| Sound ‘n Lights Monitor   Model Number 71565   Please read these instructions and keep them for future reference.   Includes two AC adaptors to power the transmitter and receiver.   The receiver also runs on battery power (9v alkaline – not included).   ® Fisher-Price   Download from Www.Somanuals.com. All Manuals Search And Download.   Your Sound ’n Lights Monitor   C 16   6 3 11   17   2 4 19   10   13   14   N O F F O OFF ON   POWER   9 POWER   5 B A B A CHANNEL   CHANNEL   12   ® ce   -Pri   er   ish   F ® Fis   he   r-P   ri   ce   15   7 18   1 8 1 2 Transmitter . . . . . . . . . . . . . . .Sends (transmits) sounds to the receiver.   On/Off Switch . . . . . . . . . . . . .Turns the transmitter power“ON”or“OFF”.   Power Indicator . . . . . . . . . . .Lights up to let you know the transmitter is“ON”.   Microphone . . . . . . . . . . . . . . .For clear audio pick-up.   3 4 5 6 2-Position Channel Switch . . . .Allows you to change channels if interference occurs.   Flexible Antenna . . . . . . . . . . .Aids in sound transmission.   7 AC Adaptor Socket (on side). . .For use with the provided AC adaptor.   8 Receiver . . . . . . . . . . . . . . . . .Receives signal from the transmitter to hear sound.   9 Volume Dial . . . . . . . . . . . . . . .Controls the volume of sound.   10 Power Indicator . . . . . . . . . . . .Lights up to let you know the receiver is“ON”.   11 Moving Lights Display . . . . . . .Shows sounds are being transmitted.   12   Speaker . . . . . . . . . . . . . . . . . .Allows you to hear baby’s sounds.   13 2-Position Channel Switch . . . .Allows you to change channels if interference occurs.   14   AC Adaptor Socket (on side). . .For use with the provided AC adaptor.   15   Battery Compartment Door . . .For easy access to battery compartment.   16 Flexible Antenna . . . . . . . . . . .Aids in sound reception.   17   Belt Clip (on back) . . . . . . . . . .For added portability when moving from room to room.   18 AC Adaptors (2 included) . . . .Both the transmitter and receiver operate on standard household current   (120v AC outlet) with either of these AC adaptors.   19   On/Off Switch . . . . . . . . . . . . .Turns the receiver power“ON”or“OFF”.   3 Download from Www.Somanuals.com. All Manuals Search And Download.   • If a removeable rechargeable battery is used, it is only to   be charged under adult supervision.   • A rechargeable battery is to be removed from the   product before it is charged.   • If you use a battery charger, it should be examined   regularly for damage to the cord, plug, enclosure and   other parts. Do not use a damaged battery charger until   it has been properly repaired.   Battery Installation   D The receiver operates either with the AC adaptor   included with your Sound ’n Lights Monitor   or with a 9 volt alkaline battery.   9V   (LR6)   Set-Up and Use   E Shown Actual Size   IMPORTANT NOTE! To prevent entanglement, never   place the transmitter in a crib or playpen. Place the   transmitter, receiver and AC adaptor cord(s) out of   baby’s reach.   Battery Compartment Door   Antenna   On/Off Switch   Channel Switch   Power   Indicator   AC Adaptor Jack   ON   OFF   ER   W PO   B A L NE   AN   CH   Finger   Tab   ® e ic   r r-P   e h is   F • Locate the battery compartment door on the bottom of   the receiver.   • Push the finger tab on the battery compartment door to   open the battery compartment door.   Socket   AC Adaptor   Plug   • Snap the terminals of a fresh 9v alkaline battery into the   connectors.   Transmitter   • Close the battery compartment.   Please Note:   • Remove the battery during long periods of non-use.   Always remove an exhausted battery from the product.   Battery leakage and corrosion can damage the product.   • Never short circuit the battery terminals.   • A non-rechargable battery is not to be recharged.   • Place the transmitter in the same room with your child.   For best sound pick-up, point the microphone directly   toward the crib or play area. Make sure the antenna   points upward for best transmission.   • For best transmission, unwrap and fully extend the   AC adaptor cord. Insert the AC adaptor jack into the   transmitter socket.   • Insert the plug into a standard wall outlet.   • Set the transmitter channel switch to the same channel   as the receiver.   • Only a battery of the same or equivalent type as   recommended in the“Battery Installation”instructions is   to be used.   • Slide the on/off switch on the front of the transmitter to   the“ON”position.The power indicator will light.   4 Download from Www.Somanuals.com. All Manuals Search And Download.   • If you will be using the AC adaptor to power the   receiver, unwrap and fully extend the AC adaptor cord   for best reception. Insert the AC adaptor jack into the   side of the receiver.   Antenna   • Insert the plug into a standard wall outlet.   • Check to be sure the channel switch on the receiver is   set to the same channel as the transmitter.   • Slide the on/off switch on the front of the receiver to   the“ON”position. The power indicator will light.   • Adjust the volume by turning the volume dial to a   comfortable level.   Moving Light Display   Power Indicator   On/Off Switch   Channel Switch   AC Adaptor Jack   OFF ON   POWER   A B CHANNEL   Volume Dial   • The moving light display will light when sound is   received by the receiver.   • If all five bars in the moving light display light:   ® e ric   r-P   he   Fis   – The receiver power is“ON”and the transmitter power   is“OFF”. (Turn the transmitter power“ON”.)   Plug   AC Adaptor   – The receiver is out of range of the transmitter. (Move   the receiver closer to the transmitter.)   – The receiver and the transmitter are not on the same   channel. (Set the channel switches on the transmitter   and receiver to the same channel.)   Receiver   AC Adaptor Use   – Loud sounds are transmitting.   Please Note:The moving light display will not light if the   battery is weak, even though you may still hear sounds.   Replace the battery with a fresh, 9v alkaline battery.   Antenna   • To protect your privacy, be sure to turn the transmitter   and receiver“OFF”when not in use.   Moving Light Display   On/Off Switch   Channel Switch   Power Indicator   Volume Dial   OFF ON   POWER   A B CHANNEL   ® Fis   he   r-P   ric   e Receiver   Battery Use   • Decide whether you will use the AC adaptor or a   9v alkaline battery to power the receiver. If you will be   using the receiver near an outlet, we recommend using   the AC adaptor.   • Place the receiver where you can hear/see it. Or, wear   the receiver using the convenient belt clip. Make sure   the antenna points upward for best reception.   5 Download from Www.Somanuals.com. All Manuals Search And Download.   One (1) Year   Sound Reception   F I Limited Warranty   It is very important to test the sound   reception of the Sound ’n Lights Monitor before   first-time use and whenever you change the   location of the transmitter.   Fisher-Price, Inc., 636 Girard Avenue, East Aurora,   New York 14052, warrants that the Sound ’n Lights   Monitor is free from all defects in material and workman-   ship when used under normal conditions for a period of   one (1) year from the date of purchase.   • Test the Sound ’n Lights Monitor transmission and   reception. In the room you intend to use the transmit-   ter, have an adult speak into the transmitter. (If an adult   is not available,use a ticking clock or radio.) Place the   receiver in the room in which you intend to use the   receiver. Adjust the receiver location or volume dial   until you hear sounds clearly.   • If you experience interference (buzzing, static, etc.)   while using one channel setting, switch both units to   the other channel. Selecting a channel is usually a   one-time adjustment.   Should the product fail to perform properly, we will   repair or replace it, free of charge. Purchaser is respon-   sible for shipping the product to the address indicated   above and for all associated freight and/or insurance cost.   Fisher-Price, Inc. will bear the cost of shipping the   repaired or replaced item to you.This warranty is void if   the owner repairs or modifies the product.This warranty   excludes any other liability other than the above   mentioned, including but not limited to any incidental   or consequential damages.   • If interference occurs on both channels or if further   problems develop, please refer to the“Problems and   Solutions Guide”beginning on page 7.   SOME STATES DO NOT ALLOW THE EXCLUSION OR   LIMITATION OF INCIDENTAL OR CONSEQUENTIAL   DAMAGES, SO THE ABOVE LIMITATION OR EXCLU-   SION MAY NOT APPLY TO YOU.   Care   THIS WARRANTY GIVES YOU SPECIFIC LEGAL   RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS   WHICH VARY FROM STATE TO STATE.   G • Keep the Sound ’n Lights Monitor free from dust.   Important Note:The electronic components in the   Sound’n Lights Monitor are not designed for consumer   repair. Evidence of any attempt at consumer repair will   void the warranty. Return the AC adaptors, transmitter and   receiver (please remove the battery from the receiver   before sending to Fisher-Price, Inc. for service).   • The outer surface of the transmitter and receiver can be   cleaned with a cloth lightly dampened with a mild   cleaning solution.   • Do not immerse any part of the Sound ’n Lights Monitor.   FCC Note   H (United States only)   Sound ’n Lights Monitor   Model Number: 1565   This device complies with Part 15 of the FCC Rules.   Operation is subject to the following two conditions:   (1) This device may not cause harmful interference and   (2) This device must accept any interference received,   including interference that may cause undesired   operation.   Fisher-Price, Inc.   Consumer Affairs Department   636 Girard Avenue   East Aurora, New York 14052   6 Download from Www.Somanuals.com. All Manuals Search And Download.   