NOTE:
Please read all instructions
carefully before using this
product
Table of Content
Safety Notice
IGS-06
CABLE CROSSOVER
Hardware Identifier
Assembly Instruction
Parts List
Warranty
Ordering Parts
Model
IGS-06
Retain This
Manual for
Reference
04-18-02
OWNER'S
MANUAL
IMPEX FITNESS PRODUCTS
14777 DON JULIAN RD., CITY OF INDUSTRY, CA 91746
Tel: (800) 999-8899 Fax: (626) 961-9966
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPORTANT SAFETY NOTICE
PRECAUTIONS
This exercise machine is built for optimum safety. However, certain precautions apply
whenever you operate a piece of exercise equipment. Be sure to read the entire
manual before you assemble or operate your machine. In particular, note the following
safety precautions:
1. Keep children and pets away from the machine at all times. DO NOT
leave children unattended in the same room with the machine.
2. Only one person at a time should use the machine.
3. If the user experiences dizziness, nausea, chest pain, or any other abnormal
symptoms, STOP the workout at once. CONSULT A PHYSICIAN
IMMEDIATELY.
4. Position the machine on a clear, leveled surface. DO NOT use the machine
near water or outdoors.
5. Keep hands away from all moving parts.
6. Always wear appropriate workout clothing when exercising. DO NOT wear
robes or other clothing that could become caught in the machine. Running
or aerobic shoes are also required when using the machine.
7. Use the machine only for its intended use as described in this manual. DO
NOT use attachments not recommended by the manufacturer.
8. Do not place any sharp object around the machine.
9. Disabled person should not use the machine without a qualified person or
physician in attendance.
10. Before using the machine to exercise, always do stretching exercises to
properly warm up.
11. Never operate the machine if the machine is not functioning properly.
WARNING: BEFORE BEGINNING ANY EXERCISE PROGRAM, CONSULT YOUR
PHYSICIAN. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE
AGE OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. READ ALL
INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT. IMPEX INC.
ASSUMES NO RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY
DAMAGE SUSTAINED BY OR THROUGH THE USE OF THIS PRODUCT.
SAVE THESE INSTRUCTIONS.
2
Download from Www.Somanuals.com. All Manuals Search And Download.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Adjustable Wrench and Allen Wrench
NOTE: It is strongly recommended this machine to be assembled by two or more
people to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Attach a Floor Stabilizer (#6) and a Lower Pivot Bracket (#35) to the Base Frame
(#3). Secure it with two M12 x 4” Carriage Bolts (#28), ∅ 1” Washers (#29), and
M12 Aircraft Nuts (#30).
B.) Insert the Lower Pulley Bracket (#14) into the hole on the Lower Pivot Bracket
(#35). Secure it with one M10 x 1” Allen Bolt (#38) and ∅ 1 ½” Washer (#39).
C.) Repeat the procedure A and B above to install the other side.
DIAGRAM 1
4
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 2 (See Diagram 2)
A.) Attach a Support Frame (#2) to the Floor Stabilizer (#6). Secure it with one Bracket (#16),
two M12 x 4” Carriage Bolts (#28), ∅ 1” Washers (#29), and M12 Aircraft Nuts (#30).
B.) Insert two Guide Rods (#12) into the holes on top of the Base Frame (#3). Secure each
Guide Rod with one M10 x 1” Allen Bolt (#38) and ∅ ¾” Washer (#32) from the bottom.
C.) Slide one 1” Thick Rubber Bumper (#22) onto each Guide Rod from top. Note: WD40 or
similar lubricant might be needed. Slide one Guide Rod Sleeve (#5) onto each Guide Rod
from top. Then slide one more 1” Rubber Bumper (#22) onto each Guide Rod from the top.
D.) Screw a Small Pulley Bracket (#8) to the top of the Weight Holder (#4). Slide the Weight
Holder (#4) onto the two Guide Rods (#12) from the top. Slide one ½” Thick Rubber Bumper
(#23) and Olympic Sleeve (#13) onto the Weight Holder from each end. Clip one Spring Clip
(#25) onto each end of Olympic Sleeve.
E.) Repeat the Step A, B, C, D above to install the other side.
F.) It is strongly recommended to spray lubricant such as WD-40 on the Guide Rods to
minimize friction.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 3 (See Diagram 3 & Cable Loop Diagram)
A.) Attach the horizontal beam on the Crossover Frame (#1) to the top of the two Guide
Rods (#12). Note: Help of a second or third person is a must!! Secure the Guide Rods
with two M10 x 1” Allen Bolts (#38) and ∅ ¾” Washers (#32). Repeat the same
procedure to install the other side.
B.) Secure each end of Crossover Frame to each Rear Support Frame (#2) with one
Bracket (#16), two M12 x 4” Carriage Bolts (#28), two ∅ 1” Washers (#29), and two
M12 Aircraft Nuts (#30).
C.) Attach an Upper Pulley Bracket (#9) to the horizontal beam on the Crossover Frame
(#1). Secure it with a M10 x 1” Allen Bolt (#38) and ∅1 ½” Washer (#39). Repeat the
same step to install the other side.
