Edelbrock Automobile Parts 1727 User Manual

EDELBROCK FUEL PRESSURE REGULATOR  
Part #1727  
®
INSTALLATION INSTRUCTIONS  
PLEASE study these instructions completely and thoroughly before installing your new Edelbrock Fuel Pressure Regulator. If you have any questions  
or problems, contact our Technical Hotline at: 1-800-416-8628, 7 am - 5 pm Monday-Friday, Pacific Standard Time.  
CAUTION!  
Installation of this product should be performed by those persons knowledgeable in the repair and modification of automotive fuel systems. Do not  
loosen fuel system connections until relieving pressure as recommended in your automotive service manual. Fuel leakage will occur when  
loosening fuel system connections, eliminate potential fire hazards before loosening any fuel system connections.  
1. With the ignition “off” and engine cool, relieve the fuel system pressure.  
2. Remove the fuel line, carburetor side.  
3. Determine the new regulator mounting location. Replace existing fuel lines as necessary for proper fitment. Mark and drill mounting bracket  
holes using the bracket as a template.  
5. Install the fittings (Fuel fittings NOT included) as shown below. Coat the threads of the fitting with thread sealer (not supplied).  
6. Assemble the bracket and regulator.  
7. Install the regulator and bracket assembly in the desired location.  
8. Connect and tighten fuel lines to the inlet and outlet, as seen below.  
9. Install the plug (supplied) or connect a fuel pressure gauge to the gauge port using a 1/8-27 NPT male thread and thread sealer (not supplied).  
10. Check for leaks: Start engine and check all connections for leaks. If any leaks exist, immediately turn key off and repair before continuing.  
11. Start the engine, loosen the jam nut on the top of the regulator, and turn the adjusting screw until the desired fuel pressure is obtained. Tighten  
the jam nut and re-check the pressure.  
Fittings Shown:  
Russell -6AN to 3/8” NPT Adapter  
Part # 660460 (Qty. 3)  
*NOTE: Thread adjusting  
Adjusting Screw*  
screw down (clockwise)  
to increase fuel pressure;  
thread adjusting screw  
up (counter-clockwise) to  
decrease fuel pressure.  
Gauge Port  
or Plug  
Mounting  
Bracket  
Fuel Out  
3/8” NPT  
Fuel Out  
3/8” NPT  
Fuel In  
3/8” NPT  
Russell fitting  
#660460 shown  
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503  
Tech-Line: (800) 416-8628  
Part #1727  
Brochure #63-0168  
© 2009 Edelbrock Corporation  
Rev. 7/09 - AJ/mc  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Cub Cadet Lawn Mower Ex32002 User Manual
Cuisinart Beverage Dispenser CWC 900 User Manual
Cuisinart Wok WOK 730 User Manual
Curtis Portable Speaker iP217UK User Manual
Desa Staple Gun 31100 User Manual
Extron electronic Network Card MAAP100 User Manual
Fellowes Paper Shredder P500 2 User Manual
Fender Guitar Artist Series User Manual
Fisher Paykel Gas Heater OR24SDMBGX User Manual
Geemarc Telephone CL330 User Manual