Haier HW 09LN03 User Manual

WINDOW TYPE ROOM AIR CONDITIONER  
HW-09LN03  
HW-12LN03  
No.0010515690  
Front panel  
Air inlet (indoor side)  
Machine body  
Air outlet (indoor side)  
Air inlet (outdoor side)  
Display panel  
Power plug  
Air filter (inside)  
1
2
3
4
5
6
7
FAN SPEED  
8
MODE  
FAN,COOL,DEHUM.  
:HIGH or LOW.  
FAN SPEED  
SWING  
ENERGY SAVER  
Used to activate ENERGY SAVER option,reduce energy consumption and noise.  
POWER  
2
POWER  
1
2
3
MODE  
FAN SPEED  
FAN,COOL,DEHUM.  
FAN SPEED  
5
TIMER button  
Used for TIMER start or stop .  
4
5
TEMP.orTIME set  
Used to set TIME or TEMP. setting.  
E-S  
ENERGY SAVER  
6
7
SWING  
E-S  
3
COOL  
1.Start  
Press POWER button  
2. Select operation mode  
Press MODE button. For each press, operation mode  
FAN  
COOL  
DEHUM  
changes as follows:  
Then select COOL operation.  
When the COOL display lights bright,the unit will  
be working under the cooling function.  
FAN SPEED  
3. Select temp. setting  
5
4. Fan speed selection  
If you choose the FAN SPEED mode you can run the  
fan in one of the 2 speeds: HIGH or LOW.  
Select desired setting.  
Change air flow direction if necessary.  
5. Stop  
Press POWER button again.  
E-S  
FAN SPEED  
at outlet  
4
DEHUMID mode  
1. Start  
Press POWER button.  
2. Select operation mode  
Press MODE button. For each press, operation mode  
changes as follows:  
FAN  
COOL  
DEHUM  
Then select DEHUMID operation.  
When the DEHUM display lights bright,The unit will be  
working under the dehumidify function.  
5
If you need to only remove the moisture press the  
Dehnmid button. Change air flow direction if necessary.  
FAN SPEED  
4
3. Select temp. setting  
4. Fan speed selection  
If you choose the FAN SPEED mode you can run the  
fan in one of the 2 speeds:HIGHOR LOW.  
Air conditioner is running under displayed fan speed.  
In DRY mode, when room temperature becomes  
lower than temp.setting+2oC,unit will run intermittently  
at LOW speed regardless of FAN setting.  
5. Stop  
3UHVVꢀ32:(5ꢀEXWWRQꢀDJDLQꢁ  
COOL operation starts when room  
temp.is higher than temp.setting.  
Ultra-low air flow  
FAN SPEED  
Temp.setting+2 C  
Temp.setting  
On reaching temp.setting +2 C  
unit will run in mild DRY mode.  
The compressor may cycle for 10 minutes on and 6 minuters off in  
Dehumid mode.  
5
FAN operation  
1. Start  
Press POWER button.  
2. Select operation mode  
Press MODE button. For each press, operation mode  
changes as follows:  
Then select FAN operation.  
FAN  
COOL  
DEHUM  
4
FAN SPEED  
When the FAN display lights bright ,the unit will be  
working under the fan operation.  
In some days you may want to run the FAN function.  
Press the FAN button.  
3. Fan speed selection  
Here the fan runs only at HIGH or LOW speed.  
Change air flow if necessary.  
4. Stop  
Press POWER button again.  
E-S  
FAN SPEED  
4
6
ENERGY SAVER operation  
1. Start  
Press POWER button.  
2. Select operation mode  
Press MODE button. For each press, operation mode  
changes as follows:  
FAN  
COOL  
DEHUM  
4
Then select COOL operation.  
When the COOL display lights bright,the unit will  
be working under the COOL function.  
FAN SPEED  
Saving energy function only can be used  
when A/C working on cooling condition.  
ENERGY SAVER selection  
When this function is selected, the fan will  
shut off three minutes after the compressor  
cycles off. This will reduce energy consumption  
and noise. When the compressor turns back on,  
the fan will turn on at the same time. If this  
function is not selected, the fan will not shut  
off when the compressor cycles off.  
E-S  
4. Stop  
Press POWER button again.  
FAN SPEED  
3
4
7
On  
Off  
24  
On Off  
cool  
On  
24  
Press "On"of remote controller or "TIMER" of control panel,  
Off  
panel,  
Press "Off"of remote controller or "TIMER"of control  
TIMER ON  
mode  
restarted  
FAN SPEED  
5
FAN SPEED  
E-S  
8
Power failure resume(please set and apply as necessary)  
If sudden power failure occurs, the unit will resume original operation when power is supplied again.  
Note:  
When sudden power failure happens during unit operation in power failure resume mode, if the air  
conditioner is not desired for use in a long period, please shut off the power supply in case that the  
unit automatically resume operation when power is re-supplied, or press POWER to turn off the unit  
when power resumes.  
