EverFocus Security Camera EFD300 User Manual

EVERFOCUS  
1/3” 520TVL Color Flush Dome Camera  
Operation Instructions  
Model No. EFD300  
Please read this manual first for correct installation and operation. This manual should be retained  
for future reference. The information in this manual was current when published. The  
manufacturer reserves the right to revise and improve its products. All specifications are therefore  
subject to change without notice.  
PRECAUTIONS  
1. Do not install the camera near electric or magnetic fields.  
Install the camera away from TV, radio transmitter, magnet, electric motor, transformer,  
audio speakers since the magnetic fields generate from above devices will distort the video  
images.  
2. Never disassemble the camera nor put impurities in it.  
Disassembly or impurities may result in trouble or fire.  
3. Never face the camera toward the sun.  
Direct sunlight or severe ray may cause fatal damage to sensor and internal circuit.  
4. Keep the power cord away from water and liquid.  
Touching the wet power cord may result in electric shock.  
5. Never install the camera in areas exposed to water, oil or gas.  
Water, oil or gas may result in failure, electric shock or fire.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
SPECIFICATIONS  
Pickup Device  
Video Format  
1/3'' SONY Super HAD CCD  
NTSC or PAL  
NTSC: 525 TV lines, 60 fields/sec  
PAL: 625 TV lines, 50 fields/sec.  
Scanning System  
Picture Elements  
Horizontal Resolution  
Sensitivity  
768x494(NTSC) ; 752x582(PAL)  
520TVL  
0.1Lux/F=1.2  
S/N Ratio  
Over 48dB (AGC off)  
1/50(1/60)~1/100,000  
Vari-focal lens, Auto Iris  
f=4~9mm  
Electronic Shutter  
Lens Type  
Auto Gain Control  
Flickerless  
ON/OFF Switch  
ON/OFF Switch  
ON/OFF Switch  
Yes  
Back Light Comp.  
Auto White Balance  
Gamma Correction  
0.45  
2 video outputs  
Video Output  
BNC 1.0Vp-p, 75ohm  
Additional testing video output 1.0Vp-p, 75ohm  
Sync. Mode  
Vandal Proof  
Power Source  
Internal sync  
Yes  
12VDC/24VAC  
12VDC: 2W max.  
Power Consumption  
Dimensions  
24VAC: 1.5W max.  
135mm(O.D.) x 112mm(H);  
5.4"(O.D.) x 4.4"(H)  
Weight  
0.7kg ; 1.6lbs  
0°C~50°C ; 32°F~122°F (20%~80% Humidity)  
FCC/CE  
Operating Temperature  
Certifications  
STANDARD ACCESSORIES  
¾
¾
¾
Camera Unit  
Operation Instructions (this document)  
Drill Template  
2
Download from Www.Somanuals.com. All Manuals Search And Download.  
OPTIONALACCESSORIES  
EN220 - 5.6-inch High Res LCD Field Monitor  
DIMENSION DIAGRAM  
55mm/2.17”  
55mm/2.17”  
45mm/1.77”  
90mm/3.54”  
120mm/4.72”  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
HARDWARE OVERVIEW  
1
2
3
1. Camera Bubble Cover  
2. Camera Setting- Please refer detail in camera setting for user manual.  
3. BNC and Power Pigtail  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
INSTALLATION  
This section covers simple steps and detail installation. Please follow instruction for preventing  
any unnecessary damage.  
Simple Steps:  
1. Cut a circle on the ceiling and mount the camera  
2. Adjust lens, camera position  
3. Adjust camera setting on Dip Switch  
Detail Steps:  
1. Cut a circle on the ceiling and mount the camera  
a. Make a hole on the ceiling (110mm/4.33”φ) against the housing’s shape by using Drill  
Template in the package.  
b. Mount camera into the hole that you just made.  
c. Connect Power and Video - Please connect 12VDC or 24VAC. Wrong power connection will  
cause power failure and shortage.  
d. Screw the bolts on both sides of housing by using a screwdriver until they are perfectly fit to  
the ceiling.  
e. Place the cover back and clip it on the camera.  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
2. Adjust lens, camera position  
a. Optional connecting to testing monitor- You can connect to testing monitor with video  
pin shown as following.  
Monitor Testing Pin  
b. Zoom and focus (for Vari-focal Lens Model)  
(1) Loosen the zoom ring knob, and then turn the ring towards <W> or <T> as necessary to obtain  
the desired view range.  
W side (Zoom out), the viewing range will be wider and the subject is smaller.  
T side (Zoom in), the viewing range will be smaller and the subject is larger.  
(2) Loosen the focus ring knob, then turn the ring towards <> or <N> as necessary to obtain  
clear video image.  
(3) Repeat steps 1 and 2 until the best image is obtained.  
