INSTALL INSTRUCTIONS C-VS-0309-F250
VEHICLE SPECIFIC CONSOLE
1999-2007 FORD F-250, 350, 450, 550
TOOLS REQUIRED:
Ratcheting wrench
Sockets Set
Screwdriver set
T-20 torx bit
Cutting tool (if necessary)
HARDWARE:
QTY DESCRIPTION
PART #
2
2
2
4
1
¼” x 1 ¼” Hex head bolt
¼” Flat washer
¼” Serrated nut
#8 x ¼” Phillips flat head sheet metal
Torx Screw kit
GSM33003
GSM31005
GSM30023
GSM33178
C-HK-1
Always!
ꢀ Read all instructions before installing any Havis-Shields Equipment Corp products.
ꢀ Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
ꢀ Use hardware provided with install kit
ꢀ For product support, visit the Install Instructions Section of our website at
1-800-524-9900.
Download from Www.Somanuals.com. All Manuals Search And Download.
Remove (2) screws on lower side
of lower trim panel. The insert
this screw attaches to will be
removed. See later instruction.
Remove two hex screws on each
side of cup holder bracket
Remove (2) hex screw as shown
above. Notice location.
Remove brake control switch from
lower trim panel. This will reinstall
into console. (Equipment bracket
sold separately)
Remove plugs on optional brake
control switch. (If necessary)
Remove lower trim panel
Current view of installation
Remove optional auxiliary
switches from trim panel
Attach upper portion of console to
dash using screws that held top of
lower trim panel
C-VS-0309-F250_INST_4-07
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Remove this screw clip to allow a
¼” bolt to fit into this hole
Attach lower portion of console
using ¼” x 1 ¼” hex bolt, washer
and serrated nut
Complete installation of
C-VS-0309-F250 console
Complete installation of C-VS-0309-F250
console w/ accessories (Sold separately)
-Brake controller/Aux Switching equipment
bracket (C-EB30-F50-1P)
-Mic Clip Bracket (C-MCB w/ C-MC)
-Cup holder (C-CUP2-E-C with additional “L”
bracket # CM93086 )
C-VS-0309-F250_INST_4-07
4
Download from Www.Somanuals.com. All Manuals Search And Download.
|