Operation  
Adjusting of the air direction  
Vertical airflow direction  
Airflow Direction Vane  
The Vertical Airflow Direction Vane is  
manually controlled by positioning the  
vane todischarge the air upward,  
downward or straight out.  
The horizontal air direction is adjusted  
by setting the AUTO SWING ON .  
Note:  
It is advisable not to keep horizontal flap at downward position for a long  
time in COOL or FAN mode, otherwise , condensate water might occur.  
Don't move the vertical blade with hand in order to avoid the vertical blade  
abnormal, using the remote controller to adjust the move of vertical blade.  
9
pulling  
Pull  
Pull  
ush  
"
CLOSE"position, the vent door opens to allow air, smoke  
or odors to be expelled from the room;  
"
OPEN"position, the vent door is closed and the air inside  
the room is circulated and conditioned.  
CLOSE  
OPEN  
10  
11  
Disposal of the condensed water  
Generally there are two methods available on disposal of the condensed water:  
1. Block the bottom plate hole of the conditioner with rubber lid, install outlet pipe fitting on the  
back hole and let the condensing water flow from the back hole of the conditioner. (See Fig.1 )  
In this method, the accumulated condensed water in the bottom plate is hit by the fan onto the  
heat exchanger, and evaporated and blown out from the machine. It can cool the heat exchanger  
radiator more quickly, and improve the energy efficiency of the conditioner. But the hitting noise  
by the fan at the outdoor side is relatively large.  
2. Block the back hole of the conditioner with rubber lid and install outlet pipe fitting to the bottom  
hole, which can make the condensed water flow out from the bottom plate. (See Fig.2)  
If necessary the above two methods can both have extra pipe added on the outlet pipe fitting.  
(available on the market).  
(Refer to P15 for choosing these two modes.)  
Fig.1  
Fig.2  
Outlet  
pipe fitting  
Rubber lid  
Back hole  
Back hole  
Rubber lid  
Outlet pipe fitting  
Bottom plate hole  
Bottom plate hole  
Cautions  
Power cord: Be sure to use the exclusive power cord.  
Change installation place: If air-con need to be changed to another  
place please contact the dealer, who sold you the unit.  
12  
13  
Outlet  
pipe fitting  
Remote  
Battery  
Screw  
Name Manual  
Figure  
Sealed gasket  
Rubber lid  
controller  
(R-03 dry battery)  
(ꢀ6  
1
2
1
1
1
3
1
Quantity  
14  
MODEL  
HW-09LN03  
366mm  
392mm  
481mm  
610mm  
HW-12LN03  
outlet pipe fitting  
outlet pipe fitting  
outlet pipe fitting  
15  
Wiring Diagram  
0010511621  
WIRING DIAGRAM  
COMPRESSOR  
FAN MOTOR  
M
S
RECEIVING HEAD  
LOUVER  
MOTOR  
R
C
BR  
BR  
B
M
CAPACITOR  
M
L
H
M
BL  
B
BL  
OR  
B
R
BL  
R
BL  
#
CN13  
CN12  
CN8 CN9  
CN10  
CN11  
CN14  
CN3  
CN2  
4
3
FUSE  
TEMP.SENSOR  
COMP.RELAY  
250V/3.15A  
BR  
Y/G  
BL  
POWER SUPPLY  
R:RED  
NOTE:1.Because of different compressor,the dotted  
part may not be used.  
OR:ORANGE  
B:BLACK BR:BROWN  
BL:BLUE  
2.There are no dotted lines on some types.  
(marked with @)  
Y/G:YELLOW/GREEN  
Dimensions(indoor  
unit) D*W*H(mm)  
Circulation  
Power input/  
Current/Rated  
current(A)  
Dehumidification  
Capacity(10.M/h)  
12 Month  
Guarantee  
Net weight  
(Kg)  
Capacity(BTU)  
Airflow(m3/h)  
Rated power  
input (W)  
9000  
980/1500 4.4/6.9  
1250/1600 6.5/8.5  
360  
450  
1.0  
1.2  
29.5  
37  
Yes  
Yes  
HW-09LN03  
HW-12LN03  
531X471X356  
560X600X382  
12000  
Note: All capacities are gross.  
Haier THERMOCOOL reserves the right to change  
specifications as part of its policy of continuous improvement.  
16  
-
-
With 3 years warranty on all air- conditioner compressors, you have  
peace of mind from the date of purchase  
-
NATIONWIDE SALES AND SERVICES  
-
-
MINNA,ILORIN,OSHOGBO,LOKOJA,  
sales office  
7
2719790  

Adaptive Engineering HQ7100 User Manual
Brookstone Mobile 2600 mAh Power Charger 802217 User Manual
Cornelius 1522 User Manual
Cornelius A8531 User Manual
Danby DAC9006DE User Manual
Epson Artisan 1430 C11CB53201 User Manual
Holland Fifth Wheel XA 3501 Series User Manual
Hotpoint Air Conditioner HP21WR User Manual
HP Hewlett Packard All in One Printer C9309A User Manual
HP Hewlett Packard Hewlett Packard Air Conditioner 3563A User Manual