D.) Attach the Cable (#20) to the Lower Pulley Bracket (#14). Attach a 6” Pulley (#18) to
the Bracket. Secure it with one M10 x 2” Allen Bolts (#31), two ∅ ¾” Washers (#32),
and one M10 Aircraft Nut (#33).
E.) Pull the Cable (#20) to the open bracket on the Floor Stabilizer (#6). Repeat Step D
above to install a 6” Pulley (#18).
F.) Pull the Cable upward towards the open pulley bracket on the Crossover Frame (#1).
Install another 6” Pulley (#18).
G.)Draw the Cable downward to the Small Pulley Bracket (#8) on the Weight Holder (#4).
Install a 4 ½” Pulley (#19) to the bracket.
H.) Pull the Cable upward to the Upper Pulley Bracket (#9). Install a 6” Pulley.
I.) Repeat the steps above to install the other side.
J.) Attach a C-clip (#37) to the end of the Cable. Attach one end of a Chain (#36) to the C-
clip and the other end to the Handle. Repeat to install the other three handles.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
DIAGRAM 3
7
Download from Www.Somanuals.com. All Manuals Search And Download.
8
Download from Www.Somanuals.com. All Manuals Search And Download.
PARTS LIST
KEY NO.
DESCRIPTION
Crossover Frame
Support Frame
Base Frame
Q’ty
1
2
1
2
3
2
4
Weight Holder
2
5
6
Guide Rod Sleeve
Floor Stabilizer
4
2
7
Allen Bolt
4
8
9
Small Pulley Bracket
Large Upper Pulley Bracket
∅ 1” x 1 ½” Brass Bushing
Handle
2
2
2
4
4
4
2
4
4
2
8
2
2
8
8
4
4
4
8
8
12
12
12
10
28
10
4
4
2
8
12
4
2
8
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
Guide Rod
Olympic Sleeve
Lower Pulley Bracket
∅ 1” x ¾” Brass Bushing
Bracket
Chin Up Grip
6” Pulley
4 ½” Pulley
Cable
M10 x 1” Round Allen Bolt
1” Thick Rubber Bumper
½” Thick Rubber Bumper
Olympic Sleeve End Cap
Spring Clip
Spring Clip Sleeve
Horse Shoe End Cap
M12 x 4” Carriage Bolt
∅ 1” Washer
M12 Aircraft Nut
M10 x 2” Allen Bolt
∅ ¾” Washer
M10 Aircraft Nut
2” x 2 ¾” End Cap
Lower Pivot Bracket
Chain
C-clip
M10 x 1” Allen Bolt
∅ 1 ½” Washer
Cone-shaped End Cap
Plastic Bushing
9
Download from Www.Somanuals.com. All Manuals Search And Download.
IRON GRIP SPORT
By IMPEX FITNESS PRODUCTS
LIMITED LIFE TIME WARRANTY
IMPEX FITNESS PRODUCTS ("IMPEX") warrants this product to be free from defects in workmanship
and material, under normal use and service conditions, for a period of LIFE TIME on the Frame and Weld,
3 YEARS on parts, and 6 MONTHS on upholstery from the date of purchase. This warranty extends only
to the original purchaser. IMPEX's obligation under this Warranty is limited to replacing or repairing, at
IMPEX's option.
All returns must be pre-authorized by IMPEX. Pre-authorization may be obtained by calling IMPEX
Customer Service Department at 1-800-999-8899. All freights on products returned to IMPEX must be
prepaid by the customer. This warranty does not extend to any product or damage to a product caused by
or attributable to freight damage, abuse, misuse, improper or abnormal usage or repairs not provided by
an IMPEX authorized service center or for products used for heavy commercial or rental purposes. No
other warranty beyond that specifically set forth above is authorized by IMPEX.
IMPEX is not responsible or liable for indirect, special or consequential damages arising out of or in
connection with the use or performance of the product or other damages with respect to any economic
loss, loss of property, loss of revenues or profits, loss of enjoyments or use, costs of removal, installation
or other consequential damages or whatsoever natures. Some states do not allow the exclusion or
limitation of incidental or consequential damages. Accordingly, the above limitation may not apply to you.
The warranty extended hereunder is in lieu of any and all other warranties and any implied warranties of
merchantability or fitness for a particular purpose is limited in its scope and duration to the terms set forth
herein. Some states do not allow limitations on how long an implied warranty lasts. Accordingly, the
above limitation may not apply to you.
This warranty gives you specific legal right. You may also have other rights which vary from state to
state. Register on-line at www.impex-fitness.com
IMPEX INC.
14777 Don Julian
City of Industry, CA 91746
ORDERING REPLACEMENT PARTS
Replacement parts can be ordered by calling our Customer Service Department toll-free at 1-800-999-
8899 during our regular business hours: Monday through Friday, 9 am until 5 pm Pacific standard time.
When ordering replacement parts, always give the following information.
1.
2.
3.
4.
Model
Description of Parts
Part Number
Date of Purchase
10
Download from Www.Somanuals.com. All Manuals Search And Download.
|