Once the lens setting is finished, tighten the zoom ring and the focus ring knobs.  
c. Adjust View Angle  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
You can lose the camera fixing screw and tilt the camera to your best angle of view.  
Tilt  
Camera Fixing Screws  
3. Camera Setting  
CAMERA SETTING  
¾ BLC (Back Light Compensation)  
When BLC is turned on, the AGC, FL and IRIS operating point is determined by averaging over  
the center area instead of entire field-of-view, so that a dimly-lit foreground object at center area  
can be clearly distinguished from brightly-lit backgrounds. BLC should not be used unless it is  
needed to compensate for back-light.  
The default setting is OFF. For Auto-Iris lens model, the brightness can also be adjusted via the  
Iris level control VR.  
¾ AGC (Automatic Gain Control)  
AGC ON: The sensitivity increases automatically when light is low.  
AGC OFF: A-low-noise picture is obtained under a low light condition.  
The default setting is ON.  
¾ FL (Flickerless)  
When picture flicker fiercely, turn FL on, then the camera will stabilize the speed of electronic  
shutter at 1/100(S)(NTSC) or 1/120(S)(PAL) automatically, and reduce the flicker immediately.  
The default setting is OFF.  
¾IRIS Level Control (For Vari-Focal Lens Model)  
Brightness Level can be adjusted from the IRIS level VR while using the direct drive lens.  
•Turn counterclockwise to L to get darker picture.  
•Turn clockwise to H to get brighter picture.¾Electronic Shutter (For Fixed Lens Model)  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
ES ON: The camera continuously adjusts the shutter speed from 1/60 (NTSC), 1/50 (PAL) second  
to 1/100,000 second according to the luminance conditions of the scene.  
ES OFF: The shutter speed is fixed at 1/60 (NTSC),1/50 (PAL) second.  
Set ES OFF, when auto iris lens is used or flicker is observed under a very bright fluorescent lamp.  
Otherwise, turn ES on for optimum performance.  
8
Download from Www.Somanuals.com. All Manuals Search And Download.  
EverFocus Electronics Corp.  
Europe Office:  
Head Office:  
Albert-Einstein-Strasse 1  
D-46446 Emmerich, Germany  
TEL: 49-2822-9394-0  
12F, No.79 Sec. 1 Shin-Tai Wu Road,  
Hsi-Chih, Taipei, Taiwan  
TEL: +886-2-26982334  
FAX: +886-2-26982380  
China Office:  
Room B-05D-1, KESHI PLAZA , Shangdi  
USA L.A. Office:  
Information Industry Base,  
Haidian District, Beijing China 100085  
TEL: +86-10-62973336/37/38/39  
1801 Highland Ave. Unit A  
Duarte, CA 91010, U.S.A.  
TEL: +1-626-844-8888  
FAX: +1-626-844-8838  
FAX: +86-10-62971423  
Japan Office:  
USA N.Y. Office:  
1809 WBG MARIBU East 18F,  
2-6 Nakase.Mihama-ku.  
Chiba city 261-7118, Japan  
TEL: +81-43-212-8188  
FAX: +81-43-297-0081  
415 Oser Avenue Unit S  
Hauppauge, NY 11788  
TEL: 631-436-5070  
FAX: 631-436-5027  
Your EverFocus product is designed and  
manufactured with high quality materials and  
components which can be recycled and  
reused.  
Ihr EverFocus Produkt wurde entwickelt und  
hergestellt mit qualitativ hochwertigen  
Materialien und Komponenten, die recycelt  
und wieder verwendet werden können.  
Dieses Symbol bedeutet, dass elektrische und  
elektronische Geräte am Ende ihrer  
Nutzungsdauer vom Hausmüll getrennt  
entsorgt werden sollen.  
This symbol means that electrical and  
electronic equipment, at their end-of-life,  
should be disposed of separately from your  
household waste.  
Please, dispose of this equipment at your  
local community waste collection/recycling  
centre.  
Bitte entsorgen Sie dieses Gerät bei Ihrer  
örtlichen kommunalen Sammelstelle oder im  
Recycling Centre.  
Helfen Sie uns bitte, die Umwelt zu erhalten, in  
der wir leben!  
In the European Union there are separate  
collection systems for used electrical and  
electronic product.  
Please, help us to conserve the environment  
we live in!  
P/N: MEFDG00400  
9
Download from Www.Somanuals.com. All Manuals Search And Download.  

Eiki Projector LC 120 User Manual
EverFocus Security Camera EDN800 User Manual
Exido Styling Iron 235 020 User Manual
Fisher Price Camper B0655 User Manual
Freedom9 Network Card X10P User Manual
Frymaster Fryer UHC P 2 User Manual
FujiFilm Camera Lens XT1745BRM K14 User Manual
Fujitsu Air Conditioner AOU18CXQ User Manual
GE Headphones 98971 User Manual
GM Automobile 2006 Corvette User Manual