MODEL H6186
8" IMPACT WRENCH
INSTRUCTION SHEET
3
⁄
EyE/EAR INJURy HAzARD!
Wear safety glasses and
hearing protection when
using this tool!
Valve Knob
INJURy HAzARD!
Always disconnect tool from
air to prevent unexpected
operation during service!
DO NOT EXCEED 120 PSI!
Personal injury could
occur.
Figure 1. Model H6186
SHATTERINg HAzARD!
Use sockets rated for
impact wrench use only.
The impact wrench MuST be regularly lubricated
with 3-4 drops of air tool oil directly into the air fit-
ting before each use. For best results, we recom-
mend using an in line filter, lubricator, and regula-
tor, as shown in Figure 2.
Specifications
Drive Size.........................................................3/8
"
No-Load Speed .................................. 9,500 RPM
Maximum Torque .................................... 190 ft/lb
Air Inlet Size .............................................1⁄4" NPT
Air Consumption..................................... 3.8 CFM
Operating Pressure ................................... 90 PSI
Maximum Operating Pressure................. 120 PSI
Weight ........................................................3.3 lbs
Quick
Quick
Connector
Lubricator
Regulator
Connector
Your
Tool
Air
Compressor
Quick
Coupler
Quick
Coupler
Air Hose
Filter
Operation
3
Install any ⁄8" drive socket into your air impact
Figure 2. Installing your tool.
wrench. To change direction, push the valve
knob, shown in Figure 1, in or out. To adjust the
torue setting, turn the valve knob from 0 to 5.
Connect to air line regulated at 90 PSI.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
COPyRIgHT © MAy, 2008 By gRIzzLy INDuSTRIAL, INC.
WARNINg: NO PORTION OF THIS MANUAL MAy bE REPRODUCED IN ANy SHAPE
OR FORM WITHOUT THE WRITTEN APPROvAL OF gRIzzLy INDUSTRIAL, INC.
#JM10713 PRINTeD IN TAIWAN
Download from Www.Somanuals.com. All Manuals Search And Download.
|