iPhone not included
User Guide
English ........................ 2
Deutsch....................... 8
Français......................15
Español ..................... 22
Italiano......................29
Dutch ........................ 36
Korean....................... 43
Norwegian ................ 50
Danish........................57
Japanese....................64
Simplified Chinese.....71
Finnish ...................... 78
Russian ......................85
Português..................92
®
®
*
jblonstage micro IIspeaker dock for iPhone/iPod
Download from Www.Somanuals.com. All Manuals Search And Download.
fcc regulations
FCC Information for Users
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference;
and (2) this device must accept any interference received, including interference that may cause undesired operation.
Radio and Television Interference
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment
off and then on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Increase the separation between the equipment and receiver.
• Connect the equipment to a different outlet so that the equipment and receiver are on different branch circuits.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by JBL could void the user’s authority to operate the equipment.
Battery Disposal
Alkaline batteries are considered non-hazardous. Rechargeable batteries (i.e., nickel cadmium, nickel metal-hydride, lithium and lithium-ion) are considered
hazardous household materials and may pose an unnecessary health and safety risk.
In the European Union and other locations, it is illegal to dispose of any battery with household trash. All batteries must be disposed of in an environmentally sound
manner. Contact your local waste management officials for information regarding the environmentally sound collection, recycling and disposal of used batteries.
IC Statement and Warning
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
jbl on stage micro II easy setup guide
Carefully unpack your speaker
system and identify all its
components. JBL On Stage
Micro II, power supply, remote
and adapter.
Step 2. Move the battery door to
the unlocked position to open
the battery compartment.
Step 3. Place 4 AAA batteries
in the battery compartment.
Step 4. Connect the power adapter
into the jack labeled “6V DC In” on
the rear of the JBL On Stage Micro
II and plug the power adapter into
a wall outlet or power strip.
or
* Auxilary audio
cables not included
-
+
Step 5. Place the appropriate iPhone/iPod adapter onto JBL On Stage
Micro II. Place your iPhone/iPod on the docking connector or connect
a 3.5mm (1/8") stereo audio cable to the rear of the JBL On Stage
Micro II. Connect the audio cable to the audio source.
Step 7. Adjust the volume using
(+) to increase and (–) to decrease.
Press both to mute the JBL On
Stage Micro II. Press either button
to unmute.
Step 6. Press the Power button
on the back of the JBL On Stage
Micro II. A green LED will light
when the JBL On Stage Micro II
system is on.
Syncing and transfering files with your computer
Make sure your iPhone/iPod is securely docked into the JBL On Stage Micro II. Connect a USB cable (not included) into the USB jack on the back of the unit, connect other end of the USB cable directly
to your computer’s USB port. Make sure your iPhone/iPod and iTunes are updated to the latest software version.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
troubleshooting your jbl on stage micro II
Technical Specifications
Troubleshooting
Possible Problem
Solution
Symptom
Frequency Response:
70Hz – 20kHz
No power to the system
Ensure that the power supply is connected to a live
power source and properly connected to the JBL On
Stage Micro II. Note: When the JBL On Stage Micro II
is powered, a green power LED on the JBL On Stage
Micro II should light up.
No sound from the
JBL On Stage Micro II
speaker system
Power adapter plug is not
inserted correctly
Power Consumption:
10W Maximum
Power Input:
No volume or low volume
Touch the volume “Up” (+) pad on the volume
control to unmute and/or increase the system volume
level.
6V/1.5A
JBL On Stage Micro II Transducer:
(2) 1" Full range per channel
Note: Touching the volume “Down” (–) pad lowers
the system volume. Touching both the (+) and (–)
volume control pads at the same time will mute the
system.
Dimensions:
Diameter – 6" (150mm)
Height – 1-3/4" (38mm)
System Weight:
2.22 lb (1.01kg)
Increase the volume level on the audio source device.
Replace the batteries.
Input source is low
Low or drained batteries
iPhone/iPod is paused
Battery:
Size – AAA
Type – Alkaline, NiMh
Quantity – 4
Press the Play button on the iPhone/iPod or remote
control.
Note: If the iPhone/iPod is paused more than 10 min-
utes, press the JBL On Stage Micro II Power button to
turn the unit back on. Press either (+) or (–)
to unmute.
DO NOT MIX BATTERY TYPES.
iPhone/iPod is paused
(battery-only mode)
DO NOT MIX CHARGED AND
PARTIALLY CHARGED BATTERIES.
BATTERIES WILL NOT RECHARGE
WHILE IN JBL ON STAGE MICRO II.
These specifications are subject to change without notice.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Troubleshooting
Symptom
Possible Problem
Solution
No sound from the JBL On Stage
Micro II speaker system (continued)
The JBL On Stage Micro II has been
muted for more than 10 minutes in the back on. Press either (+) or (–) to unmute.
battery-only mode
Press the JBL On Stage Micro II Power button to turn the unit
No sound, no LED
No audio signal has been received for
10 minutes and JBL On Stage Micro II
is in standby mode
Make sure audio signal is supplied through docked iPhone/iPod
or “Audio In” jack.
No power; green LED is not on
Wall adapter is not plugged into the
JBL On Stage Micro II correctly
Check the connection of the wall adapter.
Place the wall adapter in a known powered outlet. Test the outlet
with a lamp or other device.
Wall adapter is not receiving AC power
Connect the JBL On Stage Micro II to a known audio source.
