JVC Speaker SP DWF31 User Manual

COMPACT COMPONENT SYSTEM  
POWERED SUBWOOFER  
SP-DWF31  
INSTRUCTIONS  
LVT1305-001A  
[B]  
Download from Www.Somanuals.com. All Manuals Search And Download.  
ENGLISH  
Thank you for purchasing a JVC speaker.  
Before you begin using it, please read the instructions carefully to be sure you get the best possible performance. If you have any  
questions, consult your JVC dealer.  
Precautions for installation  
Warnings, Cautions and Others  
To reduce the risk of electrical shocks, fire, etc.:  
1. Do not remove screws, covers or cabinet.  
2. Do not expose this appliance to rain or moisture.  
To prevent deformation or discoloration of the cabinet, do not  
install the unit where it is exposed to direct sunlight or high  
humidity, and avoid installation near air conditioning outlets.  
Speaker vibrations may cause howling. Place the unit as far  
away from the player as possible.  
Take the occurrence of earthquakes or other physical shocks  
into consideration when selecting the installation place, and  
secure the unit thoroughly.  
CautionPOWER switch  
This apparatus is provided with the POWER switch to minimize  
power consumption for safe use. Therefore,  
Tuner reception may become noisy or hissing if this unit is  
installed nearby the tuner. In this case, leave a more distance  
between the tuner and this unit or use an outdoor antenna for  
better tuner reception without interference from this unit.  
1. Before doing initial settings, complete all the connections  
required, connect the mains plug into the wall outlet, then set  
the POWER switch to ON position.  
2. When not in use, set the POWER switch to OFF position.  
This disconnects the mains line.  
The speakers are magnetically shielded to avoid color  
distortions on TVs. However, if not installed properly, they may  
cause color distortions. So, pay attention to the following when  
installing the speakers.  
When placing the speakers near a TV set, turn off the TVs  
main power switch or unplug it before installing the speakers.  
Then wait at least 30 minutes before turning on the TVs  
main power switch again.  
Cautions  
Do not block the ventilation openings or holes.  
(If the ventilation openings or holes are blocked by a  
newspaper or cloth, etc., the heat may not be able to get out.)  
Do not place any naked flame sources, such as lighted candles,  
on the apparatus.  
Some TVs may still be affected even though you have followed  
the above. If this happens, move the speakers away from the  
TV.  
When discarding batteries, environmental problems must be  
considered and local rules or laws governing the disposal of  
these batteries must be followed strictly.  
When the TV screen shakes, move this unit away from the TV to  
find a position where the screen doesn't shake and then set the  
unit there.  
Do not expose this apparatus to rain, moisture, dripping or  
splashing and that no objects filled with liquids, such as vases,  
shall be placed on the apparatus.  
Precautions for Daily Use  
• To maintain the appearance of the unit  
Wipe with a dry, soft cloth if the cabinet or control panel should  
become dirty.  
If very dirty, apply a small amount of water or neutral detergent  
to the cloth and wipe clean. Then wipe with a dry cloth.  
• To improve the sound field  
If the speakers are facing a solid wall or glass door, etc., it is  
recommended to furnish the wall with materials that absorb  
sounds, for example by hanging up thick curtains, to prevent  
reflections and standing waves.  
CautionProper Ventilation  
To avoid risk of electric shock and fire, and to prevent damage,  
locate the apparatus as follows:  
1 Front:  
No obstructions and open spacing.  
2 Sides/ Top/ Back:  
No obstructions should be placed in the areas shown by the  
dimensions below.  
3 Bottom:  
Checking the Supplied Accessories  
Check to be sure you have the following supplied accessories.  
The number in parenthesis indicates the quantity of the piece  
supplied.  
Place on the level surface. Maintain an adequate air path for  
ventilation by placing on a stand with a height of 10 cm or  
more.  
Monaural audio cord (1)  
If the item mentioned above is missing, contact your dealer  
immediately.  
Front  
Front view  
Side view  
20 cm  
20 cm  
20 cm  
15 cm  
15 cm  
Contents  
Warnings, Cautions and Others................................... 3  
Connections .................................................................. 4  
Operations ..................................................................... 4  
Additional Information .................................................. 5  
10 cm  
3 –  
Download from Www.Somanuals.com. All Manuals Search And Download.  
ENGLISH  
Connections  
Before connecting this unit to the amplifier (or receiver), observe  
the following carefully.  
• Turn off the amplifier.  
• Make all connections before plugging in this unit.  
