prepaid and in accordance with Allstar’s instructions or they will not be accepted. In no event will Allstar be
responsible for goods returned without proper authorization or identification.
3-Button Operation Mode: Once you have entered a valid 3-digit door number,
the door is activated by pressing either Open, Close, or Stop button. Until another
door number is entered or the keypad times-out (keypad lights turn off), the
same door may be reactivated by pressing either Open, Close or Stop.
Goods returned to Allstar for warranty repair within the warranty period, which upon receipt by Allstar are confirmed to be
defective and covered by this limited warranty, will be repaired or replaced at Allstar’s sole option, at no cost and returned
pre-paid. Defective parts will be repaired or replaced with new or factory rebuilt parts at Allstar’s sole option.
This limited warranty does not cover non-defect damage, damage caused by unreasonable use, damage caused by improper
installation or care, vandalism or lightning, fire or excessive heat, flood or other acts of God (including, but not limited to
misuse, abuse or alterations, failure to provide reasonable and necessary maintenance), labor charges for dismantling or
reinstalling a repaired or replaced unit, or replacement batteries.
Low Battery Indicator: The lighting for your keypad also serves as a low
battery indicator. When the keypad lights flash on and off the battery should be
replaced with a alkaline 9 volt battery.
These warranties are in lieu of all other warranties, either expressed or implied. All implied warranties of merchantability
and/or fitness for a particular purpose are hereby disclaimed and excluded. Under no circumstances shall Allstar be liable for
consequential, incidental or special damages arising in connection with the use or inability to use this product. In no event
shall Allstar’s liability for breach of warranty, breach of contract, negligence or strict liability exceed the cost of the product
covered hereby. No person is authorized to assume for Allstar any other liability in connection with the sale of this product.
Non-Volatile Memory: It is not necessary to reprogram the keypad after you
replace your battery.
This warranty gives you specific legal rights. Warranty effective after August 1, 2004.
Allstar MVP Quik-CodeTransmitters and Receivers are
compatible with HomeLink®.
HomeLink® is a registered trade mark of Johnson Controls.
Copyright © 2004 c.p.Allstar Corporation PART NUMBER 112261 REV B
Download from Www.Somanuals.com. All Manuals Search And Download.
|