Test the audio source with headphones.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Troubleshooting
Symptom
Possible Problem
Solution
Note
There is no sound coming from
the JBL On Stage Micro II.
No power to unit.
Make sure that the wall outlet
or power strip has power.
Make sure that all switches for
outlet/power strip are on and
that all switches for the unit
are on.
Is the LED on? If the LED
is not on, power is not
getting to your JBL On Stage
Micro II. Try the solutions
shown.
Make sure that the iPhone/iPod
is properly docked or that the
auxiliary cable is properly con-
nected.
Incorrect source selection.
Turn up the volume.
Check the unit with a source
that you know to be good.
Connect the “Aux In” cable to
the headphone jack of your
iPhone/iPod.
Sound comes from only one
side/channel.
iPhone/iPod or auxiliary cable
is not seated properly.
Make sure that the iPhone/iPod
is seated all the way into the
docking station.
If you are using a 3.5mm
auxiliary extension cable,
make sure it is a stereo
cable.
Make sure that the auxiliary
cable is seated all the way into
the jack.
Try resetting the iPhone/iPod.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
Troubleshooting
Symptom
Possible Problem
Solution
Note
Distortion (static, cracking
or hissing sounds).
Audio source or source material
may be the problem.
Test the JBL On Stage Micro II
with another source.
Does the distortion occur with
specific songs? If so, check
the recording or record the
source again.
Volume level may be too high.
Check the volume of the source. Some devices will distort the
output signal if the volume is
set to maximum.
EQ setting may be too high.
Check the EQ setting on your
iPhone/iPod or source device.
It is recommended that you set
the source device EQ to “Flat”
or “Off.”
JBL On Stage Micro II
emits a loud hum
or buzzing noise.
Input cable is not plugged in
properly.
Check the input cable connec-
tion.
Cable may be bad.
Replace the cable.
Ground logo (an unsuitable
connection).
Turn the JBL On Stage Micro II
off and connect it to another
wall outlet.
Speaker system experiences
radio-frequency interference or
picks up a radio-station trans-
mission.
Purchase a ferrite core and
Input cable may be
picking up interference.
wrap the excess cable around it.
A ferrite core can be purchased
at your local electronics store.
8
Download from Www.Somanuals.com. All Manuals Search And Download.
jbl on stage micro II remote easy setup guide
Volume Down
Volume Up
iPhone/iPod Play/Pause1
Mute/Unmute1
iPhone/iPod Previous/Rewind
*Hold for “rewind”
iPhone/iPod Next/Fast Forward
*Hold for “fast forward”
iPhone/iPod Scroll Down
iPhone/iPod Select/Enter
iPhone/iPod Scroll Up
iPhone/iPod Menu
Additional Features:
1. In the battery-only mode, the JBL On Stage Micro II loudspeaker dock will turn off to save battery power when muted or paused
for longer than 10 minutes.
2. In the wall adapter power supply mode JBL On Stage Micro II will go into standby mode if no audio signal is detected for 10
minutes. The green LED will turn off. Once an audio signal is detected the speaker will return to normal playing mode and the
green LED will light up.
3. iPod touch and iPhone menu navigation may require the user to manually put the iPhone/iPod in music mode.
4. When the batteries are low the “low battery LED” will turn on. Change batteries immediately or switch to the power adapter.
9
Download from Www.Somanuals.com. All Manuals Search And Download.
JBL and Odyssey are trademarks of Harman International Industries, Incorporated, registered in the United States and/or other countries.
*The trademark On Stage is used with permission of OSA International, Inc.
iPhone is a trademark of Apple Inc., registered in the U.S. and other countries. iPod is a trademark of Apple Inc., registered in the U.S. and other countries. iPhone/iPod not
included. “Made for iPod” means that an electronic accessory has been designed to connect specifically to iPod and has been certified by the developer to meet Apple per-
formance standards. “Works with iPhone” means than an electronic accessory has been designed to connect specifically to iPhone and has been certified by the developer to
meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.
Features, specifications and appearance are subject to change without notice.
JBL et Odyssey sont des marques commerciales de Harman International Industries, Incorporated, déposées aux États-Unis et/ou dans d’autres pays.
*Le marque “On Stage” est utilisée avec la permission de OSA International, Inc.
iPhone est une marque commerciale d’Apple Inc., deposée aux États-Unis et dans d’autres pays. iPod est une marque commerciale d’Apple Inc., deposée aux États-Unis et
dans d’autres pays. iPhone/iPod non inclus. « Made for iPod » signifie qu’un accessoire électronique a été conçu pour assurer la connexion spécifiquement à iPod et a été
homologué par le développeur pour répondre aux normes de performance d’Apple. « Works with iPhone » signifie qu’un accessoire électronique a été conçu pour assurer la
connexion spécifiquement à iPhone et a été homologué par le développeur pour répondre aux normes de performance d’Apple. Apple n’assume aucune responsabilité pour
le fonctionnement de cet appareil, ni pour sa conformité aux normes de sécurité et réglementaires.
Sous réserve de modification.
Harman Consumer, Inc.
8500 Balboa Boulevard, Northridge, CA 91329 USA
1.516.255.4525 (USA only)
© 2010 Harman International Industries, Incorporated. All rights reserved. Tous droits réservés.
Part Number: 950-0282-001
10
Download from Www.Somanuals.com. All Manuals Search And Download.
|