| 	
		 Read all instructions BEFORE assembly and USE of product.   
					KEEP INSTRUCTIONS FOR FUTURE USE.   
					MODEL # 1638CT   
					Providence Ridge Travel System   
					Instruction Manual   
					Convenience through Innovation and thoughtful design   
					11.06   
					Download from Www.Somanuals.com. All Manuals Search And Download.   
				PARTS   
					Child Tray   
					Parent Tray   
					Base   
					Locking Cap   
					Hub Cap   
					Rear Wheels   
					Rear Axle Assembly   
					Stroller   
					Solid Cap   
					Front Wheels   
					Car Seat   
					TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE FOLLOW THESE   
					INSTRUCTIONS CAREFULLY. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.   
					TO ASSEMBLE STROLLER   
					* Remove stroller from box. The front wheels, rear wheels, and child tray,   
					and parent tray need to be installed prior to use.   
					* To attach the front wheels, slide the red unlock mechanism and squeeze   
					the stroller handle while pulling backward on the stroller to unfold. See   
					figures 1 and 2.   
					* Lean the stroller backwards so that it rests on the handle and rear frame   
					tubes and the front wheel tubes are pointing upward. Position the front   
					wheel assembly at the front tube such that the hole in the swivel assembly   
					will slide onto the front tube. Please see figure 3. Push each front wheel   
					assembly onto the front tube being careful that wheel assembly locks onto   
					the front leg. Pull on the wheel assembly to ensure that it is securely   
					attached to the stroller. Please see figure 3.   
					Figure 1.   
					Figure 2.   
					* Lean the stroller forward to rest on the front wheels. Assemble the rear   
					wheels as follows:   
					1. Slide the rear axle assembly onto the rear stroller legs until they lock   
					into place. Please see figure 4.   
					2. Slide each wheel onto the rear axle and secure in place with the   
					Locking Cap. Snap the solid cap over the Locking Cap. Snap the   
					Hub Cap onto the wheel. Please see figure 5. Please see figure 6 for   
					order assembly.   
					Figure 3.   
					Pull on each wheel to ensure that each is firmly attached to the axle.   
					* Ensure that the wheels are firmly locked into place. Do Not use the stroller   
					if the wheels are not locked into place, but rather contact our customer   
					service department immediately at (800) 328-7363, between the hours of   
					8:00am and 4:30pm PCT, for assistance.   
					Figure 4.   
					Figure 5.   
					Figure 6.   
					3 
					Download from Www.Somanuals.com. All Manuals Search And Download.   
				* To attach the front child tray, push the angled tray onto the post at the   
					end of the right armrest, while pressing downward on the snap button,   
					until locked into place. Please see figure 7. Rotate the tray downward   
					until latched onto the left armrest. Please check that the snap button   
					comes through and securely latches the tray in place. Please see figure   
					8.   
					* To remove front child tray, press inward on the left side tray release   
					button and rotate upward on the tray. Please see figure 9. Please note   
					that you may remove the tray completely by depressing the snap button   
					on the right side as shown in figure 10 while pulling forward on the tray.   
					Please see figure 7.   
					Figure 7.   
					* To install the canopy slide the male ends of the canopy into the female   
					slots on the stroller frame. Please see figure 11. To open the canopy   
					push forward on the front frame tube of the canopy. Please see figure   
					12.   
					* To attach the parent tray line up the parent tray slots with the   
					corresponding slots on the stroller frame, slide down until it locks into   
					place. Check to make sure the parent tray is secure before using. Please   
					see figure 14   
					Figure 8.   
					* To remove the parent tray, locate the locking tabs under the tray, pull   
					outward on the locking tabs and lift up to remove. Please see figure 15   
					Figure 9.   
					Front frame   
					tube   
					Figure 12.   
					Figure 11.   
					Figure 10.   
					Figure 15.   
					Figure 14.   
					4 
					Download from Www.Somanuals.com. All Manuals Search And Download.   
				TO SECURE THE CHILD   
					• The shoulder straps of the 5-point harness have 3 attachment positions.   
					Select the position that places the shoulder strap level with, or below   
					the top of the child's shoulder. To access the harness pull apart seat pad.   
					Please see figure 16.   
					• Carefully place the child in the stroller seat and bring the safety harness   
					around the child's waist and over the shoulders. Place the crotch strap   
					between the child's legs. Insert the male end of each shoulder/waist belt   
					into the buckle on the crotch strap. Tighten the harness to be snug around   
					the child's waist and over the child's shoulders Please see figure 17.   
					Figure 16.   
					Shoulder Strap   
					Waist   
					Strap   
					Squeeze   
					Adjust for a   
					snug fit   
					Crotch Strap   
					Figure 18.   
					Figure 17.   
