Unpack the device
Turn on the computer
Windows users START HERE
Begin software installation
1
2
3
4
a
b
This side of the poster is for Windows users only.
Turn on your computer and wait for
the Windows PC desktop to appear.
Insert the Windows HP PSC CD and follow the onscreen instructions.
a
Follow the steps on this poster in order.
If nothing appears on your computer screen after you insert the CD, see the Troubleshooting
Information chapter in the Reference Guide.
Windows PC
Close any open programs.
Do not connect the USB cable until the software
prompts you to do so.
When you see the Set Up Your Device Now screen, leave your computer and proceed to step 5 on
this poster. Do not connect the USB cable yet.
b
Windows PC desktop
a
b
Windows 98,
2000, ME, XP
Attach the front panel cover
Load plain white paper
Connect the power cords
c
5
6
7
a
b
a
Remove the adhesive backing from the front panel cover.
a
c
b
b Raise the lid of the HP PSC. Place the front panel cover into the recess and
stick it into place.
The HP PSC will not work until you attach the front panel cover!
a
b
a
b
Open the print-carriage access door
Turn on the device
Connect the USB cable
8
9
10
Make sure that you see the Set Up Your Device Now
screen on your computer, then connect the USB
cable. Do not connect the USB cable to a keyboard
or a non-powered USB hub.
Press the On/Resume
Lower the print-carriage
access door. The print
carriage slides to the
middle.
button to turn on the
HP PSC. Wait for it to
finish initializing.
Insert and align the print cartridges
Finish software installation
12
11
Hardware setup is now complete. Return to your computer.
Tri-color
Black
Click Next on the screen with the green checkmark. Depending on your
system, it may take 20 minutes or more to finish installing the software.
a
c
e
b
d
When you restart your computer and the Congratulations screen appears,
you are ready to use your HP PSC. If you encounter problems during setup,
see the Reference Guide.
Remove the bright pink tape from
the print cartridges. Do not touch
the gold-colored contacts or
retape the cartridges.
Hold the black print cartridge with the large HP label and
the raised markings on top. Slide the cartridge at a slight
angle into the right side of the print carriage.
Hold the color print cartridge with the large HP label and the raised
markings on top. Slide the cartridge at a slight angle into the left side
of the print carriage.
Close the print-carriage access door. Within a few minutes, a
print cartridge alignment page prints.
Press the Scan button.
After the On light stops blinking,
alignment is complete. Discard or
recycle the alignment page.
Place the top of the alignment page face down in the left
front corner of the glass. Close the lid.
Press firmly until the print cartridge snaps into place.
Press firmly until the print cartridge snaps into place. Make sure that
both print cartridges are secure.
|