Quick start guide
TL72108/TL72208/
TL72308/TL72408
5.8 GHz cordless
telephone/answering system
with caller ID/call waiting
Telephone base and charger installation
If you subscribe to high-speed Internet service (Digital Subscriber Line - DSL)
through your telephone lines, you must install a DSL filter between the
telephone base and the telephone wall jack. The filter will prevent noise
and caller ID problems caused by DSL interference. Please contact your DSL
service provider for more information about DSL filters.
Install the telephone base as shown below.
1. Plug the small
end of the larger
power adapter into
the power jack at
the bottom of the
telephone base.
2. Plug one end of
the telephone
D E S K
D E S K
line cord into the
telephone jack at
the bottom of the
telephone base.
W A L L
W A L L
3. Route cords
through slots.
Telephone
line cord
DSL filter (not included),
required if you have DSL high-
speed Internet service.
Power
adapter
4. Plug the large
end of the
larger power
Telephone
wall jack
adapter into a
power outlet not
controlled by a
wall switch.
5. Plug the other end
of the telephone line
cord into a telephone
jack.
Charger installation
1. Plug the small end
of the smaller power
adapter into the jack
on the underside of the
charger, then route the
cord through the slot
as shown.
2. Plug the large end
of the smaller power
adapter into a power
outlet not controlled
by a wall switch.
IMPORTANT INFORMATION
ꢀ. Use only the power adapter supplied with this product. To order a replacement
1 (800) 222-3111. In Canada dial 1 (866) 288-4268.
2. The power adapters are intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
2
Battery installation & charging
Install the battery as shown below. After installing the battery, you can make
and receive short calls, but replace the handset in the telephone base or
additional charger when not in use. For optimal performance, charge the
handset battery for at least ꢀ6 hours before use. When fully charged, the
handset battery provides approximately five hours of talk time or three days
of standby time.
If the battery is depleted, it may take approximately four minutes to charge
the handset before it can resume screen display. The screen will continue to
display LOW BATTERY until the battery has charged for approximately one
hour.
Step 2
Step 1
Plug the battery
securely into the plug
inside the handset
battery compartment,
matching the color-
coded label.
Step 3
Insert the supplied
battery with the label
THIS SIDE UP facing up
as indicated.
Align the cover flat
against the battery
compartment cover,
then slide it upwards
until it clicks into place.
Step 4
Charge the handset by placing the handset face up in
the telephone base or in the additional charger. The
CHARGE light will be on when charging.
IMPORTANT INFORMATION
Use only the battery supplied with this product. To order a replacement or spare battery (AT&T
model 279ꢀ0, part number 89-0099-00-00) or equivalent, visit our website at
1 (866) 288-4268.
ꢁ
Quick reference guide - handset
CHARGE
On when the handset is
charging in the telephone
base or charger.
Press
or
to scroll up
or down while in menus.
While entering names or
numbers, press
move the cursor to the left
or right.
CID
or
to
Press to display caller ID
information.
PHONE/FLASH
Press to make or answer
a call.
During a call, press to
receive an incoming call if
call waiting is activated.
MENU/SELECT
Press to enter the menu.
While in the menu, press to
select an item or save an
entry or setting.
DIR
REDIAL/PAUSE
Press to view redial
memory.
Press to display directory
entries.
While entering numbers,
press and hold to insert a
dialing pause.
VOLUME
Press the volume key on
the side of the handset to
adjust listening volume.
Each press of the button
increases or decreases the
volume.
MUTE/REMOVE
During a call, press to
mute microphone.
While reviewing the caller
ID history, press to delete
an individual entry, or
press and hold to clear
the caller ID history. While
predialing, press to delete
digits.
OFF/CLEAR
During a call, press to hang
up.
While using menus, press
to cancel an operation,
back up to the previous
menu, or exit the menu
display.
SPEAKER
INT
Press to turn on the
handset speakerphone.
Press again to resume
normal handset use.
Press to begin an intercom
conversation or to transfer
a call.
Feature menu
Using menus
Feature menu
Press
or
to scroll
DIRECTORY
CALL LOG
RINGER VOLUME
RINGER TONE
KEY TONE
The >
through menu items.
<DIRECTORY
CALL LOG
symbol
Press MENU/SELECT to select
or modify a highlighted item.
shows a
highlighted
menu item.
Press
OFF/CLEAR to cancel
an operation, back up to the
previous menu, or exit the
menu display.
LANGUAGE
CLR VOICE MAIL
ꢂ
Quick reference guide - telephone base
IN USE
VOICEMAIL
•
•
•
On when handset
Flashes when you have
is in use, when the
answering system is
answering an incoming
call or when you are
registering a handset.
new voicemail. Voicemail
is a service offered by
your local telephone
company, and is different
from answering system
messages.
Flashes when another
telephone is in use on
the same line or when
you are deregistering
handset(s) from the
telephone base.
HANDSET LOCATOR
Press so that handsets
will beep to locate
misplaced handsets.
Flashes quickly when
there is an incoming
call.
Answering System Functions
MESSAGE COUNTER
PLAY/STOP
Number of messages (or
during playback, message
number currently playing).
Press to start or stop
message playback.
X/DELETE
/REPEAT
Press to delete the
Press to repeat message.
Press twice to play
previous message.
message currently playing
When no messages are
playing, press twice to
delete all old messages.
ANSWER ON
Press to turn answering
system on or off.
/SKIP
Press to skip message.
CLOCK
Press to review or set
clock.
VOLUME
Press to adjust playback
volume.
SETUP
Press to hear and change
setup options.
RECORD
ANNC.
Press to record a memo
or, after pressing ANNC.,
to record an outgoing
announcement.
Press to review or record
outgoing announcement.
Press again to end
announcement playback
or recording.
ꢃ
© 2008 Advanced American Telephones. All rights reserved.
AT&T and the AT&T logo are trademarks of AT&T Intellectual Property II, L.P. d/b/a
AT&T Intellectual Property licensed to Advanced American Telephones.
Printed in China. Issue 2 AT&T 0ꢃ/08.
|