Brinkmann Landscape Lighting Solar Powered LED Garden Accent Light User Manual

ENDURA  
EXTRA-LONG RUNNING SOLAR POWERED L.E.D. GARDEN ACCENT LIGHTS  
LEGACY II OWNER’S MANUAL  
ASSEMBLY AND OPERATING INSTRUCTIONS  
Download from Www.Somanuals.com. All Manuals Search And Download.  
ASSEMBLY INSTRUCTIONS  
Inspect contents of the box to ensure all parts are included and undamaged.  
A flathead screwdriver is required for  
mounting the wall bracket.  
1
PARTS LIST:  
Legacy II Light Head Fixture  
Ground Stake  
1
2
3
4
Connector w/Point  
Connector  
Deck/Wall/Fence Mounting Bracket  
Mounting Screws (2)  
5
6
4
6
2
Select a location with full, direct sunlight.  
Shady locations will not allow the battery to  
charge fully and will reduce the hours of  
nighttime light.  
NOTE: The rechargeable Ni-Cd battery  
must be allowed to fully charge to  
operate properly. Partially  
charging the battery on a  
5
consistent basis will drastically  
reduce the life of the battery.  
The selected location should not be near a  
nighttime light source such as a porch light or  
street light, as these might keep the solar  
lights from automatically turning on. The solar  
lights should not be placed closer than 5 feet  
from one another. This could cause the solar  
lights to flicker from the adjacent light source.  
3
2
Download from Www.Somanuals.com. All Manuals Search And Download.  
OPERATING INSTRUCTIONS  
READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY BEFORE OPERATING YOUR SOLAR LIGHT.  
SAVE THIS MANUAL FOR FUTURE REFERENCE.  
Step 1  
Attach the ground stake to a pointed  
connector. Push approximately 3" of the  
ground stake into the ground. If the  
ground is too hard, soak area with water  
to soften.  
Step 2  
Insert light head into ground stake. The  
photocell light sensor should point away  
from other nighttime light sources.  
Step 3  
Charge in direct sunlight for 10-12 FULL,  
SUNNY DAYS. The light will turn on  
automatically at night. Allow at least  
10-12 cycles (i.e., 10-12 days and nights  
of charging and discharging) for the  
battery to charge to its full capacity.  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
Deck/Wall/Fence  
Mounting:  
Select a location with full, direct sunlight.  
Shady locations will not allow the battery to  
charge fully and will reduce the hours of  
nighttime light.  
Step 1  
Mount the bracket to a deck, wall or  
fence using the two screws provided.  
Step 2  
Insert the hexagon portion of the  
connector to the bottom hexagon hole  
of the light fixture.  
Step 3  
Insert light fixture with connector into  
bracket. The photocell light sensor  
should point away from other nighttime  
light sources.  
Step 4  
Charge in direct sunlight for 10-12  
FULL, SUNNY DAYS. The light will turn  
on automatically at night. Allow at least  
10-12 cycles (i.e., 10-12 days and nights  
of charging and discharging) for the  
battery to charge to its full capacity.  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
®
IMPORTANT:  
The EPA Certified RBRC Battery  
Changing Battery  
Step 1  
Remove lens from top housing by  
turning lens clockwise.  
Recycling Seal on the nickel-cadmium (Ni-Cd)  
battery contained in our product indicates The  
Brinkmann Corporation is voluntarily participating in  
an industry program to collect and recycle these  
batteries at the end of their useful life, when taken  
out of service in the United States or Canada. The  
Step 2  
With top housing upside down (solar  
panel facing down), push tab on battery  
compartment lid and remove the lid.  
®
RBRC program provides a convenient alternative to  
placing used Ni-Cd batteries into the trash or the  
municipal waste stream, which may be illegal in your area. Please call 1-800-8-  
BATTERY™ for information on Ni-Cd battery recycling and disposal  
bans/restrictions in your area. The Brinkmann Corporation’s involvement in this  
program is part of our commitment to preserving our environment and conserving  
our natural resources.  
Step 3  
Remove battery. Replace with new Ni-Cd  
rechargeable battery.  
Step 4  
Replace battery compartment lid.  
Step 5  
Top Housing  
Attach the lens by aligning the tabs with  
the slots in top housing. Turn counter-  
clockwise to lock in place.  
Tabs  
Lens  
NOTE: These lights utilize L.E.D. (Light  
Emitting Diode) technology. There  
are no bulbs to replace.  
Battery Compartment Lid  
Battery  
Cleaning  
It is important that the solar panel is kept free  
of dirt and debris. A dirty solar panel will not  
allow the battery to fully charge. This will  
shorten the life of the battery and cause the  
light to malfunction. Clean regularly with a  
dampened cloth or paper towel.  
Top Housing  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
Solar lights can be left outside year round, even in cold weather. However, if you  
wish to store your light indoors for more than two or three days, follow these steps  
to prevent damage to rechargeable batteries:  
Storage Tips  
Store at room temperature in a dry location.  
Store solar light where it can receive some sunlight or room light each day.  
