JL Audio Car Speaker SB GM SLVCNSL 10W3 D6 User Manual

S B -G M -S LV C N S L /1 0 W 3  
S t e a lt h b o x ™  
F it s 2 0 0 0 E x t e n d e d -C a b F u ll-S iz e G M P ic k u p Tr u c k s  
a n d S u b u r b a n , Ta h o e , Y u k o n , Y u k o n X L S U V 's  
Installation Guide:  
This Stealthbox is a product which requires professional installation skills and tools. Please read this installa-  
tion guide thoroughly before beginning the project. It will guide you step by step through the installation.  
Several of the steps in this process may require two people to accomplish.  
It is absolutely vital that the enclosure be properly mounted to the vehicle according to these instructions.  
Failure to mount the enclosure properly presents two problems: 1 ) The sub-bass performance will suffer due  
to the movement of the enclosure caused by the force exerted by the woofer and 2 ) A loose enclosure  
presents a serious safety hazard in the event of a collision or sudden deceleration.  
STEP 1 : Remove the front seats by removing the nuts and bolts  
at the front and rear. A socket can be used if the proper Torx bit  
is not available (1 1 mm in rear and 1 5 mm in front).  
STEP 2 : Remove the cup holder tray in order to access the  
mounting screws.  
STEP 3 : Remove the mounting screws at the forward edge of the  
console body.  
S B -G M -S LV C N S L /1 0 W 3 -D 6 , J L A U D IO , In c 2 0 0 0  
P a g e  
1
S h e e t S K U # 0 1 1 1 4 2 R e v is io n 8 /1 5 /0 0  
Download from Www.Somanuals.com. All Manuals Search And Download.  
STEP 1 0 : Remove the internal storage tray.  
STEP 1 1 : Pull the console body toward the rear in order to  
release it from the duct work. Remove the console body from the  
vehicle.  
STEP 1 2 : Remove and discard the duct.  
STEP 1 3 : Modify the internal storage tray by cutting around its  
perimeter approximately 1 1 / 2 " below the upper lip.  
S B -G M -S LV C N S L /1 0 W 3 -D 6 , J L A U D IO , In c 2 0 0 0  
P a g e  
3
S h e e t S K U # 0 1 1 1 4 2 R e v is io n 8 /1 5 /0 0  
Download from Www.Somanuals.com. All Manuals Search And Download.  
STEP 1 4 : Apply the supplied templates to the proper sides of the  
console body (as indicated on the template). The templates show  
where to cut the console body as well as where to drill two holes  
through the console body. Drill and cut where indicated.  
STEP 1 5 : Drill a 3 / 8 " hole through the stock mounting bracket  
at each of the four locations indicated in Diagram # 1 .  
1"  
1"  
1
9/16"  
1
9/16"  
X
X
X
X
2
1/2"  
2
1/2"  
Diagram #1  
STEP 1 6 : Run speaker wire to the console area.  
STEP 1 7 : Bolt the bracket to the bottom of the Stealthbox  
(Ensure proper operation of the Stealthbox prior to mounting it to  
the bracket).  
S B -G M -S LV C N S L /1 0 W 3 -D 6 , J L A U D IO , In c 2 0 0 0  
P a g e  
4
S h e e t S K U # 0 1 1 1 4 2 R e v is io n 8 /1 5 /0 0  
Download from Www.Somanuals.com. All Manuals Search And Download.  
STEP 1 8 : Clip the section of the original storage tray rim in the  
area shown in the picture and in Diagram # 2 . This will allow the  
clasp to grasp the new pocket insert only (not both the console  
body and the new insert).  
Cut Here  
Before  
After  
Diagram #2  
STEP 1 9 : Install the original tray (modified in steps 1 3 and 1 8 )  
with the new provided insert.  
STEP 2 0 : Connect the speaker wire to the Stealthbox. Mount  
the bracket/ Stealthbox into the vehicle.  
S B -G M -S LV C N S L /1 0 W 3 -D 6 , J L A U D IO , In c 2 0 0 0  
P a g e  
5
S h e e t S K U # 0 1 1 1 4 2 R e v is io n 8 /1 5 /0 0  
Download from Www.Somanuals.com. All Manuals Search And Download.  
STEP 2 1 : Place the console body over the Stealthbox.  
STEP 2 2 : Secure the body with the OEM screws into the dash  
extension.  
STEP 2 3 : Drill 7 / 6 4 " holes into the Stealthbox at the four  
locations of the holes drilled into the console body.  
STEP 2 4 : Secure the console body to the Stealthbox through  
these holes with the supplied screws.  
This com plet es t he ins t a lla t ion.  
Specifications :  
Supplied Hardware:  
Enclos ur e Type: Acoustic Suspension (Sealed)  
Driver Type: J L AUDIO 1 0 W 3 -D6 Subwoofer  
Cont. Power Handling: 2 5 0 Watts  
Nominal Impedance: 3  
(4) 1/4" X 2" Bolts  
(4) 1/4" Washers  
(4) #8 Flat Head Screws  
(4) 1/4" Lock Washers  
(1) Console Insert  
1 0 3 6 9 N. Commerce Pkwy, Miramar, Florida 3 3 0 2 5 -3 9 2 1 Voice: (9 5 4 ) 4 4 3 -1 1 0 0 Fax: (9 5 4 ) 4 4 3 -1 1 1 1  
S B -G M -S LV C N S L /1 0 W 3 -D 6 , J L A U D IO , In c 2 0 0 0  
P a g e  
6
S h e e t S K U # 0 1 1 1 4 2 R e v is io n 8 /1 5 /0 0  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Indesit Washer IWC 6125 User Manual
Ingersoll Rand Patio Umbrella SLB1200 User Manual
Johnson Controls Furnace CM8M CMLMMP User Manual
JVC Automobile Alarm SP X60 User Manual
JVC CD Player KD G617 User Manual
JVC DVD Recorder 0307MNH SW BJ User Manual
JVC Stereo System 0310YAMMDWDAT User Manual
Kenwood Car Speaker KFC 4675C User Manual
KitchenAid Gas Heater 710 0003 User Manual
Klipsch Headphones X10I User Manual