					• To release, apply pressure to both sides of each male clip until the clip is released. See figure   
					18. This process requires a moderate amount of effort so as to prevent an accidental release by   
					your child.   
					WARNING:Avoid serious injury from   
					falling or sliding out. Always use the safety   
					harness.   
					STRANGULATION HAZARD:   
					Child can strangle in loose straps. Never leave   
					child in seat when straps are loose or undone.   
					5 
					Download from Www.Somanuals.com. All Manuals Search And Download.   
				ATTACHMENT OF THE BABY TREND INFANT CAR SEAT   
					* To attach the Baby Trend Infant Car Seat, recline the seat all the way   
					back. Please see figure 19   
					* Check that the front child tray is firmly attached to the stroller   
					armrests. Make sure that the car seat locks into the front child tray. Then   
					turn tabs on stroller frame to lock the front of the car seat into the stroller.   
					See figure 20.   
					* Position the Infant Car Seat, facing toward the rear of the stroller, so   
					that the seat shell goes into the front tray and latches into place. Please   
					see figure 21. Check that the Infant Car Seat is firmly locked onto   
					the front tray before using.   
					* To remove the Infant Car Seat, squeeze the release handle located at the   
					Figure 19.   
					foot-end of the seat and carefully lift upward on the seat. Please see   
					figure 23.   
					Locks   
					into tray   
					Figure 20.   
					Figure 21.   
					WARNING:Failure to follow these   
					car seat attachment instructions could re-   
					sult in serious injury or death.   
					Figure 22.   
					6 
					Download from Www.Somanuals.com. All Manuals Search And Download.   
				SEAT BACK POSITIONING   
					WARNING: The upright position should   
					be used only for a child that is at least 6 months   
					old.   
					* The seat has a multiple position recline that is controlled by a cord and   
					spring loaded adjuster behind the seat. To recline the seat, pull back on   
					the loop of the adjuster. Please see figure 23. To place the seat back in   
					a more upright position, grab the adjuster with one hand and pull the   
					cord to the desired position with the other hand. See figure 24.   
					The cord will lock automatically.   
					Figure 23.   
					Figure 24.   
					BRAKES   
					WARNING: Always set brakes when the   
					stroller is not being pushed so that the stroller will not   
					roll away. Never leave stroller unattended on a hill or   
					incline as the stroller may slide down the hill.   
					* To engage brakes, apply light downward pressure to the brake lever   
					located on each rear wheel. The stroller may require slight forward or   
					rearward movement in order to line up the teeth on the brake with each   
					wheel brake cluster. See figure 25. Check that the stroller will not move   
					and that the brakes are properly applied. To release, gently lift up on the   
					brake lever.   
					Figure 25.   
					7 
					Download from Www.Somanuals.com. All Manuals Search And Download.   
				CANOPY   
					Front frame   
					tube   
					* To open the canopy, push forward on the front frame of the canopy. To   
					close canopy, pull the front edge toward the rear of the stroller until   
					folded. Always fold the canopy prior to folding the stroller frame. Please   
					see figure 26.   
					Figure 26.   
					CAUTION: Read the following section completely before folding your stroller!   
					TO FOLD STROLLER   
					* Close the canopy as described in the canopy section. NOTE: For an   
					easier fold place the seat in the furthest recline position. Also you   
					must flip the carseat support tabs to the outside of the stroller frame   
					before folding. To fold the stroller slide the red fold lock with your   
					thumb while squeezing the large red fold button in the center of the   
					handle and push forward on the handle. Please see figure 27. Once the   
					stroller begins to fold, release the red handle and push forward on the   
					handle until the stroller is folded. Please see figure 28. To stroller will   
					automatically lock when folded correctly, and will stand freely in the   
					folded position.   
					Figure 27.   
					WARNING:Failure to   
					follow these folding instructions   
					could result in serious injury or   
					death.   
					Figure 28.   
					8 
					Download from Www.Somanuals.com. All Manuals Search And Download.   
				TO UNFOLD STROLLER   
					* To unfold the stroller slide the red fold lock with your thumb while   
					squeezing the large red fold button in the center of the handle and push   
					down on the handle.   
					Figure 29.   
					WARNING:Failure to   
					follow these folding instructions   
					could result in serious injury or   
					death.   
					Figure 30.   
					CLEANING SEAT PAD   
					* To clean the seat pad. use warm water, soap and a sponge, and let air   
					dry.   
					STOP   
					IF YOU EXPERIENCE ANY DIFFICULTY IN USING THIS PRODUCT,   
					PLEASE CONTACT OUR CUSTOMER SERVICE DEPARTMENT AT (800) 328-7363   
					BETWEEN THE HOURS OF 8:00AM AND 4:30PM PACIFIC COAST TIME FOR ASSISTANCE.   
					9 
					Download from Www.Somanuals.com. All Manuals Search And Download.   
				 |