Sony VAIO VPCSB User Manual

VPCSB Series Hard Disk Drive  
Replacement Instructions  
IMPORTANT!  
PLEASE READ BEFORE YOU START  
These easy instructions will guide you through the Hard Drive replacement process.  
Before you begin, place your notebook computer on a clean or covered surface to avoid  
damage to the computer's case.*  
Follow the ESD (Electrostatic Discharge) damage prevention instructions:  
o Hold parts by the edges, away from exposed circuitry when possible.  
o Do not walk around excessively as this promotes static build-up.  
Before you begin, remove any jewelry you may be wearing to prevent scratches to the surface  
of your notebook computer.*  
The appearance of the electronic components shown in the illustrations may differ from the  
components shipped. This slight difference does not affect the accuracy of these instructions.  
* Sony is not responsible for damage caused by incorrect handling of the notebook computer.  
Prepare the Computer  
Battery Pack Removal  
CAUTION:  
Make  
sure  
the  
Step 1. Using the enclosed magnetic  
screwdriver, remove the two (2)  
NOTE: If your unit is configured with an  
Extended Battery Pack, it must be  
Computer is turned off, the lid is  
closed, and the AC Adapter is  
disconnected. Failure to do so can  
result in damage to the Computer.  
screws  
securing  
the  
Hard  
removed  
before  
beginning  
this  
Drive/Battery Door.  
procedure.  
Put the screws aside to re-secure  
the Door later in the procedure.  
Extended Battery Pack Removal  
Place the Computer upside down on a  
protected surface with the front edge  
facing you.  
1) Slide the “LOCK” battery tab up to  
the unlock position.  
2) Slide the “RELEASE” battery tab to  
the Right and hold.  
3) Rotate the battery up to remove.  
FOR TECHNICAL SUPPORT IN THE US CALL TOLL FREE 1-866-651-7669 FROM 9:00 AM TO 11:00 PM EST  
P/N 989202617 Rev. B 1/4  
VPCSB Series Hard Disk Drive  
Replacement Instructions  
Step 4. Arrange the Brackets & screws  
as shown above. Set the old HDD aside.  
Step 2. Re-install the four (4) Hard  
Drive Bracket screws to secure the  
Brackets to the New Hard Drive.  
HDD Reassembly  
Step 1. Place the new Hard Drive in the  
same position as the old Hard Drive so  
that it aligns with the Brackets as shown.  
Step 3. Re-install the HDD Cable to the  
Hard Drive by aligning the connectors.  
Step 2. Re-install the four (4) Hard  
Drive screws holding the Hard Drive  
assembly in place.  
HDD Reinstallation  
Step 1. Reseat the Hard Drive into the  
Hard Drive Bay.  
Note: The wide end of the Cable  
attaches to the Hard Drive at this step.  
FOR TECHNICAL SUPPORT IN THE US CALL TOLL FREE 1-866-651-7669 FROM 9:00 AM TO 11:00 PM EST  
P/N 989202617 Rev. B 3/4  
VPCSB Series Hard Disk Drive  
Replacement Instructions  
Step 3. Using two fingers, reinstall the  
HDD Cable to the unit by aligning the  
connectors, and then push straight down  
to seat.  
Step  
2.  
Re-attach  
the  
Hard  
Battery Reinstallation  
Drive/Battery Door by sliding up  
towards the unit. Verify the Door sits  
completely flush.  
Step 1. Reinstall the Battery into the  
Battery Bay.  
Step 4. Reconnect the AC Adaptor.  
Power on your computer and continue  
with the recovery process by following  
the instructions described on the back of  
the recovery disk’s case.  
Return the old Hard Drive to  
Sony using the included  
shipping instructions.  
Step 3. Re-install the two (2) Hard Drive  
Door screws to secure the Door.  
FOR TECHNICAL SUPPORT IN THE US CALL TOLL FREE 1-866-651-7669 FROM 9:00 AM TO 11:00 PM EST  
P/N 989202617 Rev. B 4/4  

Tannoy W395 User Manual
Sony Ericsson J110c User Manual
SonicWALL E6500 User Manual
Seagate SV35 SERIES ST3500410SV User Manual
Samsung SPINPOINT MP2 HM121HJ User Manual
RCA RIR205 User Manual
Pioneer DEH P7000BT User Manual
Pioneer CD Player DEH 1300MP User Manual
Palm TREOPROBLKSPT User Manual
Nokia 6300i User Manual