INSTALL INSTRUCTIONS
C-VS-0812-CHGR & C-VS-0812-CHGR-1
20” VEHICLE SPECIFIC LOW PROFILE CONSOLE
2006-2007 DODGE CHARGER and MAGNUM
2008 DODGE CHARGER and MAGNUM
TOOLS REQUIRED:
Ratcheting wrench
Sockets - 7/16”
Screwdriver set
T-20 torx bit
Combo wrench set
HARDWARE:
ITEM#
QTY DESCRIPTION
PART #
1
2
3
4
5
6
7a
7b
8a
8b
9
1
1
1
1
1
1
1
1
1
1
2
1
8
8
8
6
4
2
2
1
8” console housing
Support bracket for stout console
12” Low profile console (housing only)
Frame support bracket
YAW sensor cover panel
Rear floor filler panel
Driver side wire panel - 2006 – 07 Charger
Driver side trim panel - 2008 Charger
Passenger side wire panel - 2006 – 07 Charger
Passenger side trim panels - 2008 Charger
“L” bracket mounting leg
Extension floor plate
¼-20 Hex nut
¼-20 x ¾” Hex bolt
¼-20 Serrated nut
10-32 x ½” Phillips machine screw
10-32 Keps nut
#10 Flat washer
Torx hardware kits
Mounting hardware kit
CM000672
CM001595
C-SM-1200-H
CM001593
CM001638
CM001642
CM001598-D
CM002165
CM001598-P
CM002164
C-B41
CM93712
GSM30005
GSM33001
GSM30023
GSM33118
GSM30028
GSM31003
C-HK-1
10
C-HK
Download from Www.Somanuals.com. All Manuals Search And Download.
View of trak removed
Remove OEM supplied trak.
Note: Some hardware is re-used
in installation of console
Attach frame support bracket
(#4) to vehicle using 10/32 x ½”
phillips machine screws,
washers, and keps nuts
Attach frame support bracket
(#4) to vehicle using 10/32 x ½”
phillips machine screws,
Attach support bracket for stout
console (#2) to vehicle and to frame
support bracket using OEM hardware
and #10 x ½” phillips machine screws
and washers
Tighten hardware
washers, and keps nuts
Note: Due to some slight differences on the OEM floor mount bracket, tabs with mounting hole may
need to be bent slightly to accommodate the console front support bracket. Bending these tabs can easily
be done using pliers.
View of installation to this point
Note: Be sure OEM wiring is not
being crushed by mounting
brackets
Place console assembly and
install extension (#10) for “L”
bracket mounting leg on stout
Attach “L” bracket mounting
leg (#9) to rear floor filler panel
(#6) using ¼-20 x ¾” hex bolts
console, using OEM hardware.
and serrated nuts.
Download from Www.Somanuals.com. All Manuals Search And Download.
Attach rear floor filler panel (#6)
to vehicle using OEM hardware
Attach YAW sensor cover panel
(#5) to vehicle using front
driver side hardware from rear
floor filler panel (#6)
Attach driver and passenger-
side wire panels (#7 & 8) to
frame support bracket using #10
x ½” phillips machine screws
and washers.
View of installed C-VS-0812-CHGR
Route wiring and install emergency
controls and accessories
C-VS-0812-CHGR_INST_12-07
4
Download from Www.Somanuals.com. All Manuals Search And Download.
|