CDA Freezer FW880 User Manual

FW880 extra large integrated  
freezer  
Manual for Installation, Use and Maintenance  
Customer Care Department • The  
Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY  
T : 01949 862 012 F : 01949 862 003 E : [email protected] W : www.cda.eu  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Before first use  
You must allow the freezer to settle for at least twenty four hours prior to switching the power on.  
It is recommended that you clean the interior of the appliance prior to first use, using a solution of bicarbonate of soda  
and warm water and then thoroughly drying the interior.  
The freezer may have an odour to it at first use. This will disappear as the appliance cools.  
Please note:  
The appliance will work continuously until it comes down to the correct temperature.  
If the appliance is switched off, you should allow five minutes before switching it on again to prevent unnecessary  
damage to the compressor.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Controls and Use  
S
S
4
3
5
1
2
1
3
4
5
2
fig. 1  
1. Thermostat dial  
The thermostat automatically keeps the internal temperature at a constant level. The temperature is regulated by  
the thermostat dial, located on the freezer control panel. To change the temperature, turn the dial anti-clockwise from  
1 (highest temperature) to 5 (coldest temperature). We recommend that you start with the appliance set to position 3.  
Don not turn the dial beyond the maximum. To switch the freezer off, turn the dial anticlockwise to the  
minimum position.  
2. Super freeze switch  
This freezer is equipped with a super freeze function. This allows the freezer compressor to run continuously and  
so freezes food more quickly. To select this function, push the switch across until the super freeze indicator light (5)  
illuminates. To switch the function off, then push the switch back across until the indicator light goes out again.  
Note that this should not be used for more than 24 hours.  
3. Power indicator light  
This green light will illuminate when the freezer is switched on.  
4. Over temperature indicator light  
This red light will illuminate when the temperature inside the freezer is too high. This may illuminate after the door  
has been opened, or when fresh food is added and should switch off again once the temperature within the freezer  
has stabilised.  
5. Super freeze indicator light  
This yellow light will illuminate when the super freeze function has been switched on with the super freeze switch (2).  
Use  
The freezer compartments are designer to store only frozen food.  
Never put hot or warm foods in the freezer, allow them to cool fully before putting them into the freezer.  
Follow the instructions on the packaging for storage of frozen food. If no information is provided, foods should not be  
stored for more than three months after the purchase date.  
Never put carbonated drinks into the freezer as the carbon dioxide may expand, causing and explosion.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Defrosting the freezer  
Do not use heaters or defrosting sprays in this appliance.  
Never use any metallic or sharp objects to remove the ice as this could damage the lining.  
The freezer compartment should be defrosted regularly to ensure the most efficient running of the freezer.  
Once the ice is more than 5mm thick, the freezer should be defrosted.  
First remove the freezer drawers.  
To speed up the process, place a bowl of warm water in the base of the freezer compartment.  
Once defrosting is complete, dry the inside of the freezer compartment with a sponge or clean cloth thoroughly. Then  
re-connect the mains power supply.  
Clean the drawers separately by hand using soap and water. Do not put them in a dishwasher.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Troubleshooting  
If you have any problems with your appliance, you should check the troubleshooting prior to calling CDA Customer Care  
to prevent unnecessary service calls and potential cost.  
If the appliance is not working  
Check there is power to the appliance.  
The house fuses are intact and the fuse in the plug has not blown.  
The thermostat is not set to 0 (off position).  
The plug socket is functioning fine. To check this, plug another electrical appliance in to see if the socket is working.  
The temperature of the room is adequate (10oC or above).  
If the appliance is working, but not very well  
The appliance is not overloaded.  
The thermostat is set to an appropriate temperature.  
The door is closing properly.  
The cooling system at the rear of the appliance is clean and free of dust, and not touching the rear wall.  
There is enough ventilation at the side and rear walls.  
The temperature of the room is adequate (10oC or above).  
