A
Wall mount with a telephone stand
Cord connections
B
1
1
Desk mount option
Route line cord through the stand.
K
K
Press here to remove the stand.
C
I
T7316 Telephone User Card
D
J
Headset option
Connect cord to
headset.
key hole slots
Use the key hole slots on the stand
to mark the location for the screws.
Tighten screws for a secure fit.
L
L
E
2
M
Connect cord to
handset.
F
Mount the stand as shown and
insert screw. Use the screw that
came with your telephone.
H
G
Connect cords to the telephone,
refer to “Cord connections”
illustrations.
2
3
1-800-4 NORTEL
N
© 2002 Nortel Networks
P0935248 02
Mount the telephone
onto the screws and
slide it down.
Printed in Canada
Connect line cord to
wall jack.
Connect line cord to
wall jack.
Wall mount without a telephone stand
Your T7316 telephone
Your T7316 telephone
A
F
1
Telephone light
√ Volume control
Press here to remove the stand.
Telephone setup
Flashes when a call rings at the telephone.
Adjusts the handset, Handsfree, headset and ringer
volume.
Lights up when Message Waiting Indication (MWI) is
supported by system software. Contact your System
Administrator or Coordinator for more information.
Display contrast level
Connect cords to the telephone,
refer to “Cord connections”
illustrations.
G
H
I
© Mute button
Turns the microphone off or on when you are on a call.
Adjust the contrast of your display.
1. Press ≤•‡.
B
C
Adjustable display
Shows the time and date, call and feature information.
2. Press UP or DOWN to view the levels.
3. Press OK to select a level.
¬ Headset button
Turns the headset mode on.
2
Display buttons
Language choice
≤ Feature button
Starts or ends a feature.
The label for display buttons appear in capital letters
on the bottom of the display. Display buttons change
with each feature you use.
≤•fi‚⁄
Select Primary Language for the telephone display.
≤•fi‚¤
J
≥ Hold button
Places calls on hold.
Select Alternate Language for the telephone display.
≤•fi‚‹
Contrast level 2
Feature message
K
L
Memory buttons
DOWN
UP
OK
Display button label
Select Alternate Language 2 for the telephone display.
≤•fi‚›
Memory and line buttons
Display button
Select Alternate Language 3 for the telephone display.
M
Ω Indicators
Appear next to active line and memory buttons.
D
E
® Release button
Ends an active call.
Ring type
Connect line cord to
wall jack.
Select a different ring for your telephone.
1. Press ≤•fl.
N
Number card
Write your extension number on this card.
Dial pad
Place the telephone onto
the wall mount plate and
slide it down.
2. Press ⁄, ¤, ‹, ›, or NEXT to hear the different
ring types.
3. Press OK to store the ring type.
|