| 	
		 ® 
					Undercounter Dishwasher   
					PRODUCT MODEL NUMBERS   
					OVERALL DIMENSIONS   
					TUD8700R   
					TUD8700S   
					TUD8750R   
					TUD8750S   
					25-1/4" (64.1 cm)   
					3/4" (1.9 cm)   
					insulation – may be   
					compressed (not used   
					on all models)   
					23-7/8"   
					(60.6 cm)   
					24-1/2"   
					(62.2 cm)   
					Electrical: 120-volt, 60-Hz, AC-only, 15- or   
					20-amp. electrical supply. Use copper wire only. A   
					time-delay fuse or circuit breaker and separate   
					circuit is recommended.   
					Water: A hot water line with 20-120 psi   
					(138-862 kPa) water pressure. Water temperature   
					must be 120°F (49°C) at dishwasher. Use 3/8" O.D.   
					copper tubing with compression fitting or flexible   
					stainless steel braided fill line (1/2" minimum plastic   
					tubing is optional but not recommended). Use a 90°   
					elbow with 3/8" N.P.T. external pipe threads on one   
					end to connect to water inlet valve. Do not solder   
					within 6" (15.2 cm) from water inlet valve.   
					33-7/8"   
					(86 cm) min. with   
					wheels removed   
					21" (53.3 cm)   
					Side view   
					Drain: Use the new drain hose supplied with your   
					dishwasher. If this is not suitable, use a new drain   
					hose with a maximum length of 12 feet (3.7 m)   
					that meets all current AHAM/IAPMO test   
					standards, is resistant to heat and detergent, and   
					fits the drain connector of the dishwasher. Must   
					have a high drain loop 20 inches (50.8 cm) above   
					the subfloor or floor. Connect drain hose to waste   
					tee or disposer inlet above drain trap in house   
					plumbing and 20 inches (50.8 cm) minimum   
					above the floor. An air gap must be used if the   
					drain hose is connected to house plumbing lower   
					than 20 inches (50.8 cm) above subfloor or floor.   
					Use 1/2" minimum I.D. drain line fittings.   
					Rear view   
					CABINET OPENING DIMENSIONS   
					24" (61 cm)**   
					All surfaces must be free   
					from intrusions   
					2-1/2"   
					34"   
					(86.4 cm)   
					min.*   
					(6.4 cm)‡   
					6-3/4"   
					(17.2 cm)‡   
					24"   
					(61 cm)   
					min.   
					10-1/2"   
					(26.7 cm)   
					1-3/4"   
					(4.4 cm)‡   
					3"   
					(7.6 cm)‡   
					6-1/4"   
					(15.9 cm)***   
					2"   
					4"   
					(5.1 cm)‡   
					(10.2 cm)‡   
					3"   
					6-1/4"   
					(15.9 cm)‡***   
					(7.6 cm)‡   
					2"   
					(5.1 cm)   
					9"   
					(22.9 cm)   
					10"   
					(25.4 cm)   
					1-3/4"   
					4-1/4"   
					(4.4 cm)‡ (10.8 cm)‡   
					clear area‡   
					Cut holes in shaded area of cabinet walls or floor as specified below:   
					water line – 1/2" (1.3 cm)   
					drain line – 1-1/2" (3.8 cm)   
					direct wire – 3/4" (1.9 cm)   
					power supply cord – 1-1/2" (3.8 cm)   
					* Measured from the lowest point on the underside of countertop. May be   
					reduced to 33-7/8" (86 cm) by removing wheels from dishwasher.   
					** Minimum, measured from narrowest point of opening.   
					*** May be increased to 6-7/8" (17.5 cm) if height of opening is 34-1/2" (87.6 cm)   
					at its lowest point.   
					‡ Both sides   
					Because Whirlpool Corporation policy includes a continuous commitment to improve   
					our products, we reserve the right to change materials and specifications without notice.   
					Dimensions are for planning purposes only. For complete details, see Installation   
					Instructions packed with product. Specifications subject to change without notice.   
					Ref. 8575348   
					01-15-07   
					Download from Www.Somanuals.com. All Manuals Search And Download.   
				 |