Cisco Systems Network Card Modular Gigabit Ethernet Line Card I User Manual |
Inserting an EPA into a Modular Gigabit Ethernet
Line Card
December 16, 2005
Document Part Number: 78-17296-01 A0
To insert an EPA into the Modular Gigabit Ethernet line card, follow these steps:
Warning
Step 1
You must use an ESD-preventive wrist or ankle strap to do this procedure. Attach an ESD-preventive
wrist or ankle strap and follow its directions for use, before you do this procedure.
Figure 1
Locations of Labels and Reference Points on the EPA
ATTENTION:
USE CARE DURING INSTALLATION OF EPA CARD,
MIS-ALIGNMENT CAN CAUSE DAMAGE TO THE
CONNECTOR AT THE UNDERSIDE REAR OF THE PCB.
MAKE SURE THAT THE CONNECTOR IS FULLY
ENGAGED BY PUSHING DOWN ON THE 2X LABELS
BEFORE INSTALLATION OF FRONT PANEL SCREWS (2X).
DO NOT APPLY EXCESSIVE FORCE TO THE FRONT
PANEL OR TOP SURFACE DURING INSTALLATION OR
DAMAGE CAN OCCUR TO THE PCB CONNECTOR.
Caution
The connectors must be engaged without any angular misalignment. Engaging the connectors at an angle
will cause damage to the connectors.
Co rp o ra t e He a d q u a rt e rs :
Cis c o S ys t e m s , In c ., 1 7 0 We s t Ta s m a n Drive , S a n J o s e , CA 9 5 1 3 4 -1 7 0 6 US A
Copyright © 2005 Cisco System s, Inc. All rights reserved.
Download from Www.Somanuals.com. All Manuals Search And Download.
Step 3
Ensure that the connector guide pins are aligned. Once the connector is engaged, apply gentle pressure
Figure 4
Press on the Rear Outer Corners of the EPA
PUSH
CORNERS
TO
INST
ALL
PUSH
CORNERS
TO
INST
ALL
Figure 5
Rear Outer Corners of the EPA (Close-up)
PUSH
BOTH
PUSH
BOTH
CORNERS
TO
CORNERS
TO
INSTALL
INSTALL
PUSH
BO
CORNERS
TH
INST TO
ALL
PUSH
BO
CORNERS
TH
INST TO
ALL
Inserting an EPA into a Modular Gigabit Ethernet Line Card
78-17296-01 A0
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Step 4
Press gently on the white labels in middle of the outer edge of the EPA as shown in Figure 6 to ensure
that the connector is fully seated.
Figure 6
Press on the White Labels on the EPA
PUSH
CORNERS
TO
INST
ALL
PUSH
CORNERS
TO
INST
ALL
Inserting an EPA into a Modular Gigabit Ethernet Line Card
78-17296-01 A0
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Step 5
Use a Phillips screwdriver to insert and tighten the screw on the EPA, 3 to 5 in-lbs, as shown in Figure 7.
Apply no more than 5 in-lbs of torque when tightening the screw.
Caution
Figure 7
Inserting and Tightening the Screw on the EPA
PUSH
CORNERS
TO
INST
ALL
PUSH
CORNERS
TO
INST
ALL
Inserting an EPA into a Modular Gigabit Ethernet Line Card
78-17296-01 A0
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Step 6
Use a Phillips screwdriver to insert and tighten the two screws on the faceplate of the line card,
Caution
Apply no more than 5 in-lbs of torque when tightening the screw.
Figure 8
Inserting the 2 screw s on the Faceplate of the Line Card
PUSH
CORNERS
TO
INST
ALL
PUSH
CORNERS
TO
INST
ALL
Inserting an EPA into a Modular Gigabit Ethernet Line Card
78-17296-01 A0
6
Download from Www.Somanuals.com. All Manuals Search And Download.
CCSP, CCVP, the Cisco Square Bridge logo, Follow Me Browsing, and StackWise are trademarks of Cisco Systems, Inc.; Changing the Way We
Work, Live, Play, and Learn, and iQuick Study are service marks of Cisco Systems, Inc.; and Access Registrar, Aironet, ASIST, BPX, Catalyst,
CCDA, CCDP, CCIE, CCIP, CCNA, CCNP, Cisco, the Cisco Certified Internetwork Expert logo, Cisco IOS, Cisco Press, Cisco Systems, Cisco
Systems Capital, the Cisco Systems logo, Cisco Unity, Empowering the Internet Generation, Enterprise/Solver, EtherChannel, EtherFast,
EtherSwitch, Fast Step, FormShare, GigaDrive, GigaStack, HomeLink, Internet Quotient, IOS, IP/TV, iQ Expertise, the iQ logo, iQ Net Readiness
Scorecard, LightStream, Linksys, MeetingPlace, MGX, the Networkers logo, Networking Academy, Network Registrar, Packet, PIX, Post-Routing,
Pre-Routing, ProConnect, RateMUX, ScriptShare, SlideCast, SMARTnet, StrataView Plus, TeleRouter, The Fastest Way to Increase Your Internet
Quotient, and TransPath are registered trademarks of Cisco Systems, Inc. and/or its affiliates in the United States and certain other countries.
All other trademarks mentioned in this document or Website are the property of their respective owners. The use of the word partner does not imply
a partnership relationship between Cisco and any other company. (0502R)
© 2005 Cisco Systems, Inc. All rights reserved.
Inserting an EPA into a Modular Gigabit Ethernet Line Card
78-17296-01 A0
7
Download from Www.Somanuals.com. All Manuals Search And Download.
|