INSTALL INSTRUCTIONS C-TM-IMP-1
HEAVY DUTY TRAK MOUNT
2006-2009 CHEVROLET IMPALA
TOOLS REQUIRED:
Ratcheting wrench
Standard Socket set
Open-end wrench set
Screwdriver Set
HARDWARE:
QTY DESCRIPTION
PART #
1
1
1
1
18” Length Extrusion
12” Length Extrusion
Transmission Hump Bracket (no holes drilled)
Rear Extrusion Bracket
Extrusion Adapter Bracket
¼” Serrated Nut
¼ x ¾” Hex Head Bolt
¼” x ¾” Phillips pan head machine screws
¼” Flat washers
#10 x ¾” Phillips pan head machine screws
¼” x ¾” Hex Head Lag Bolts
CM93055-2
CM93055-1
C-B43
CM001380
CM001379
GSM30023
GSM33001
GSM33124
GSM31000
GSM33119
GSM33060-1
C-B42
1
12
12
6
6
2
6
Always!
¾ Read all instructions before installing any Havis-Shields Equipment Corp products.
¾ Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
¾ Use hardware provided with install kit
¾ For product support, visit the Install Instructions Section of our website at
1-800-524-9900.
18” Length
Extrusion
C-TM-IMP-1
12” Length
Extrusion
Transmission
Hump Bracket
(C-B43)
Guide bracket
Extrusion
Adapter Bracket
Under seat
adapter bracket
Rear Extrusion
Bracket
Cut floor mat, next to the seat
rail to allow Under seat
support bracket to slide under
seat rail
Slide under seat support
brackets into position as
shown
Slide guide brackets into seat rail
and loosely attach #10 x ¾” Phillips
pan head machine screws
1. Position sub-assembled transmission hump bracket, 18”
portion of trak, extrusion adapter bracket, rear extension
bracket and 12” portion of trak to the under seat & guide
brackets.
2. Loosely attach assembly using ¼-20 x ¾” Phillips machine
screws and washers.
Attach rear extrusion
Tighten all loose hardware.
Insert necessary hardware for
consoles and accessories and
attach plastic end caps
bracket to 12” portion of
extrusion using (2) ¼-20 x
¾” bolts and serrated nut
C-TM-IMP-1_INST_11-08
3
C-TM-IMP-1 installed
C-TM-IMP-1 installed w/ console, computer
mounts and accessories. (Sold separately)
C-TM-IMP-1_INST_11-08
4
|