If the appliance is noisy  
The appliance is level and stable.  
The side and rear walls are clear, and there is nothing resting on the appliance.  
The cooling gas in the refrigerator will make a slight bubbling noise, even when the compressor is not running.  
If there is water in the lower part of the refrigerator compartment  
The drain hole in the channel at the back of the compartment is clear.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Installation And Ventilation  
This appliance must never be installed close to heat sources i.e. heating  
elements, cookers or in damp places  
The diagram shows the ventilation requirements for your product.  
Failure to provide adequate ventilation can lead to increased running costs and  
premature failure and may invalidate the warranty provided with the product.  
540  
1780-1783  
540  
fig. 2  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Reversing the door  
fig. 3  
It is possible to reverse the door on this appliance, if required.  
To do so, follow the steps below:  
1. Loosen the top hinge fixing screws and remove the top hinge,  
taking care to support the weight of the door.  
2. Lift the door from the bottom hinge and place on a soft surface  
to protect the door from damage.  
3. Refit the hinge taken from the top to the opposite lower corner,  
as in figure 3.  
4. Replace the door and refit the hinge taken from the lower corner  
to the opposite top corner.  
5. Adjust the hinges to ensure the door is aligned correctly.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Mounting the Fascia Door  
x4  
Using a screwdriver, x the mounting brackets to the •  
appliance door, as shown in figure 4.  
Position the appliance within the unit. Ensure that there  
is a gap of 3 to 4 mm between the non-hinged side and  
the cabinet wall.  
Locate the slider in the bracket and fix the slider to  
the fascia door 20 to 22 mm from the edge of the  
fascia as shown in figure 5, ensuring that the slider is  
positioned centrally and horizontally within the bracket.  
Tighten securely by hand.  
Fill the gap on the non-hinged side with the seal strip •  
provided, as shown in figure 6.  
fig. 4  
x4  
20 mm  
fig. 5  
door gasket  
fig. 6  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Electrical information  
Warning! This appliance must be earthed.  
The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. To change a fuse in this type of plug,  
follow the steps below:  
1. Remove the fuse cover and fuse.  
2. Fit replacement 13A fuse, ASTA approved to BS 1362 type, into the fuse cover.  
3. Replace fuse cover.  
Important: Do not use the appliance without the fuse cover in position.  
How to connect an alternative plug  
If the fitted plug is not suitable for your socket outlet, then it should be cut off and disposed of safely to avoid possible shock  
hazard. A suitable alternative plug of at least 13 Amp rating to BS 1363 should be used.  
As the colours of the wires in the mains lead of this appliance may not correspond with the  
coloured markings identifying the terminals in your plug, proceed as follows:-  
The wire which is coloured GREEN and YELLOW must be connected to the terminal which is marked with letter (E) or  
by the Earth symbol or coloured GREEN and YELLOW.  
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter (N), or  
coloured BLACK.  
The wire which is coloured BROWN must be connected to the terminal which is marked with the letter (L) or  
coloured RED.  
If in doubt regarding the electrical connection of this appliance, consult a qualified electrician. Do not shorten the  
supply cable, the appliance may require removing for servicing.  
N.B. Ensure that the plug socket is situated in an easily accessible place.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
To contact our Customer Care Department, or for Service,  
please contact us on the details below.  
Customer Care Department • The  
Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY  
T : 01949 862 012 F : 01949 862 003 E : [email protected] W : www.cda.eu  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Belkin Network Router F7D4301 User Manual
BMW Automobile 320i User Manual
Bosch Appliances Digital Camera NBN 498 User Manual
Bosch Power Tools Vacuum Cleaner 3931B SPB User Manual
Bose DVR RC 18S User Manual
Bose Home Theater System AM353759 User Manual
Cadillac Automobile 2006 DTS User Manual
Canon Camcorder 9545A001AA User Manual
Canon Scanner DR C130 User Manual
Cisco Systems Home Theater Server 52x User Manual