1011
Vandal Resistant Sub Station with built in Color Pinhole Camera for use with
AP-M, LAF-C, LDF-C, LEF, LEM, MP-S Systems
- INSTRUCTIONS -
The LE-SSV is a 2-gang stainless steel vandal proof and weather resistant sub station designed for use with the
systems listed above. It is constructed of 12 gauge stainless steel and has a stand alone color camera built in. The
unit either flush mounts into a 2-gang box, or surface mounts using the SBX-2G. Each unit includes a 12V DC power
transformer for the camera, tamper proof screws, and a tool for installation.
INSTALLATION:
1. For flush mounting, install sub station in standard 2-gang electrical box with minimum 2-1/2" depth.
2. For surface mounting, use the SBX-2G surface mount enclosure (sold separately).
3. Only the 12V DC power supply included should be used to power the LE-SSV camera.
4. IMPORTANT! These units are designed for use in normal weather conditions, and to allow drainage and
evaporation of moisture that naturally gets into the unit. Do not apply caulking or silicone sealant around the
unit when installing, and do not use weather stripping around the perimeter of the box when mounting. If
sealing the unit is required, the bottom must remain unsealed. Sealing the unit will prevent or inhibit moisture from
dissipating from inside the unit, which may cause corrosion or deterioration of the internal components over time.
Front View
Back View
Camera
Speaker
Call button
45cm
18”
50cm / 20”
67cm
26½”
50cm
20”
The view achieved if the subject is 20" from the
camera is: 18" Vertically and 26½” Horizontally
Transparent corner shadowing
on the picture is normal.
Page 1
Download from Www.Somanuals.com. All Manuals Search And Download.
LE-SSV BACK VIEW:
Red connector for 12V DC camera
power input (from included power supply)
Power supply dimensions:
1-⅝" W x 2-¼” H x 1-⅝” D
6' DC cord.
Color Camera
Call Button
Yellow BNC connector for
video output
Speaker
Red: # terminal of Master
Black: E of Master
Blue:- (Neg.) of Master
NOTE: If using fiber optic interface, the video input on
the IFS VIC-5211 is not compatible with the LE-SSV
camera. The VIC-5211 can be used for audio only,
with a separate fiber module required for video.
Intercom wiring must be run at least 20" away from any AC wiring, fluorescent lighting, dimmer switches, or any
other electronic device that may cause interference.
SPECIFICATIONS:
Audio Power Source:
Supplied by master station
Speaker:
Call Button:
Call Annunciation:
20 ohms, 4W, 2" diameter, water proof and puncture resistant, 2.4 oz. magnet
SPST call button, momentary activation. Limited stop button
Call tone rings at master as long as button is held down. LED will remain lit for approx.
20 seconds (LEF, LEM-3, MP-3S, AP-5/10M only). Call tone only on LEM-1DL, LEM-1, and MP-1S.
Hands free at sub. Master is push-to-talk, release-to-listen.
75 Ohm, 1Vp-p, NTSC, DC-coupled
Communication:
CCTV Camera Output:
Iris Control:
Auto
Minimum Illumination:
Camera image sensor:
Focal Length:
1.0 lux
1/3" CCD
4.3mm Cone Pinhole Lens (78°)
Effective Pixels:
Camera Power Source:
MTBF:
510(H) x 492(V) NTSC
12V DC, 100mA (via included power supply)
(Mean Time Before Failure) 80,000 Hours
Faceplate:
12 gauge stainless steel
Mounting:
Flush mount into a 2-gang box (minimum 2-½” depth) or surface mount into SBX-2G (sold separately)
Tamper proof screws included (6x32 for use with flush 2-gang box) with T-10 TORX bit
When using SBX-2G, use the hardware included with that unit.
Color-coded prewired pigtails. Red wire = “1"; Black wire = “E”; Blue wire = negative;
Red connector = 12VDC power; Yellow connector = 75 Ohm / 1Vp-p video output (BNC).
Terminations:
Operating Temperature: 14 F ~ 140°F (-10°C ~ 60°C)
Audio Wiring:
2 conductors in a 1-master LEF, MP-S, or AP-M system. 3 conductors in a multi-master LEF system.
Shielded cable is recommended. Use Aiphone #822202 for LEM or MP-S. Use #822202 or
#822203 for LEF. Use #832202 for AP-M systems.
Audio Wiring Distance:
Video Wiring:
See system that unit is being used with for distance specifications.
Independent BNC connection from substation pigtail to destination video device.
Dimensions (H x W x D): LE-SSV alone: 4-11/16" x 4-11/16" x 2"
With SBX-2G: 4-3/4" x 4-7/8" x 3-5/8" (Top) 2-3/8" (Bottom)
Aiphone Communication Systems
1700 130th Ave. N.E.
Bellevue, WA 98005
(425) 455-0510
Toll Free Technical Support:
1-800-692-0200
E-mail [email protected]
Download from Www.Somanuals.com. All Manuals Search And Download.
LE-SSV Instr.
1011JD
FAX (425) 455-0071
|