THANK YOU FOR CHOOS ING J BL
For more than 50 years, JBL
has been involved in every
aspect of music and film
recording and reproduction,
from live performances to
the recordings you play in
your home, car or office.
note of enjoyment that you
expected – and that when
you think about purchasing
additional audio equipment
for your home, car or
keep you posted on our
latest advancements, and
helps us to better under-
stand our customers
and build products that
meet their needs and
expectations.
office, you will once again
choose JBL.
We’re confident that the JBL Please take a moment to
JBL Consumer Products
loudspeakers you have
complete the enclosed
chosen will provide every
profile card. It enables us to
X +
0 +
Y 2
0
M HZ
X + 0 + Y2 0MHZ”
X + 0 + Y2
OWNER’S GUIDE
P RODUCT LINE:
HT S ERIES
MODEL
NUMBER:
HTPS-400
DES IGN GOAL: Bring the thrill of live performance and movie sound to
the home environment by calling on JBL’s professional engineering leadership.
WOOFER TYP E: Aluminum cone with rubber surrounds
®
CROS S OVER NETWORK: THX -Ultra Certified
ENCLOS URE DES IGN: Sealed
TWO UNITS MINIMUM
P ROFES S IONAL REFERENCE: Cinema Loudspeaker Series
Download from Www.Somanuals.com. All Manuals Search And Download.
UNPACKING
Feet
feet, attach them to the four
In cases where a grille is
Your HTPS-400 subwoofer is
equipped with 2 sets of feet
for use depending on the type
of surface the subwoofer will
be placed on. Enclosed with
this manual is a set of rubber
self-adhesive feet for use on
hard surfaces, such as wood
or tile floors, and a set of
spiked feet for use on
carpeted surfaces. To install
the feet, set the subwoofer
gently on a padded surface
with the bottom side up. If
you are using the rubber
corners of the unit, covering
the holes. If you are using the
spiked feet, install them by
pressing them into the holes.
The subwoofer may not
needed, carefully align the
grille pegs with the grommets
and insert the grille. The grille
is not designed for frequent
removal, and cannot be
readily removed with bare
hands. If for some reason it
becomes necessary to remove
the grille, it should be pried off
very carefully with a small, flat-
tipped, jewelers’ screwdriver,
taking extra care not to
perform as well as expected if
you neglect to attach the feet.
Grille
Your HTPS-400 subwoofer has
been packaged with the grille
unattached for shipping pur-
poses. In some applications,
such as custom installations,
the grille may not be necessary.
damage the baffle or the grille.
S P EAKER P LACEMENT
Experiment with placement for
Since the HTPS-400 is video-
However, to meet THX Ultra
requirements for a 3000-
cubic-foot room, two or more
HTPS-400 subwoofers are
required. The preamp output
featured on the HTPS-400
simplifies the hookup of
the most accurate and uniform shielded, it may be placed in
bass response throughout the
room. It is important to avoid
blocking the grille of the
subwoofer.
proximity to a television
monitor.
A single HTPS-400 subwoofer
meets THX Select requirements
for a 3000-cubic-foot room.
multiple units (see page 4).
Front view
Top view
0–2 ft.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
HOOKUP
Line-Level Inputs
THX Mode:
If your surround processor/
receiver is THX-certified:
Note: When the THX/Normal
switch is set to “THX,” the
subwoofer’s internal crossover
and output level control are
bypassed.
GREEN–ON
RED–STANDBY
THX®-Certified
Receiver/ Processor
CROSSOVER
LINE
PHASE
180
EQ
GAIN
Subwoofer
Out
°
NORMAL
THX
OUT
IN
0°
OFF
AUTO
ON
MIN. MAX. 50Hz 150Hz
To continue enjoying THX-
quality bass response in a
very large room, two or more
HTPS-400 subwoofers may be
connected in series. For every
3000 cu. ft. of room volume, it
is recommended that you add
one HTPS-400.
Sub 1
THX®-Certified
Receiver/ Processor
GREEN–ON
RED–STANDBY
Subwoofer
Out
CROSSOVER
LINE
PHASE
180
EQ
GAIN
°
NORMAL
OUT
IN
0°
OFF
AUTO
ON
THX
MIN. MAX. 50Hz 150Hz
Sub 2
GREEN–ON
RED–STANDBY
CROSSOVER
LINE
PHASE
180
EQ
GAIN
°
NORMAL
OUT
IN
0°
OFF
AUTO
ON
THX
MIN. MAX. 50Hz 150Hz
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Normal Mode:
Use this hookup for all non-
THX processors, including
Dolby* Digital, DTS®, Dolby
Pro Logic* or stereo.
Note: If using Dolby Digital or
DTS, set the crossover
frequency knob fully clockwise
to the maximum position. Make
sure the THX/Normal switch is
in the Normal position.
GREEN–ON
.
RED–STANDBY
Receiver/ Amplifier
CROSSOVER
LINE
PHASE
180
EQ
GAIN
Subwoofer
Out
°
NORMAL
THX
OUT
IN
0°
OFF
AUTO
ON
MIN. MAX. 50Hz 150Hz
Note: Some receivers/
processors have stereo
subwoofer outputs. In that
case, you must use a “Y”-
connector (not included) in
order to maximize the
subwoofer’s performance.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
OP ERATION
The HTPS-400 contains a
signal-sensing auto turn-on/
turn-off circuit. This feature
will automatically turn the
subwoofer on when you turn
your system on with the power
switch in the “Auto” position
and begin playing any program power switch’s “Off” position
material. The subwoofer will
return to standby mode when
no signal is received for
approximately 15 minutes. The
is for vacation use only.
