Legacy Car Audio LCDCS94 User Manual

LEGACY  
LCDCS94  
CD CHANGER DIN SOCKET  
INSTRUCTION MANUAL  
When you want to play the CD changer, plug the CD changer DIN into  
the socket of the back of the car audio unit.  
ANTI-THEFT DETACHABLE PANEL  
FULL LOGIC TAPE AND DISC PLAYER  
AM/FM STEREO DIGITAL PLL TUNING RADIO  
WITH CDC CONTROL  
TROUBLE SHOOTING  
Before going through the check list, finish wiring connection. If there still are  
any question after finish testing the items in the following list, consult your  
nearest service dealer.  
9. TUNE/SEEK/TRACK UP OR DOWN, FF/RW BUTTONS  
In radio mode, press UP or DN button, it will start automatic tuning and  
stop at the next receivable station; press UP or DN button for more than  
2 seconds to research for the higher or lower frequency station.  
In tape mode, press UP or DN button to fast forward or rewind the tape,  
and press TAPE button to resume normal tape playing.  
Symptom  
Cause  
Solution  
In CD player or CD changer mode, press UP or DN button to skip to the  
beginning of the next track or one of the track currently playing. Press  
DN button twice to skip to the beginning of the previous track. Press and  
hold UP or DN button for more than 2 seconds to search quickly (with  
sound) in the forward or reverse direction, and press it again to resume  
normal playing.  
The compact  
disc or tape  
does not play  
when inserted  
into the unit.  
The volume control is turned  
down.  
Turn up the volume control.  
The power connections are not Check the +12V and ground  
wired correctly.  
connections.  
The road surface is rough.  
Wait for the road surface to  
improve before playing a disc.  
The sound from  
the CD player  
skips.  
The unit is not mounted  
securely.  
Install the unit securely. Be sure to  
use the rear strap if the vehicle  
does not provide support for the  
rear of the unit.  
10-11-12-16-17-18. 1-6 PRESET MEMORY BUTTONS  
Select the desired band, then tune for the station you want to store in  
memory, and then press and hold one of 1-6 preset memory buttons  
for more than 2 seconds to store the broadcasting station to the preset  
memory. Every preset memory button can be stored only one station for  
each band, so the car audio system can be stored 30 stations.  
After finishing the storing operation, select the desired band and then  
press one or the six preset memory buttons to quickly tune for the  
desired station.  
The disc is defective.  
The disc is dirty.  
Try another disc. If it plays properly,  
the first disc may be defective.  
Clean the disc.  
No power.  
Switch the ignition to the "ON" or  
"ACC" position.  
The vehicle ignition is switched  
off.  
The fuse is blown.  
Replace the fuse with another 15A  
fuse.  
10. AMS BUTTON(Automatic Music Select System)  
The unit does  
not work  
properly (Eject,  
Load, Play).  
The microcomputer has been  
affected by electrical noise.  
Eject the disc or tape, then insert it  
again.  
In tape mode, press AMS button to turn on the AUTOMATIC MUSIC SELECT  
SYSTEM. Then if you press FF or REW button, it allows you to skip forward  
or backward to the beginning of a particular selection.  
Turn the power off and then on  
again.  
Press AMS button again to cancel AMS mode.  
No radio  
reception.  
The antenna cable is not  
connected.  
Insert the antenna cable firmly into  
the antenna jack on the unit.  
11-12. DISC SELECTING BUTTONS  
In CD changer mode, press the DISC + button to select the next disc and  
the DISC - button to select the preceding disc.  
The radio does  
not stop on any  
stations when  
automatic  
The signals are weak.  
Select a station using manual tuning.  
tuning is used.  
INSTALLATION  
13.LOUD/SUB WOOFER  
Press it shortly to enhance the bass effect during bass mode.  
Press it more than 2 seconds, SUB WOOFER will be turned on.  
then press SEL button to select the sound mode such as volume, bass,  
treble, balance and fader, and then press + or - button to increase or  
decrease the volume level of the selected sound mode. Press it more  
than 2 seconds again to turn off the SUB WOOFER.  
14.TAPE BUTTON  
Press it to switch from radio, CD player or CD changer mode to tape mode.  
In tape mode, press it to make the player automatically switch to the  
opposite side of the tape when the tape reaches the end of one side.  
15.CDP/CD-CH BUTTON  
Press it to switch from radio or tape mode to CD player or CD changer  
mode.  
1). When a disc is loaded in the disc compartment and the CD changer  
is not connected, the mode changes like this:  
Radio/Tape  
CD player  
CD player pause  
2). When a disc is not loaded in the CD player and the CD changer is  
connected, the mode changes like this:  
Radio/Tape  
CD changer  
CD changer pause  
3). When a disc is loaded in the CD player and the CD changer is  
connected, the mode changes like this:  
Radio/Tape  
CD player  
CD changer  
16. SCAN BUTTON  
In CD player mode, press it to search each song for 10 seconds, press  
it again to stop scanning and retain the song currently selected.  
In CD changer mode, press it to search each song for 10 seconds, press  
it again to search each disc for 10 seconds, press it thirdly to stop  
scanning and retain the disc currently selected.  
