KitchenAid Cooktop KGRT600H User Manual

®
30" Freestanding and Slide-In Gas Range  
PRODUCT MODEL NUMBERS  
OVERALL DIMENSIONS  
KGRT600H  
KGRT607H  
KGST300H  
KGST307H  
Slide-in Range  
IMPORTANT:  
Rear vent must be installed  
on all slide-in models for  
proper ventilation.  
1-1/2"  
(3.8 cm)  
30" (76.2 cm)  
rear vent width  
Gas supply: Use 3/4" rigid pipe gas supply  
line to the range location. A smaller size pipe on  
long runs may result in insufficient gas supply.  
With L.P. gas, piping or tubing size can be 1/2"  
minimum. If local codes permit, it is  
recommended that new flexible metal tubing,  
design-certified by AGA or CSA, 4-5 feet long,  
1/2-inch or 3/4-inch I.D., be used for connecting  
the range to the rigid gas supply line. A 1/2"  
male pipe thread is needed for connection to  
pressure regulator female pipe threads. An  
easily accessible individual manual shutoff valve  
must be located in the same room, but external  
to the range.  
Freestanding  
Range  
36-1/8"  
(91.8 cm)  
cooktop  
height  
30" (76.2 cm)  
range width  
8-1/4"  
(21 cm)  
36-1/8"  
(91.8 cm)  
cooktop  
height  
1"  
(2.54 cm)  
spacer  
44-3/8"  
(112.7 cm)  
30"  
(76.2 cm)  
width  
Electrical: 120-volt, 60 Hz, AC-only, 10 amp,  
electrical supply, fused on both sides of the line.  
A separate circuit is recommended. A time-delay  
fuse or circuit breaker is recommended.  
27-3/4"  
(70.5 cm)  
depth  
1"  
(2.54 cm)  
spacer  
with  
handle  
27-3/4"  
(70.5 cm)  
depth  
with  
handle  
SLIDE-IN RANGE COUNTERTOP PREPARATION  
The cooktop sides of the slide-in range fit over  
the cutout edge of your countertop.  
1/2" from each front corner and/or rounded  
edge flattened.  
30"  
(76.2 cm)  
opening  
width  
1/2"  
(1.3 cm)  
If you have a square finish (flat) countertop  
and the opening width is 30", no countertop  
preparation is required.  
If countertop opening width is greater than 30",  
adjust the 1/2" dimension.  
22-5/8"  
(57.5 cm)  
Countertop must be level. Place level on  
countertop, first side to side; then front to  
back. If countertop is not level, range will not  
be level. Oven must be level for satisfactory  
baking conditions.  
Formed front-edged countertops: Must have  
molded edge shaved flat 1/2" from each front  
corner of opening.  
30-7/8"  
(78.4 cm)  
Formed or tiled  
countertop trimmed  
1/2" (1.3 cm) back at  
front corners of  
Tile countertops may need trim cut back  
Cooktop sides of range fit over  
edges of countertop opening.  
countertop opening.  
CABINET OPENING DIMENSIONS  
25" countertop depth and 24" base cabinet depth,  
36" countertop height  
13" (33 cm) max.  
upper cabinet depth  
For minimum  
18" (45.7 cm)  
upper side cabinet  
to countertop  
clearance to  
cooktop, see  
30" (76.2 cm) cabinet  
opening width  
NOTE*  
.
Freestanding or Slide-in Range  
30" (76.2 cm)  
opening width  
4" (10.2 cm) min. clearance from  
both sides of range to side wall  
or other combustible material.  
18"  
(45.7 cm)  
9" (22.9 cm)  
6" (15.2 cm)  
Gas line opening  
3" (7.6 cm)  
should be located  
within this shaded area  
2-1/2"  
(6.4 cm)  
Floor gas line  
10" (25.4 cm)  
opening if directly  
below regulator  
2-1/2" (6.4 cm)  
2" (5.1 cm)  
Outlet should be  
located within the  
18" x 10"  
(45.7 x 25.4 cm)  
shaded area  
*
NOTE: 24" (61 cm) min. when bottom of wood or metal cabinet is  
protected by not less than 1/4" (6.4 mm) flame retardant millboard  
covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm)  
stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.  
24" (61 cm)  
7/8" (2.2 cm) min.  
30" (76.2 cm) min. clearance between the top of the cooking platform  
and the bottom of an unprotected wood or metal cabinet.  
required between  
cabinet opening and  
door or hinge opening  
Because Whirlpool Corporation policy includes a continuous commitment to improve  
our products, we reserve the right to change materials and specifications without notice.  
Dimensions are for planning purposes only. For complete details, see Installation  
Instructions packed with product. Specifications subject to change without notice.  
Ref. 9758571  
04-20-04  

IBM THINKCENTER 8191 User Manual
Intel Computer Hardware IP 4MTS6B User Manual
Intel Core I5 I5 3320m 2 60 Ghz Processor BX80638I53320M User Manual
JVC KD NX901 User Manual
Lincoln Impinger Conveyor Ovens 1450 User Manual
NEC A500 JC 1576VMB User Manual
Panasonic CT G2987L User Manual
Panasonic TC 25V70R User Manual
Philips 17GR2746 User Manual
Philips BDDl321V User Manual