Toggle
LED
Position Procedure
Color
Off
Power switch off
Red
On
Power switch on and playing program material
Green
Auto
Simply turn off your receiver/processor. The HTPS-400 will
turn off after approximately fifteen minutes. The subwoofer
No signal present for more
than 15 minutes – Red;
will turn on when your receiver/processor begins playing again. signal present – Green
Output Level (Gain) – Normal (non-THX) Modes Only
Output
Level
(Gain)
Note: When the THX/Normal
switch is set to “THX,” the
output (gain) control is
bypassed. Output level is then
adjusted at the THX processor.
Min. Max.
Output
Level
(Gain)
Min. Max.
Crossover Frequency – Normal (non-THX) Modes Only
The Crossover Frequency
adjustment determines
the highest frequency the
HTPS-400 will reproduce. It
allows a seamless transition
from the subwoofer to the
satellite speakers. Experiment
with this adjustment to
find the crossover frequency
that sounds best with your
speakers.
Note: When the THX/Normal
switch is set to “THX,” the
internal crossover is bypassed.
Crossover frequency is then
adjusted at the THX processor.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Phase
The Phase switch is used to
adjust the relative polarity of
the subwoofer to the other
speakers. When the speakers
are out of phase, the low-
frequency sound waves will
cancel each other out,
normal THX operation, the
Phase switch should be set to
0 degrees so that the sub-
woofer is operating in phase
with the main speakers. This
should produce a smooth
frequency response up to
80Hz. In rare cases when the
subwoofer is placed more
than 25 feet away from the
main speakers, or where the
subwoofer is not being used
with a THX-certified receiver,
or processor, and speakers,
the 180-degree position may
provide a smoother frequency
response.
Listen to your HTPS-400
subwoofer and main speakers
with the switch in the “0°”
position, then listen to the
same material with the switch
set to “180°”. Decide which
sounds better and leave the
switch in this position. Repeat
this procedure if you change
the location of the subwoofer.
reducing bass response.
The HTPS-400 provides a
convenient phase switch that
allows you to remedy this
situation without relocating
the speakers or changing any
speaker connections. In
TROUBLES HOOTING
If there is no output from the
subwoofer:
If there is no (or low) bass
output:
If you are hearing midrange
frequencies (such as vocals)
through the subwoofer:
• Make sure the system is on
and a source is playing.
• Make sure the HTPS-400 is
plugged into an active outlet
and the power switch is in
either the “Auto” or “On”
position.
• Make sure that the sub-
woofer is plugged into a live
electrical outlet and the
power switch is in either the
“Auto” or “On” position.
• Adjust the “Crossover
Frequency.”
• When using the THX mode,
make sure the subwoofer
crossover is activated on your
processor/receiver.
• When using the Normal
Mode, adjust the “Crossover
Frequency” to a lower
frequency.
• If you are using a THX-
certified processor/receiver,
make sure the THX/Normal
switch is set to “THX.”
• Adjust the “Output Level”
(Gain) control.
• Change the setting on the
Phase switch.
• If you are not using a THX-
certified processor/receiver,
make sure the THX/Normal
switch is set to “Normal.”
• Adjust the “Output Level”
(Gain) control.
• If you are not using a THX-
certified processor/receiver,
make sure that you have
configured your processor/
receiver so that the sub-
woofer/LFE output is on.
• Review proper operation of
your receiver/amplifier.
• Check all wires and make
sure they are properly
connected. Make sure none
of the wires are frayed, cut or
punctured.
• If you are not using a THX-
certified processor/receiver,
make sure that you have
configured your processor/
receiver so that the subwoofer/
LFE output is on.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
S P ECIFICATIONS
HTPS-400
Powered Subwoofer
Amplifier Power 1000 watts
Driver 12" with aluminum cone and
rubber surround, video-shielded
Input THX and normal line level
Output Line level (loop through from input)
Crossover Frequency – 50Hz – 150Hz (continuously adjustable)
Normal Mode
Frequency Response 25Hz – crossover point
(Determined by crossover setting)
Dimensions (H x W x D) 14-5/8" x 14-5/8" x 14-5/8"
371mm x 371mm x 371mm
Weight 62 lb/28kg
Occasional refinements may be made to existing products without notice,
but will always meet or exceed original specifications unless otherwise
stated.
THX is a registered trademark of Lucasfilm Ltd.
*Trademarks of Dolby Laboratories.
DTS is a registered trademark of Digital Theater Systems, Inc.
P RO S OUND
COMES HOME™
OWNER’S GUIDE
P RODUCT LINE:
HT S ERIES
MODEL
JBL Consumer Products
NUMBER:
250 Crossways Park Drive, Woodbury, NY 11797
HTPS-400
8500 Balboa Boulevard, Northridge, CA 91329
DES IGN GOAL: Bring the thrill of live performance and movie sound to
the home environment by calling on JBL’s professional engineering leadership.
© 2003 Harman International Industries, Incorporated.
JBL is a registered trademark of
WOOFER TYP E: Aluminum cone with rubber surrounds
Harman International Industries, Incorporated.
®
CROS S OVER NETWORK: THX -Ultra Certified
Part No.336077-001
ENCLOS URE DES IGN: Sealed
TWO UNITS MINIMUM
P ROFES S IONAL REFERENCE: Cinema Loudspeaker Series
Download from Www.Somanuals.com. All Manuals Search And Download.
|