Braun Electric Shaver BS 8385 User Manual

ContourPro

on _•

min

Download from Www.Somanuals.com. All Manuals Search And Download.

www.braun.co.jp

Download from Www.Somanuals.com. All Manuals Search And Download.

•

off

on _•

STOP

Download from Www.Somanuals.com. All Manuals Search And Download.

ContourPro

o n

•

o f

min

Download from Www.Somanuals.com. All Manuals Search And Download.

min

Download from Www.Somanuals.com. All Manuals Search And Download.

o n

o f ^•

Download from Www.Somanuals.com. All Manuals Search And Download.

English

Our products are designed to meet the

highest standards of quality, functionality and

design. We hope you enjoy your new Braun

Shaver.

5 Comfort setting switch «sensitive»

6 Shaver-to-station contacts

7 On/off switch

8 Shaver display

9 Cleaning light (yellow)

10 Replacement light for shaving parts

11 Reset button

12 Shaver power socket

13 Special cord set

Warning

Your shaving system is provided with a

special cord set, which has an integrated

Safety Extra Low Voltage power supply. Do

not exchange or tamper with any part of it,

otherwise there is risk of an electric shock.

14 Etui

A Before shaving

To prevent the cleaning fluid from leaking,

ensure that the Clean&Renew station is

placed on a flat surface. When a cleaning

cartridge is installed, do not tip, move

suddenly or transport the station in any

way as cleaning fluid might spill out of the

cartridge. Do not place the station inside a

mirror cabinet, nor place it on a polished or

lacquered surface.

Prior to first use, you have to connect the

shaver to an electrical outlet using the special

cord set (13) or alternatively, proceed as

follows:

Installing the Clean&Renew station

• Using the special cord set (13), connect the

station power socket (5) to an electrical

outlet.

• Press the lift button (2) to open the housing

• Hold the cleaning cartridge (6) down on a

flat, stable surface (e.g. table).

• Carefully remove the lid from the cartridge.

• Slide the cartridge into the base of the

station as far as it will go.

The cleaning cartridge contains a highly

flammable liquid so keep it away from

sources of ignition. Do not expose to direct

sunlight and cigarette smoking nor store it

over a radiator.

Keep it out of reach of children.

• Slowly close the housing by pushing it

down until it locks.

Do not refill the cartridge and use only

original Braun refill cartridges.

Charging the shaver in the Clean&Renew

station

Insert the shaver head down into the cleaning

station. (The contacts (6) on the back of the

shaver will align with the contacts (3) in the

cleaning station).

Description

Clean&Renew station

1 Level indicator

2 Lift button for cartridge exchange

3 Station-to-shaver contacts

4 Start button

If required, the Clean&Renew station will start

charging the shaver now.

5 Station power socket

6 Cleaning cartridge

A full charge provides up to 45 minutes of

cordless shaving time. This may vary

according to your beard growth.

Shaver

1 Shaver foil

The best environmental temperature for

charging is between 5 °C to 35 °C. Do not

expose the shaver to temperatures higher

than 50 °C for extended periods of time.

2 Cutter block

3 Foil release buttons

4 Long hair trimmer

Download from Www.Somanuals.com. All Manuals Search And Download.

Shaver display

Tips for the perfect shave

For best results, Braun recommends you

follow 3 simple steps:

1. Always shave before washing your face.

2. At all times, hold the shaver at right

angles (90°) to your skin.

3. Stretch your skin and shave against the

direction of your beard growth.

The shaver display (8) shows the charge

status of the battery. During charging or

when using the shaver, the respective green

battery segment will blink. When fully

charged, all green segments will light up for

approximately one hour, provided the shaver

sits in the C&R station.

The red low charge segment flashes when

the battery capacity has dropped below

20 %, provided the shaver is switched on.

The remaining capacity will then be sufficient

for 2 to 3 shaves.

Shaving with the cord

If the shaver has run out of power

(discharged), you may also shave with the

shaver connected to an electrical outlet via

the special cord set.

Cleaning

B Shaving

For best shaving results, we recommend

cleaning the shaver in the station after each

shave (see «Automatic cleaning»).

Press the on/off switch (7) to operate the

shaver.

All charging and cleaning needs are then

automatically taken care of.

Comfort setting switch «sensitive» (5)

Setting the shaver head according to your

comfort needs.

Cleaning indicator

Clean your shaver in the Clean&Renew

station at the latest when the yellow cleaning

light (9) shines constantly after shaving.

If this is not done, the cleaning light will go

off after some time and the counter will be

reset.

The «sensitive» switch (5) provides three

options for comfort setting:

1 «+»:

The shaver head is in full swing, freely

follows the contours of your skin to

provide more comfort.

2 middle position:

The shaver head is semi-fixed for more

control.

C Automatic cleaning

The Clean&Renew has been developed for

cleaning, charging and storing your shaver.

After each shave, return the shaver to the

Clean&Renew station and proceed as

follows:

3 «–»:

The shaver head is fixed for full control

and precise handling in hard to reach

areas.

• Insert the shaver head down into the

cleaning station.

• Push down the start button (4). The

cleaning process will start (approx.

