Sony MG MS User Manual

3-242-050-21 (1)  
3 A  
AUDIO OUT  
FRONT  
SUB OUT (MONO)  
MG-MS/FM/MW/LW  
Compact Disc  
Player  
AUDIO OUT  
REAR  
Installation/Connections  
安裝/線路連接  
B
BUS AUDIO IN  
BUS CONTROL IN  
BUS AUDIO IN  
Source selector*  
音源選擇器*  
XA-C30  
BUS CONTROL IN  
* not supplied  
非附送  
MEX-5DI  
Sony Corporation © 2002 Printed in Japan  
Cautions  
Parts Iist (2)  
121 mm  
142.5 mm  
1
This unit is designed for negative earth 12 V  
DC operation only.  
The numbers in the list are keyed to those in the  
instructions.  
Do not get the wires under a screw, or caught  
in moving parts (e.g. seat railing).  
Before making connections, turn the car  
ignition off to avoid short circuits.  
Connect the yellow and red power input leads  
only after all other leads have been connected.  
Run all earth wires to a common earth  
point.  
For the use of release key 9, see the supplied  
operating instructions.  
19 mm  
9.5 mm  
Caution  
59 mm  
170 mm  
Handle the bracket 1 carefully to avoid injuring  
your fingers.  
Dimensions include unit size, front panel and disc tray open, etc.  
所標出的尺寸包括主機尺寸、前面板尺寸和光碟托盤打開時的尺寸等。  
Be sure to insulate any loose unconnected  
wires with electrical tape for safety.  
TO  
P
Notes on the power supply cord (yellow)  
When connecting this unit in combination with  
other stereo components, the connected car  
circuit’s rating must be higher than the sum of  
each component’s fuse.  
1
4
2
5
3
6
TOP  
2
When no car circuits are rated high enough,  
connect the unit directly to the battery.  
Connection example (3)  
Note (3-A)  
Be sure to connect the earth cord before connecting  
the amplifier.  
Tip (3-B-  
)
Before installation (1)  
For connecting two or more CD/MD changers, the  
source selector XA-C30 (optional) is necessary.  
× 4  
× 2  
Do not install the unit where its operation  
interferes with driving.  
7
8
9
Example:  
— Opening and closing of the front panel or  
disc tray interfere with operation of the gear  
shift.  
— With the front panel open, operation of  
hazard lamps, switches etc., is impaired.  
Equipment used in illustrations (not supplied)  
插圖中的裝置(非附送)  
Front speaker  
前揚聲器  
Power amplifier  
功率放大器  
Rear speaker  
後揚聲器  
CD/MD changer  
CD/MD 換碟機  
Active subwoofer  
有源超低音揚聲器  
5
1
*
182 mm  
53 mm  
8
TOP  
1
with the TOP marking up  
要使帶 TOP 標記面朝上  
Dashboard  
儀表板  
Fire wall  
防火壁  
2
3
4
TOP  
1
4
5
6
2
5
6
Bend these claws outward  
for a tight fit, if necessary.  
若有必要,則可向外彎曲這些卡爪,以便牢  
固安裝。  
3
6
5
Precautions  
Warning when installing in a car  
without ACC (accessory)  
position on the ignition key  
switch  
使用前注意事項  
安裝在點火鑰匙開關上沒有 ACC  
(輔助)位置的汽車上時的警告  
Choose the installation location carefully so  
that the unit will not interfere with normal  
driving operations.  
Avoid installing the unit in areas subject to  
dust, dirt, excessive vibration, or high  
temperatures, such as in direct sunlight or near  
heater ducts.  
請仔細選擇安裝位置,以使本機不妨礙正常的駕  
駛操作。  
避免將本機安裝在多塵、髒亂、極易受震動的地  
方,或者高溫之處,如陽光直射處或暖氣機前。  
為了安全起見,安裝時請使用附送的部件。  
在關掉汽車引擎之後,一定請按下機器上的  
(OFF) 兩秒以關掉時鐘顯示。  
如果只短暫地按一下 (OFF),將不會關掉時鐘顯  
示而浪費電池。  
Be sure to press (OFF) on the unit for two  
seconds to turn off the clock display after  
turning off the engine.  
When you press (OFF) only momentarily, the  
clock display does not turn off and this causes  
battery wear.  
安裝角度之調整  
Use only the supplied mounting hardware for  
a safe and secure installation.  
請在 30 度以內調整安裝角度。  
復原按鈕  
Mounting angle adjustment  
Adjust the mounting angle to less than 30°.  
當安裝和連接完成後,務請用圓珠筆等按壓復原按  
鈕。  
安裝示例(5)  
安裝在儀錶板裡  
Reset button  
安裝時,必須關閉本裝置的前面板,並裝上前面板  
8。(5- )  
Mounting example (5)  
When the installation and connections are  
completed, be sure to press the reset button with  
a ballpoint pen, etc.  
*
Installation in the dashboard  
切勿直接按壓液晶顯示幕。顯示幕會破碎並造成手  
指受傷。在安裝本裝置時,必須裝上附送的前面  
板蓋 8。  
When installing this unit, be sure to close the  
front panel of the unit and attach the front  
切勿拿著前面板或光碟托架進行安裝,否則會損  
壞裝置或造成故障。  
panel cover 8. (5- )  
*
本裝置在首次設定過程中會產生一些噪音,這是正常現象。  
Do not push the LCD display directly. The  
display may break and cause injury to your  
fingers. When installing the unit, be sure to  
attach the supplied front panel cover 8.  
Do not hold the unit by its front panel or disc  
tray when installing as this can damage the  
unit, or cause malfunction.  
將本機安裝於日本產汽車上時  
6)  
Note  
The unit makes some noise during the initial  
settings, this is not a malfunction.  
有的日本產汽車不能安裝本機,在這種情形下,請  
您向當地的 Sony 經銷商諮詢。  
為防止發生故障,安裝時只能使用附送的螺絲 5。  
Mounting the unit in a Japanese  
car (6)  
You may not be able to install this unit in some  
makes of Japanese cars. In such a case, consult  
your Sony dealer.  
Note  
To prevent malfunction, install only with the  
supplied screws 5.  
6
A TOYOTA  
B NISSAN  
5
5
max. size  
max. size  
5 × 8 mm  
5 × 8 mm  
最大尺寸  
5×8 mm  
最大尺寸  
5×8 mm  
to dashboard/centre console  
至儀表板/中央控制箱  
to dashboard/centre console  
至儀表板/中央控制箱  
5
max. size  
5 × 8 mm  
Bracket  
托架  
5
max. size  
5 × 8 mm  
Bracket  
托架  
最大尺寸  
5×8 mm  
最大尺寸  
5×8 mm  
Bracket  
托架  
Bracket  
托架  
Existing parts supplied with your car  
隨汽車附送的部件  
Existing parts supplied with your car  
隨汽車附送的部件  

Seagate ST305004EXB101 RK User Manual
Sanyo SAC MST6 User Manual
Samsung SGH T500 User Manual
Samsung SGH A257 User Manual
Samsung SGH A167 User Manual
Samsung Cell Phone CRT_SCH R730 User Manual
Pioneer DEX P90RS User Manual
OtterBox Cell Phone Accessories 8700 User Manual
Numark Industries MX25 User Manual
Nokia RAE 3N User Manual