The battery needs light to maintain a charge during storage.  
During prolonged storage, units must be fully discharged and charged once  
every month or remove batteries and replace with new Ni-Cd rechargeable  
batteries when ready for use. Check and replace batteries periodically  
throughout the year.  
Do not store solar lights in a box, or a dark room without a source of light on  
the solar panel. This will damage the batteries and prevent their ability to hold  
a charge.  
For best performance, do not store for prolonged periods.  
If your solar light does not turn on at night, it may be caused by one the  
following conditions:  
Troubleshooting  
Information  
Battery is not fully charged or needs replacement:  
a. Make sure your light is located in an area where the solar panel gets the  
maximum amount of full, direct sunlight every day. Allow sunlight to  
recharge the battery for 10-12 FULL, SUNNY DAYS.  
b. If the weather has been cloudy or overcast during the day, the battery will  
not be recharged for operation at night. The solar light must have direct  
sunlight every day to fully charge the battery. If the solar light does not  
receive enough sunlight one day, it will recharge the next sunny day and  
resume normal operation.  
c. Check and replace the battery periodically throughout the year, especially  
after winter months. Replacement batteries may be purchased from The  
Brinkmann Corporation Customer Service Department by calling  
1-800-468-5252.  
Other light sources: If your solar lights are located too close to a street light,  
porch light or another solar light, it may not turn on automatically at night. The  
built-in photocell light sensor is reacting to the other light source. Eliminate the  
other light source or relocate your solar lights.  
Dirty solar panel: A dirty solar panel will not allow the battery to fully charge.  
This will shorten the life of the battery and cause the light to malfunction.  
Clean regularly with a dampened cloth or paper towel.  
After correcting the problem, check the light operation immediately after dark or in a  
dark room. If the light will only operate for a short time, the battery needs recharging.  
Clean snow and debris off the solar panel to allow battery to recharge.  
Wintertime  
Tips  
Check and replace battery periodically throughout the year, especially after  
winter months.  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
1-YEAR LIMITED WARRANTY  
For 1-year from date of purchase, The Brinkmann Corporation warrants the Legacy II solar light against defects due to workmanship or  
materials to the original purchaser. The Brinkmann Corporation’s obligations under this warranty are limited to the following guidelines:  
This warranty does not extend to the L.E.D. or battery.  
This warranty does not cover solar lights that have been altered or damaged due to: normal wear, abuse, improper maintenance,  
improper use, disassembly of parts and/or attempted repair by anyone other than an authorized employee of The Brinkmann  
Corporation.  
This warranty does not cover surface scratches or weathering as this is considered normal wear.  
Warranty service is limited to repair or replacement of solar lights which prove defective under normal use and which upon  
examination shall indicate to Brinkmann’s satisfaction, they are defective. If Brinkmann confirms the defect and approves the  
claim, Brinkmann will elect to repair or replace the solar light as covered by the terms of this warranty.  
This warranty extends to the original purchaser only and is not transferable or assignable to subsequent purchasers.  
The Brinkmann Corporation requires reasonable proof of purchase. Therefore, we strongly recommend that you retain your sales  
receipt or invoice. To obtain repair or replacement of your Legacy II solar light under the terms of this warranty, please call Customer  
Service Department at 1-800-527-0717 for a Return Authorization Number and further instructions. A receipt or proof of purchase  
will be required. Solar lights returned to Brinkmann must include your name, address and telephone number. Please make sure the  
light is properly packed, postage prepaid, and insured. A Return Authorization Number must be clearly marked on the outside of  
the box. Brinkmann cannot be responsible for any solar lights forwarded to us without a Return Authorization Number.  
EXCEPT AS ABOVE STATED, THE BRINKMANN CORPORATION MAKES NO OTHER EXPRESS WARRANTY.  
THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED IN DURATION TO  
1-YEAR FROM THE DATE OF PURCHASE. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY  
LASTS, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU.  
ANY LIABILITY FOR INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING FROM THE FAILURE OF THE LEGACY II  
SOLAR LIGHT TO COMPLY WITH THIS WARRANTY OR ANY IMPLIED WARRANTY IS EXCLUDED. CUSTOMER ACKNOWLEDGES  
THAT THE PURCHASE PRICE CHARGED IS BASED UPON THE LIMITATIONS CONTAINED IN THE WARRANTY SET OUT ABOVE.  
SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE  
LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY  
ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.  
140-2417-0  
11/00, 2/02  
Owner’s Manual for Models  
822-0417-0  
822-0417-2  
822-0417-4  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Belkin Network Cables PM00760 A F4U001 User Manual
Belkin Network Router A F5D7130 User Manual
Black Decker Cordless Saw 3680 User Manual
Blaupunkt Car Stereo System C32 User Manual
BOXLIGHT Projector XD 10m User Manual
Braun Blender MR 500 SOUP User Manual
Briggs Stratton Pressure Washer 2550 PSI User Manual
Brother Car Stereo System CP5225N User Manual
Brother Printer MFCJ5620DW User Manual
Bryan Boilers Boiler RV500 User Manual