• DO NOT connect this unit to the REC OUT jacks of your  
amplifier. It may damage your subwoofer.  
Monaural audio cord (Supplied)  
Amplifier or Receiver  
To SUBWOOFER OUT  
or MONO  
To LINE OUT  
To an AC outlet  
Stereo audio cord (not Supplied)  
In the case that the receiver dose not have the SUBWOOFER OUT or MONO terminal.  
Operations  
Turning On the Power—POWER  
To turn on the power.  
Press the POWER switch to the ON position.  
• The power lamp lights in green.  
Front  
SP-DWF10  
To cut of the power.  
Press the POWER switch to the OFF position.  
• The power lamp goes out.  
• This will disconnect the mains lead.  
SP-DWF10  
Power lamp  
Operating the Unit Automatically According to the Incoming  
Signals—AUTO POWER ON/STANDBY  
To activate AUTO POWER ON/STANDBY.  
Rear  
Press the AUTO POWER ON/STANDBY switch to the [ ] ON  
position.  
• If no sound comes in for 5-10 minutes, the unit enters  
standby mode. The power lamp lights in red.  
• If the unit detects incoming signals, the unit starts  
operating. The power lamp lights in green.  
To cancel AUTO POWER ON/STANDBY.  
Press out the AUTO POWER ON/STANDBY switch to set it to the  
[
] CANCEL position.  
AUTO POWER ON / STANDBY  
CANCEL  
ON  
When the volume level of the amplifier is so low or the  
incoming signals are so weak that this unit cannot detect  
sounds, Auto Power On/Standby may not work correctly.  
– 4 –  
Download from Www.Somanuals.com. All Manuals Search And Download.  
ENGLISH  
Additional Information  
Speaker layout  
Center speaker  
To obtain the best possible sound from your unit:  
Front left  
speaker  
Front right  
speaker  
Place a subwoofer wherever you like since bass sound is non-  
directional. Normally place it in front of you.  
Place all the main speakers at the same distance from the  
listening position.  
Powered  
subwoofer  
Be sure to place the powered subwoofer to the TV's right. If you  
place the powered subwoofer to the TV's left, keep sufficient  
distance between them to prevent the TV from appearing  
mottled.  
Surround left  
speaker  
Surround right  
speaker  
Troubleshooting  
Use this chart to help you solve daily operational problems. If there is any problem you cannot solve, contact your dealer.  
Power does not come on.  
Is the unit pugged in?  
Plug the AC power cord firmly into the AC outlet.  
Auto Power On/Standby does not function correctly.  
Signals are too weak or volume level is too low.  
This is not a malfunction. If this happens, cancel Auto Power On/Standby.  
No sound is heard.  
Connections are incorrect, or loose.  
Check the connections. If incorrect, redo the connections. (See pages 4.)  
Audio signals through the amplifier are extremely weak.  
Increase the volume level on the amplifier.  
Sounds fluctuate (suddenly become loud or soft).  
The built-in protective circuit is working.  
Lower the volume level, then turn off and on the unit.  
Suddenly no sound comes out. – the power lamp still lights in green.  
The volume of the playback source is too high.  
Turn down the volume of the playback source, turn off and on the source, then adjust the volume properly on the source.  
Specifications  
Type : Powered Subwoofer  
Bass-reflex type  
(magnetically shielded type)  
Speaker : 16.0 cm cone × 1  
Frequency Range : 32 Hz  
Impedance : 4 Ω  
200 Hz  
Input terminals : INPUT (LOW-LEVEL)  
Power requirements : AC 230 V , 50 Hz  
Output power of built-in amp : 100 W (50 Hz, 4 , 10 % THD)  
Power Handling Capacity : 27 W  
Dimensions  
(W × H × D) : 184 mm × 374 mm × 354 mm  
Mass : 8.2 kg  
Accessories : Monaural audio cord (× 1)  
5 –  
Download from Www.Somanuals.com. All Manuals Search And Download.  
EN  
1204NSMCREJSC  
© 2005 Victor Company of Japan, Limited  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Indesit Clothes Dryer IDCA 735 User Manual
Insignia Computer Hardware NS PCCUP53 User Manual
Jackson Dishwasher TempStar HH User Manual
JBL Speaker SUB10 User Manual
JVC Camcorder Accessories 0898AYVUNAP User Manual
JVC Camcorder GR AX657UM User Manual
JVC Stereo Receiver RX D701S User Manual
Kenmore Clothes Dryer 69902 User Manual
Keys Fitness Elliptical Trainer 920D User Manual
Kompernass Scale KH 1156 User Manual