Edelbrock Automobile Parts 15010 User Manual

OIL SUPPLY ADAPTER  
For Honda/Acura B-Series and D-Series Engines  
Catalog #15010  
®
INSTALLATION INSTRUCTIONS  
PLEASE study these instructions carefully before beginning this installation. Most installations can be accomplished with common tools and  
procedures. However, you should be familiar with and comfortable working on your vehicle. If you do not feel comfortable performing this installation,  
it is recommended to have the installation completed by a qualified mechanic. If you have any questions, please call our Technical Hotline at:  
1-800-416-8628, 7:00 am - 5:00 pm, Pacific Standard Time, Monday through Friday or e-mail us at [email protected].  
IMPORTANT NOTE: Proper installation is the responsibility of the installer. Improper installation  
will void your warranty and may result in poor performance and engine or vehicle damage.  
DESCRIPTION: Designed for Honda/Acura B-Series and D-Series engines equipped with or without a factory water-cooled oil cooler, this kit can  
supply oil for a VTEC conversion or for a turbocharger. The adapter also includes a port for an oil pressure gauge. The adapter fits directly between  
the engine block, or factory oil cooler, and the stock oil filter.  
KIT CONTENTS:  
1 Oil Supply Sandwich Adapter Assembly  
INSTALLATION PROCEDURE  
1. Remove the stock oil filter (replace with a new filter).  
2. Install the Oil Supply Sandwich Adapter in place of the stock oil filter.  
3. Make sure the O-Ring is facing toward the engine block, and the threaded stud with ½” hex opening is facing out (See Fig. 1).  
4. Although it is a tight fit, the aluminum housing and the threaded center stud will turn independently of each other. Start the assembly onto the  
engine by hand at first. Then, while holding the outer housing in position, tighten the threaded center with a ½” Allen wrench. Make sure to  
position the -6 AN (blue) fitting so that it is facing toward the driver’s side, pointing upward slightly (about the 10 o’clock position) (See Fig. 1).  
5. Install a new oil filter.  
6. Attach an appropriate supply line for the accessory requiring an oil supply. A supply line can be attached using a -6AN (female) fitting. You may  
also attach an oil pressure gauge line to the 1/8 NPT port on the Oil Supply Adapter by removing the 1/8 NPT plug, and installing your gauge  
fitting.  
-6AN Fitting  
Tighten Using  
1/2” Allen  
Wrench  
1/8 NPT Plug  
(Not Visible)  
Fig. 1  
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503  
Tech Line: 1-800-416-8628 • E-Mail: [email protected]  
Catalog #15010  
Rev. 11/06 - RS/mc  
©2006 Edelbrock Corporation  
Brochure #63-0250  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Cradlepoint Network Router IBR650 User Manual
Craftsman Tiller 917295651 User Manual
Curtis MP3 Player MPK7836UKA User Manual
Dual Speaker LU43P User Manual
Dynacord Stereo Amplifier Professional Power Amplifiers User Manual
Dynex Power Supply DX 800U User Manual
Electro Voice Portable Speaker EVX 180A User Manual
Euro Pro Blender EP585 User Manual
GE Drill DBLR333 User Manual
Generac Power Systems Portable Generator 00802 3 User Manual