Problems and Solutions Guide   J IMPORTANT! If you have a problem with the Sound ’n Lights Monitor, first check the Problems and   Solutions Guide below. If you still experience a problem with the Sound ’n Lights Monitor, call Fisher-Price   Consumer Affairs, toll-free at 1-800-432-KIDS, 8 AM - 6 PM EST Monday through Friday.   Hearing-impaired consumers using TTY/TDD equipment,   ® ® please call 1-800-382-7470. Or, write to: Fisher-Price Consumer Affairs,   636 Girard Avenue, East Aurora, New York 14052.   PROBLEM   PROBABLE CAUSE   Transmitter not turned“ON”   Power is turned“OFF”   SOLUTION   Transmitter power   indicator does not light   Turn the transmitter“ON”.   Make sure that any light switches that control power flow to   the wall outlet are“ON”.   Make sure house fuses and circuit breakers are“ON”.   AC adaptor not properly connected   AC adaptor problem   Check AC adaptor jack-to-socket and plug-to-outlet connections.   Test the transmitter using the other AC adaptor included with this   product. If the transmitter works with the other AC adaptor, call   Fisher-Price® at 1-800-432-KIDS to replace the broken AC adaptor.   Receiver power   indicator does not light   Receiver not turned“ON”   Power is turned“OFF”   Turn the receiver“ON”.   Make sure that any light switches that control power flow to the   wall outlet are“ON”.   Make sure house fuses and circuit breakers are“ON”.   AC adaptor not properly connected   AC adaptor problem   Check AC adaptor jack-to-socket and plug-to-outlet connections.   Test the receiver using the other AC adaptor included with this   product. If the receiver works with the other AC adaptor, call   Fisher-Price® at 1-800-432-KIDS to replace the broken AC adaptor.   Weak or dead battery   Replace the battery in the receiver with a fresh 9v alkaline   battery or use the AC adaptor.   No sound   Channel switches not on same setting   Set channel switch on transmitter and receiver to the same   channel.   Signal interference due to other nursery   monitors, cordless telephones, etc.   Change the channel setting on both the transmitter and the   receiver.   Identify and eliminate the source of interference.   Test reception by moving the transmitter and/or receiver to   different locations throughout the house. Relocate the   transmitter and/or receiver.   Out of range or insufficient signal   Test reception by moving the transmitter and/or receiver to   different locations throughout the house. Relocate the   transmitter and/or receiver.   Volume not turned up   Adjust volume control on receiver.   Improper antenna position   Make sure the antenna on the transmitter and receiver are   pointing upward.   Weak or dead battery in receiver   AC adaptor not properly connected   Replace the battery in the receiver with a fresh 9v alkaline   battery or use the AC adaptor.   Check AC adaptor jack-to-socket and plug-to-outlet connections.   7 Download from Www.Somanuals.com. All Manuals Search And Download.   PROBLEM   PROBABLE CAUSE   SOLUTION   Weak reception   Out of range or insufficient signal   Test reception by moving the transmitter and/or receiver to   different locations throughout the house. Relocate the transmitter   and/or receiver.   AC adaptor cord(s) not fully extended   Improper antenna position   Fully extend AC adaptor cord(s).   Make sure antennas are pointing upward.   Receiver moving light   display does not light   Weak or dead battery in receiver   Replace the battery in the receiver with a fresh 9v alkaline   battery or use the AC adaptor.   Interference   (buzzing, static, etc.)   Signal interference due to other   nursery monitors or cordless   telephones, etc.   Change channel switch on both transmitter and receiver to the   other channel.   Identify and eliminate source of interference. Do not use more   than one receiver or transmitter at the same time in the same   house.   Channel switches not on   same setting   Check channel switch on transmitter and receiver to be sure   they are on the same channel.   Feedback   (squealing or whistling)   Receiver is too close to the   transmitter   Move receiver further away from transmitter.   Volume is set too high   Lower volume on the receiver.   All five bars on the   receiver moving light   display light   Receiver power is“ON”but   transmitter power is“OFF”   Turn the transmitter power“ON”.   Out of range or insufficient signal   Move the receiver closer to the transmitter.   Channel switches not on same   setting   Check channel switches on transmitter and receiver to be sure   they are on the same channel.   AC adaptor not properly connected   to transmitter   Check AC adaptor jack-to-socket and plug-to-outlet connections.   If you have any questions about this product:   In Canada, call 1-800-567-7724, or write to:   Mattel/Fisher-Price, 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2.   In Great Britain, telephone 01734 770488.   In Australia, call the Fisher-Price Australian Consumer Advisory Service toll-free at 1-800-800-812, or write to:   Fisher-Price, Mattel Pty. Limited, 461 Plummer Street, Port Melbourne,Victoria 3207.   8 Download from Www.Somanuals.com. All Manuals Search And Download.   |