Cooper Lighting Work Light IMI 6950 User Manual

EPL Envoy  
Task Light Field Installation Kit  
Sheet 1 of 3  
INSTALLATION INSTRUCTIONS  
4/7/08  
IMI-695D  
IMPORTANT : READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN FOR FUTURE REFERENCE  
GENERAL: Upon receipt of luminaire thoroughly inspect for any freight  
WARNING: Make certain power is OFF before starting installation or  
attempting any maintenance.  
WARNING: Risk of Electric Shock. Disconnect power at fuse or circuit  
breaker before installing or servicing.  
WARNING: Risk of Burn. Disconnect power and allow luminaire to cool  
before changing lamp or handling luminaire.  
WARNING: RISK OF FIRE! DO NOT mount on or near combustible  
materials.  
damage, which should be brought to the attention of the delivery  
carrier. Compare the catalog description listed on the packing slip  
with the luminaire label on the housing to assure you have received the  
correct merchandise.  
SAFETY: This luminaire must be wired in accordance with the national  
electrical code and applicable codes and ordinance. Proper grounding  
is required to insure personal safety. Carefully observe grounding  
procedure. All work should be done by a qualified electrician.  
FAILURE TO FOLLOW INSTRUCTIONS MAY RESULT IN SERIOUS INJURY OR  
DEATH  
Figure 1  
TAMPER-PROOF  
SCREW FOR LATCH  
TASK LIGHT FIELD KIT INSTALLATION: (Figure 1)  
1. Note: Remove tamper proof screws first if luminaire includes (TR)  
tamper-resistant option. (Figure 1).  
TAMPER-PROOF  
SCREW FOR HANDLE  
2. To release clasp lock on “quick mount” bracket, push handle inward and  
pull luminaire forward. (Figure 2). CAUTION: Do not let luminaire fall.  
Support luminaire while lowering off of j-box to resting/hanging position.  
3. Remove luminaire hanging hook from quick mount plate (Figure 3 & 4).  
CAUTION: Support luminaire while removing.  
LATCH  
CAUTION: DO NOT place luminaire directly with lens facing down; it may  
scratch or cause the lens to break. Place fixture with lens facing upright on  
stable work surface. SUGGESTION: Remove the lens completely in order to  
perform remaining of Task Light accessory installation.  
Unlatch both latches. CAUTION: To avoid lens breakage, remove lens  
retainer if necessary (Figure 5). Remove the complete lens assembly and  
set aside to prevent damage. Take off upper reflector by loosening  
thumbscrews (See figure 6).  
Figure 2  
TO REMOVE  
HANDLE  
4. Reference dimensions as shown and mark housing if necessary  
(Figure 7 & 8).  
5. Line up an adapter block and secure tightly if possible to aid in drilling  
(Figure 7 & 8).  
CAUTION: DO NOT drill or damage other components inside luminaire. To  
avoid this from happening, remove them if necessary.  
6. Drill center hole as specified and de-burr if necessary to remove sharp  
edges (Figure 7 & 8).  
Figure 3  
QUICK MOUNT  
PLATE  
7. Drill and tap the two outside holes as specified (Figure 7 & 8).  
8. Install gasket and adapter block (with provided fasteners) (Figure 9).  
9. Apply sealing compound on the threads of handle (provided by others).  
10. Pull wires out of head through access in block. Screw the handle into  
adapter block. On inside of fixture, make connections and restrain with  
wire tie.  
HANGING  
HOOK  
11. Aim the handle to a preferred position and lock it in position.  
12. Aim task light head to a preferred position and tighten #10-24 Allen head  
screw (with provided Allen wrench).  
LUMINAIRE  
13. To install lamp, remove task light cover by twisting counter-clockwise and  
pulling out (Figure 9). CAUTION: Verify that lamp source and wattage  
correspond with the luminaire label.  
14. Re-install task light cover by pushing in and rotating clockwise (Figure 9).  
These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible contingency during installation,  
operation or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user’s purpose, please contact your nearest representative.  
NOTE: Specifications and dimensions subject to change without notice.  
Customer First Center 1121 Highway 74 South Peachtree City, GA 30269 770.486.4800 FAX 770.486.4801 ADH080775  
Download from Www.Somanuals.com. All Manuals Search And Download.  
EPL Envoy  
Parking Luminaire  
Sheet 3 of 3  
INSTALLATION INSTRUCTIONS  
4/7/08  
IMI-695D  
IMPORTANT : READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN FOR FUTURE REFERENCE  
Figure 7  
Figure 9  
ADAPTER  
BLOCK  
HANDLE  
(APPLY SEALING  
COMPOUND BY OTHERS)  
.25-.375”  
HOLE  
ADAPTER  
BLOCK  
GASKET  
TASK LIGHT  
HEAD  
DRILL/TAP  
#10-24  
DRILL/TAP  
#10-24  
.25  
10-24  
10-24  
SCREW  
ALLEN HEAD  
TASK LIGHT  
COVER  
LATCH  
LOCATION  
LOCKNUT  
LINE UP ADPATER  
BLOCK HERE  
1.75  
Figure 8  
.25-.375”  
HOLE  
ADAPTER  
BLOCK  
DRILL/TAP  
#10-24  
DRILL/TAP  
#10-24  
.25  
(0,0)  
LINE UP ADPATER  
BLOCK HERE  
LATCH  
LOCATION  
1.75  
INDICATE UP  
POSITION  
These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible contingency during installation,  
operation or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user’s purpose, please contact your nearest representative.  
NOTE: Specifications and dimensions subject to change without notice.  
Customer First Center 1121 Highway 74 South Peachtree City, GA 30269 770.486.4800 FAX 770.486.4801 ADH080775  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Crate Amplifiers Stereo Amplifier G200C User Manual
Curtis Cordless Telephone TC924 User Manual
Dynex Computer Keyboard DX CKB102 User Manual
Edelbrock Automobile Parts 1565 User Manual
Everpure Water System CGS 23 User Manual
Fender Musical Instrument Amplifier P N 048502 User Manual
Fitness Quest Home Gym 386da User Manual
Foster Refrigerator RBC20 60 User Manual
GBC Laminator H410 User Manual
Global Machinery Company Saw TTS5000M User Manual