Failure to follow these warnings
and the assembly instructions could
result in serious injury or death.
Please read this Owner’s
Manual completely BEFORE
first use of your monitor! Pay
special attention to the warn-
ings. Keep these instructions
for future reference.
NSuournsdeSlreeyp
This device is designed only to monitor the sounds of your child. It will
not alert you to your child’s silent activities. This product is not
designed or intended for use as a medical monitor. Always be sure that
both the transmitter and receiver are working properly and are within
range of each other.
Monitor
by
Congratulations on your purchase
of a Graco® Nursery Monitor!
OWNER’S
!
!
!
!
!
STRANGULATION HAZARD.
Keep the adapter cords out of the
reach of children. Do not use with
extension cords.
Keep Nursery Monitor away from
heat sources, such as fireplaces,
radiators, stoves, and TVs or other
appliances. Heat can damage the
case or electrical parts.
MANUAL
!
!
!
!
Graco is the recognized leader in the
design and manufacture of quality baby
products. We believe your new Graco
®
!
!
!
!
DO NOT place the Nursery Unit
or its cord within your child’s
reach. Do not put the Nursery
Unit inside a crib or playard.
Nursery Monitor is a wise choice.
!
!
Use ONLY with 110-120 volt AC
electrical outlets.
Before using your Nursery Monitor,
please take a few minutes to read this
Owner’s Manual. The short time you
spend reading these instructions will
help you use your Nursery Monitor
properly.
!
!
!
!
Protect the AC adapter cords.
Place them so they are not walked
on or pinched by furniture or other
items.
!
!
!
!
!
DO NOT OPEN THE TRANSMIT-
TER, RECEIVER OR ADAPTER.
NO USER-SERVICEABLE PARTS
INSIDE. RISK OF ELECTRIC
SHOCK, FIRE OR DEATH.
!
DO NOT use the monitor if:
- The adapter cords or plugs have
Please save your Owner’s
Manual for future use.
!
!
!
!
DO NOT immerse any part of
the Nursery Monitor in water.
Clean only with a dry cloth.
been damaged.
Model No. M-
Channels C-
Serial No. S-
- The unit has been exposed to
!
liquids.
Customer Satisfaction
-
Unit has been dropped or is
damaged inside.
!
!
!
!
!
!
!
DO NOT place unit near water
and moisture. Do not use the
Nursery Unit outdoors. Do not
use the monitor near possibly wet
areas, such as a bathtub, shower,
wash basin, sink, laundry tub,
swimming pool, wet basement, etc.
!
Our goal is to make every product the
best it can be! We are also committed to
supporting our products after purchase. If
you would like to speak with Graco about
your product, please contact our Customer
Service Department at 1-800-345-4109.
Our knowledgeable staff will be ready
to answer any questions you may have
concerning parts, use or maintenance.
When you call, please have the model
and serial numbers ready so your call may
be processed quickly and efficiently.
Dear Customer,
!
!
!
!
!
!
!
!
Allow for proper ventilation when
units are in use. Do not cover the
nursery or parent’s unit with any
object such as a blanket. Do not
place it in a drawer or in any
location which would muffle the
sound or interfere with the normal
flow of air.
Please fill in the model and
serial numbers above from
the label inside the battery
compartment of your new
Nursery Monitor.
Both Parent’s Unit and
Nursery Unit MUST be set
to the same channel for
the system to operate.
FCC ID# M6Y002020049R
M6Y002020049T
© 1998 Graco 901-5-98
2
3
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Installing A Battery
Using AC Adapters
The Parent’s Unit can use either a
Use ONLY the Graco® adapters
included with the unit. Do not use
these adapters with other equipment
under any circumstances.
Battery changing should only be
done by an adult.
battery or standard 120 volt AC
household current. The Nursery
Unit uses standard 120 volt AC
household current only. The included
AC adapters must be used for this
purpose.
The Parent’s Unit can be operated
on battery power.
Push in
at angle
and lift
If units do not work, check that AC
adapters are plugged into working
outlets.
1. Push a key, screwdriver, or other
object at an angle into the side slot
under the AC adapter jack as shown,
and lift up to open the battery
compartment.
To use AC adapters, plug the connec-
tor on the cord into the AC adapter
jack on the side of the unit. Then
plug adapter into a standard wall
outlet.
When electricity is off (from a power
failure, etc.), the transmitter will NOT
work, since it only operates on AC
current.
2. Snap a nine volt battery into
proper terminals. An alkaline battery
is recommended. Place battery into
compartment.
