P R E P A R A T I O N
IKELITE VIDEO CASE
SUPPLEMENTAL INSTRUCTIONS FOR
PACKAGED WITH HOUSING__________________________________________________
#6038.91Sony HDR SR5
• External UR/Pro Color Filter
• Internal Lens Shade
• Silicone Lubricant
COLOR FILTER_____________________________________
The installation and usage of the external UR/Pro
color filter is described in the general instruction manual.
LENS SHADE_______________________________________
The internal lens shade helps block light reflection/
refraction caused by the interaction of the external color
External
Color Filter
Internal
Lens Shade
filter and the port.
Carefully thread the lens shade on the front of the
camera lens. The lens threads are very fine; DO NOT cross thread. It should screw on
very easily. If it is difficult to turn, you are cross threading.
Completely thread the lens shade into the camera to avoid any potential
clearance or sealing problems when the camera is installed and the housing is sealed.
LCD MONITOR / EXTERNAL MIRROR_________________________________________
The camera's LCD monitor can be viewed from the rear of the housing, using the
external mirror featured on the side of the housing.
Open the LCD monitor on the camera, rotate 180°, and then press it back against
the side of the camera. The external mirror is hinged so that it can be opened to reflect
the image from the camera's LCD monitor for viewing from the rear of the housing.
During transportation, please remember to close the mirror by pressing it against
the side of the housing or lid snap.
This supplemental set of instructions describes additional features specific
to your housing model. Prior to testing the system in the water, please read
this supplement along with the general instruction manual to become familiar
with its features and functions.
Ikelite Video Cases are slightly negative in salt water for stability. This
housing has been water pressure tested at the factory and has a working
depth of 60m (200').
Power
Lid Snap
Power Zoom
HOUSING CONTROLS________________
• Power On/Off / Mode
• Start/Stop
BATTERY AND TAPE__________________________________________________________
Install a fully charged Sony battery on the camera:
Port
Sony NP-FH50, NP-FH60, NP-FH70
Other brand batteries may not fit inside the housing.
Make sure you have loaded an appropriate digital cassette tape in the camera.
Touch
Pad
• Snap Shot
Mirror
• Power Zoom
• Photo
T. P.
Bottom Bar
• LCD Screen Control #1
• LCD Screen Control #2
• LCD Screen Control #3
• LCD Reversing Circuit On/Off
• Display Batt Info
OPTIONAL WIDE ANGLE LENS_______________________________________________
The housing’s port accepts optional 67mm threaded waterproof Wide-Angle lenses
such as the Ikelite #6420 W-20, Epoque DCL-20 and Inon UWL-100 Type 2. These
waterproof lenses secure to the outside of the lens port.
Should you elect to use an optional waterproof lens, carefully thread the lens on
the front of the lens port on the housing. The lens threads are very fine; DO NOT cross
thread. It should screw on very easily. If it is difficult to turn, you are cross threading.
Base
On/Off
for Reverse
Circuit
• Touch Pad Controls
Snap Shot
INTERNAL WIDE-ANGLE LENS OPTION ________________________________________
Special ports are available for use with the Raynox HD-5050 Pro high definition
wide-angle lens. optional ports sold separately as dome port #9304 or flat lens port
Start/
Stop
MAIN O-RING #0109_________________
O-rings last several years if properly
maintained. Control seals should not need to
be replaced as long as the control shafts are
kept clean and lightly lubricated.
not
#9304.1. Raynox HD-5050 Pro lens not included. Lens
through Ikelite.
available for purchase
Download from Www.Somanuals.com. All Manuals Search And Download.
|