If you want to take CHASSIS out of the SLIDE BRACKET HOUSING,  
remove the PLASTIC OUTLINE away, then insert the two KEY PLATE  
into left and right side of chassis as above illustration.  
PRECAUTIONS AND MAINTENANCE  
17.RPT/METAL BUTTON  
In tape play mode, If a metal tape is used, press METAL button  
to make the player in metal play mode, and MTL is indicated on LCD.  
In CD player mode, press it to play the current track repeatedly. Press  
it again or eject the disc to cancel this mode.  
In CD changer mode, press it to play the current track repeatedly. Press  
it again to play the current disc repeatedly. Press it thirdly to cancel this  
mode.  
.1.This unit is designed for negative ground operation only. The equipment can  
be used safely, if the negative terminal of the battery is connected to the  
vehicle metal work.  
2.Do not use speakers of impedance less than 4 ohms; and allow the speaker  
wires to be shorted together when the unit is switched on.  
Otherwise it may overload or burn out the power amplifier stage.  
3.If the car interior is extremely hot, as after being parked in the sun, do not use  
the player until the car has been driven for a while to cool off the interior.  
4.Take care of your tape cassette to preserve the quality of the recordings. Do  
not allow them to be exposed to direct sunlight. Store them in a place  
protected from dirt and dust and avoid handing with greasy or oily hands.  
Also, keep the away from magnets, and motors of the permanent magnet type.  
5.It is not advisable to use cassette tapes longer than C-60(30 minutes per side)  
in automobile players, since the tape is too thin and tends to become easily  
entangled. Always remove cartridge from your tape player as soon as play is  
finished.  
6.The capstan and tape head should be cleaned about once every six months  
with a soft cloth or cotton-wool swab, moistened with alcohol.  
This will serve to maintain the richness and clarity of sound, and prevent loss  
of volume. Do not use a screwdriver, or ferrous metal rod , in carrying out the  
above cleaning. See illustration.  
18.RDM/PAUSE BUTTON  
In CD player mode, press it to play the track in random order. Press the  
TRACK + or - button to select another random track. Press it again or  
eject the disc to cancel this mode.  
In CD changer mode, press it to play tracks on the current disc in  
random order. Press it again to play tracks on the full disc in random  
order. Press it thirdly to cancel this mode.  
In tape mode, press it to pause tape playing, press it again to resume  
tape playing.  
20.RELEASE BUTTON  
Press it to detatch the front panel when you want to take it away.  
21.BAND BUTTON  
Press it to switch from tape, CD player or CD changer mode to radio, and  
the LCD screen will be shown as below:  
7.A loosely wound cassette tape will get damaged. Prior to using such tape,  
tighten it in a manner as guided by Fig. 2.A carelessly would cassette tape will  
cause unnecessary pressure on the tape resulting in the cassette springing out  
while the tape is running .For prevention, rewind the tape through fast for  
warding or rewinding.  
FM 1  
FM 2  
FM 3  
MW(AM) 1  
MW(AM) 2  
DISC PLAY:  
SPEAKER CONNECTION  
Cleaning discs:  
Before playing, clean the disc with a clean, lint-free.  
Flip the disc in the direction of the arrow.  
CDC SOCKET  
ANTENNA PLUG  
YELLOW  
WOOFER LINE OUT  
RCA LINE OUT  
MEMORY B+  
FUSED  
FILTER  
BOX  
0.5A &10A  
FUSES  
YELLOW  
BLACK(GND)  
RED (B+)  
RED R  
WHITE L  
1 A  
FUSE  
BLUE AUTO ANT  
+
+
FRONT  
GRAY  
WHITE  
FRONT  
NOTE:  
. Do not use so solvents such as benzine, thinners. Commercially available cleaners  
or anti static spray damage the unit.  
RIGHT  
SP  
WHITE/BLACK  
GREEN  
GRAY/BLACK  
VIOLET  
LEFT  
SP  
+
+
. Insert a disc with the label surface down. Doing so may damage the unit.  
REAR  
REAR  
GREEN/BLACK  
VIOLET/BLACK  
Label  
surface up  
NOTE:  
. Do not try to insert another disc when one has been already inserted. Doing so may  
damage the unit.  
. Handle the disc by its edge. And to keep the disc clean, do not touch the surface.  
.Do not stick paper or tape on the disc.  
.Do not expose the disc to direct sunlight or heat sources such as hot air ducts. Or  
leave it in a car parked in direct sunlight where there can be a considerable rise  
in temperature.  

HP Hewlett Packard vs15 User Manual
JVC AV 29Q317B AV 29RXP8 AV 29S357 AV 21Q317B AV 21R318 AV 21RXP8 AV 21S357 User Manual
JVC AV 32F475 User Manual
Lenovo L2251X User Manual
Lenovo ThinkVision L171 User Manual
Loewe Centros 1172 User Manual
Logitech USB Headset H390 User Manual
Manhattan Computer Products HI SPEED USB 2 0 160391 User Manual
Philips 29PT 8306 User Manual
Philips Computer Monitor 206V3L User Manual