sport utility stroller Weather Shield instructions
Fax: (208) 375-5172, BOB Trailers, Inc. 5475 Gage St. Boise, ID 83706
Congratulations on your purchase of the BOB Weather
Align
Side
Shield. It is designed to provide your child with protection
from inclement weather. Proper installation and care will
provide years of reliable service.
seam
with
Vents
forward
canopy
support
Elastic
cord
end
Before attempting to use or attach your new Weather
Shield, read and understand these instructions
completely to insure proper assembly and operation.
If you are unclear on any point, contact your dealer or
BOB before use.
Front
Vent
Rear
Vents
loop
Fig. 1 Vents unobstructed
Warnings
Fig. 6 Shield placed on canopy
.
This product is designed exclusively for use with BOB
Sport Utility, Sport Utility D’Lux and Ironman strollers. It
is not intended for use with other strollers or products.
Loop Around
Black Knob
.
The Weather Shield is made of a non-breathable material. Rear
Toavoiddangerofsuffocationandexcessivetemperatures,
follow all assembly instructions.
Canopy
Flap
Elastic Under
Black Knob
.
.
.
Always make sure all vents are unobstructed, as indicated
in Fig.1.
Forward
Canopy
Support
Aft Canopy Support
Fully Rotated Back
The Weather Shield is not designed to work with optional
Infant Car Seat Adapter and car seat.
Fig. 2 Canopy Supports
in positon.
Fig. 7 Elastic under knob
Do not use Weather Shield when temperatures exceed
65oF/18oC. Use in higher temperatures can cause unsafe
conditions inside the Weather Shield.
.
.
.
Never leave child unattended.
When not in use, keep out of reach of children.
When the Weather Shield is used, the rear canopy flap
must be in correct position as described below. This will
insure proper airflow and avoid danger of suffocation.
Cinch Cord
Lock tight
INSTALLATION INSTRUCTIONS:
against Canopy
1. Set stroller Parking Brake (refer to Parking Brake section
of stroller Owner’s Manual). Place sun canopy into position
to receive the Weather Shield as shown in Fig.2.
Fig. 3 Canopy Drawstring
Adjustment
2. Pull each canopy drawstring in order to gather extra
material under canopy. Cinch cord lock against canopy to
retract and hold material, as shown in Fig. 3.
Very important: when the Weather Shield is used, the rear
canopy flap must be in correct position as described below.
This will insure proper airflow and avoid danger of suffocation.
3. Locate rear canopy flap and fold forward. Attach canopy
flap Velcro on flap to respective Velcro mate on top outboard
sides of canopy as shown in Fig. 4. Warning tag on rear
canopy flap also describes and illustrates this critical step.
Fig. 4 Canopy Flap in Position
4. Inspect opening at back of stroller to make sure the air
passage between top of seat back and canopy are
unobstructed (see Fig. 5). We recommend reclining seat
back slightly to optimize airflow (refer to Reclining Seat
section of stroller Owner’s Manual).
5. Place Weather Shield on the stroller so the rear flap
drapes over back (between the handlebars) and the seam
above the window is aligned with the forward Sun Canopy
supports (see Fig. 6).
Air Passage
6. Stretch the elastic cord on each side under each respective
black shock knob as shown in Fig. 7. There is an opening
mid way up each side (with silver reflective fabric on each
Fig. 5 Rear Vent Unobstructed
OMA23
P1
Download from Www.Somanuals.com. All Manuals Search And Download.
|