5 minutes cleaning, 4 hours drying).

• Do not interrupt the cleaning process, as

it leaves the shaver wet and not fit for use.

Long hair trimmer (4)

To trim sideburns, moustache or beard, slide

the long hair trimmer upwards.

Download from Www.Somanuals.com. All Manuals Search And Download.

If interruption is needed nonetheless, press

the start button (4).

• When cleaning is finished, the yellow

cleaning light will go off and the shaver is

ready for use.

• A cleaning cartridge should be sufficient for

about 30 cleaning cycles. When the level

indicator (1) has reached the «min» mark,

the remaining fluid in the cartridge is

sufficient for about 5 more cycles. Then the

cartridge should be replaced, when used

daily approx. every 4 weeks.

Rinsing the shaver head under running water

is an alternative way to keep the shaver

clean, especially when traveling:

• Switch the shaver on (cordless) and rinse

the shaver head under hot running water.

You may use liquid soap without abrasive

substances. Rinse off all foam and let the

shaver run for a few more seconds.

• Next, switch off the shaver, press the foil

release buttons (3) to remove the shaver

foil (1) and cutter block (2). Then leave the

disassembled shaving parts to dry.

• The hygienic cleaning cartridge contains

alcohol, which once opened will naturally

evaporate slowly into the surrounding air.

Each cartridge, if not daily used, should be

replaced after approximately 8 weeks.

• The cleaning cartridge also contains

lubricates, which may leave residual marks

on the shaver head after cleaning.

However, these marks can be removed

easily by wiping gently with a cloth or soft

tissue paper.

• If you regularly clean the shaver under

water, apply a drop of the light machine oil,

included with the shaver, onto the shaver

foil and long hair trimmer. This is critical

for proper functioning of the shaver as

washing under water can lead to removal

of lubricants from the shaver’s cutting parts

leading to higher friction in the shaver.

This may result in the battery running out

faster than normal. Even if this happens –

indicated by low charge indicator lighting

up earlier, your Braun shaver will run for

at least 5 more minutes enabling you to

complete your current shave.

Cleaning the housing

From time to time clean the housing of the

shaver and the Clean&Renew station with a

damp cloth, especially inside the cleaning

chamber where the shaver rests.

The following quick cleaning is another

alternative cleaning method:

• Press the foil release buttons (3) to lift

the shaver foil (do not remove the foil

completely). Switch on the shaver for

approx. 5–10 seconds so that the shaved

stubbles can fall out.

• Switch off the shaver. Remove the shaver

foil and tap it out on a flat surface. Using

the brush, clean the inner area of the

shaver head. However, do not clean the

shaver foil nor the cutter block with the

brush as this will damage them.

Replacing the cleaning cartridge

After having pressed the lift button (2) to

open the housing, wait for a few seconds

before removing the used cartridge to avoid

any dripping.

Before discarding the used cartridge, make

sure to close the openings using the lid of the

new cartridge, since the used cartridge will

contain contaminated cleaning solution.

Keeping your shaver in top

shape

Replacing the foil and cutter block/reset

To maintain 100% shaving performance,

replace the shaver foil (1) and cutter block (2),

when the replacement symbol (10) lights up

D Manual cleaning

The shaver head is suitable for

cleaning under running tap water.

Warning: Detach the shaver from the

power supply before cleaning the

shaver head in water.

Download from Www.Somanuals.com. All Manuals Search And Download.

(after about 18 months) or when cassette is

worn.

The replacement symbol will remind you

during the next 7 shaves to replace the

shaver foil and cutter block. Then the shaver

will automatically reset the display. After you

have replaced the shaver foil and cutter

block, use a ball-pen to push the reset button

(11) for at least 3 seconds to reset the

counter. While doing so, the replacement

light blinks and goes off when the reset is

complete. The manual reset can be done at

any time.

Accessories

Available at your dealer or Braun Repair

Centres:

• Shaver foil and cutter block: Series 8000

• Cleaning cartridge Clean&Renew CCR

Environmental notice

This product contains rechargeable

batteries. In the interest of protecting

the environment, please do not

dispose of the product in the house-

hold waste at the end of its useful life.

Disposal can take place at a Braun Repair

Centre or at appropriate collection points

provided in your country.

The cleaning cartridge can be disposed with

regular household waste.

Subject to change without notice.

This product conforms to the European

Directives EMC 89/336/EEC and Low

Voltage 2006/95/EC.

For electric specifications, see printing on the

special cord set.

Download from Www.Somanuals.com. All Manuals Search And Download.

5-751-429/01/V-07

Download from Www.Somanuals.com. All Manuals Search And Download.

Black Box TV Video Accessories 4 x 4 HDMI Matrix Switch User Manual
Black Decker Cordless Sander DS321 User Manual
Bolens Lawn Mower 112 310A User Manual
Breville Blender BBL500 User Manual
Cannon Cooktop C50GKB User Manual
Canon Camera Lens EF 135mm f 28 User Manual
Canon Fax Machine FAX L800 User Manual
Canon Fax Machine L250 User Manual
Cecilware Water Dispenser GB3 CP ST User Manual
Chief Manufacturing Projector Accessories RSM A D User Manual