3. Snap battery compartment cover
closed.
BATTERY USE TIPS
Charging of a rechargeable battery
should only be done by an adult.
Remove battery from Parent’s Unit if
it will not be used for a long time.
Remove a dead battery promptly. A
dead battery left in unit may leak,
damaging your unit.
Battery power will be conserved
when Parent’s Unit is powered
through AC adapter. It is not
necessary to remove battery when
using AC adapter.
Do not attempt to recharge a non-
rechargeable battery.
Change battery if:
A rechargeable battery CANNOT be
recharged by plugging AC adapter
into the Parent’s Unit. Remove the
battery from unit to recharge it.
!
Signal reception becomes poor
Static noise develops (also check
!
!
!
for appliance interference)
901-5-98
9
10
11
12
Download from Www.Somanuals.com. All Manuals Search And Download.
System Setup
Solving Problems
Most problems have a simple solution. First, check that:
SETTING UP
TESTING THE UNITS
!
Power is turned ON for both units
Both units are plugged in (or battery is fresh in Parent’s Unit)
Electrical outlet works
Units are set to same channel
THE MONITOR
!
It is VERY IMPORTANT to test the
system when first set up, and at regular
times thereafter. Test the units any time
they may have been damaged or have
not been used for a long time.
!
1. Check that both Nursery Unit
and Parent’s Unit are set to the
same channel.
!
!
Volume is turned up on Parent’s Unit
!
Parent’s Unit is in range of the Nursery Unit
2. Place the Nursery Unit within 10
feet (2-3 meters) of your baby. Plug
an AC adapter into the jack on the
side of the Nursery Unit. Plug it into
a working 120 volt AC outlet.
If necessary, try the following ideas:
1. If two adults are present, have one
take the Parent’s Unit to different
locations, trying various volume
settings, while the other speaks
into the Nursery Unit.
NO SOUND:
Battery dead or weak—replace or use AC adapter.
Channel settings do not match—set both units to same channel.
AC adapter not properly connected—check the connections.
Nursery Unit covered or blocked—remove the obstruction.
3. Aim the Nursery Unit toward
your baby. Check that there are
no walls or large objects that
could block sound transmission.
2. If only one adult is available,
place a ticking clock, radio, or
other sound-producing device
near the Nursery Unit to test it.
WEAK SOUND:
Parent’s Unit too far from Nursery Unit—move closer.
Large objects blocking the signal—try repositioning Nursery Unit.
Check that antennas are vertical and are not touched by other objects.
Volume setting too low—turn it up.
3. When testing, keep the level of
your child’s sounds in mind, and
adjust the volume accordingly.
Do not place the
Nursery Unit or AC adapter cord
within your child’s reach. DO NOT
place Nursery Unit inside a crib or
play yard.
STATIC:
Interference from other electrical equipment—eliminate cause of static
(TVs, mixers, computers, fans, fluorescent lights, light dimmers, etc.)
Parent’s Unit too far from Nursery Unit—move them closer.
Channel settings do not match—set both units to same channel.
Try other channel on both Parent’s Unit and Nursery unit.
4. If there is sound interference,
switch both the Nursery Unit and
the Parent’s Unit to the other
channel setting.
4. Turn on the Nursery Unit using
the ON/OFF switch on the left
side. The red power light should
come on.
NOTE: As with all radio frequency
devices, transmission range and
reception may vary. Your Nursery
Monitor uses public airwaves, so it is
possible for conversations near the
Nursery Unit to be broadcast to other
nursery monitors, radios, cordless
phones or scanners outside your
home. For your privacy, always turn
off the Nursery Unit when not in use.
SHRILL NOISE (FEEDBACK):
Nursery Unit and Parent’s Unit too close together—move them farther apart.
Volume set too high—lower the volume.
5. Install a nine volt battery into the
Parent’s Unit, or plug it into a
working 120 volt AC outlet using
the other AC adapter.
If you cannot solve the problem, please contact our
Customer Service Department at 1-800-345-4109.
6. Turn on the Parent’s Unit using
the volume control dial on the
right side. The red power light
should come on.
Do not attempt to modify the unit. Any modifications to the transmitter and/or
receiver can void the operator’s authority to operate the equipment.
This monitor operates on one or more of the following frequencies:
49.830 Mhz, 49.845 Mhz, 49.860 Mhz, 49.875 Mhz, 49.890 Mhz.
Maximum signal strength is 10 millivolts/meter at 3 meters.
901-5-98
13
14
15
16
Download from Www.Somanuals.com. All Manuals Search And Download.
|