Companion® Infant Restraint System Model # E9L14
Assembly Visual Inspection Instructions
WARNING: Remove infant from carrier
before beginning visual inspection.
On bottom of carrier where rubber
strips run along edges of support
rails, there is an exposed opening
with attachment hooks.
Turn carrier upside down so the
underside of the carrier faces
upward.
Approximately 1.5” from each
attachment hook (toward the red
carrier-release handle) are tabs.
Remove infant carrier from base.
The base can remain in the vehicle
during visual inspection of carrier.
Britax Child Safety, Inc.
13501 South Ridge Drive
If one or both tabs do not fully cover
the opening, contact Britax Child
Safety, Inc. at 888-427-4829 for
further instruction. If both tabs are
not fully covered, you may continue
to use the carrier in vehicle without
the base.
Verify that tabs are intact and fully
cover the opening.
If both tabs fully cover the openings,
the carrier is safe for continued use.
Britax Child Safety, Inc. apologizes
for any inconvenience.
Charlotte, NC 28273
Consumer Services: 1.888.4Britax
For more information visit: BritaxUSA.com
© 2006 Britax® Child Safety, Inc.
Download from Www.Somanuals.com. All Manuals Search And Download.
|