Sony ICFC1IP User Manual

Important Safety Instructions  
1) Read these instructions.  
2) Keep these instructions.  
3) Heed all warnings.  
4) Follow all instructions.  
5) Do not use this apparatus near water.  
6) Clean only with dry cloth.  
7) Do not block any ventilation openings.  
Install in accordance with the manufacturer’s  
instructions.  
8) Do not install near any heat sources such as  
radiators, heat registers, stoves, or other apparatus  
(including amplifiers) that produce heat.  
9) Do not defeat the safety purpose of the polarized  
or grounding-type plug. A polarized plug has two  
blades with one wider than the other. A grounding  
type plug has two blades and a third grounding  
prong. The wide blade or the third prong are  
provided for your safety. If the provided plug does  
not fit into your outlet, consult an electrician for  
replacement of the obsolete outlet.  
10) Protect the power cord from being walked on or  
pinched particularly at plugs, convenience  
receptacles, and the point where they exit from the  
apparatus.  
Owner’s Record  
The model number and the serial number are located  
on the rear exterior.  
Record the serial number in the space provided below.  
Refer to them whenever you call upon your Sony  
dealer regarding this product.  
3-272-042-11(2)  
Precautions  
Connecting the  
antenna  
• Operate the unit on the power sources specified in  
“Specifications” .  
• To disconnect the power cord (mains lead), pull it  
out by the plug, not the cord.  
• The unit is not disconnected from the AC power  
source (mains) as long as it is connected to the wall  
outlet, even if the unit itself has been turned off.  
• Do not leave the unit in a location near a heat  
source, such as a radiator or airduct, or in a place  
subject to direct sunlight, excessive dust,  
mechanical vibration, or shock.  
• Allow adequate air circulation to prevent internal  
heat build-up. Do not place the unit on a surface (a  
rug, blanket, etc.) or near materials (a curtain) that  
might block the ventilation holes.  
To connect the AM loop  
antenna  
Model No. ICF-C1iP  
Serial No.  
The shape and the length of the antenna is designed to  
receive AM signals. Do not dismantle or roll up the  
antenna.  
For customers who purchased this product in the  
USA  
1 Remove only the loop part from the plastic  
stand.  
2 Set up the AM loop antenna.  
Please register this product on line at  
Proper registration will enable us to send you  
periodic mailings about new products, services,  
and other important announcements. Registering  
your product will also allow us to contact you in  
the unlikely event that the product needs  
adjustment or modification. Thank you.  
FM/AM Clock Radio  
ICF-C1iP  
• Should any solid object or liquid fall into the unit,  
unplug the unit and have it checked by qualified  
personnel before operating it any further.  
• To clean the casing, use a soft cloth dampened with  
a mild detergent solution.  
3 Connect the cords to the AM antenna  
terminals.  
Operating Instructions  
NOTES ON LITHIUM BATTERY  
• Wipe the battery with a dry cloth to assure a good  
contact.  
• Be sure to observe the correct polarity when  
installing the battery.  
WARNING  
The cords (A and B) can be connected to either  
terminal.  
To reduce the risk of fire or electric shock, do  
not expose this apparatus to rain or moisture.  
To reduce the risk of electrical shock, do not  
open the cabinet. Refer servicing to qualified  
personnel only.  
To reduce the risk of fire, do not cover the ventilation  
of the apparatus with newspapers, tablecloths,  
curtains, etc. And do not place lighted candles on the  
apparatus.  
11) Only use attachments/accessories specified by the  
manufacturer.  
Insert the cord while  
pushing down the  
terminal clamp.  
12) Use only with the cart, stand, tripod, bracket, or  
table specified by the manufacturer, or sold with  
the apparatus. When a cart is used, use caution  
when moving the cart/apparatus combination to  
avoid injury from tip-over.  
• Do not hold the battery with metallic tweezers,  
otherwise a short-circuit may occur.  
If you have any questions or problems  
concerning your unit, please consult your  
nearest Sony dealer.  
Only insert up  
to here.  
The apparatus shall not be exposed to dripping or  
splashing and that no objects filled with liquids, such  
as vases, shall be placed on the apparatus.  
B
A
Specifications  
Do not install the appliance in a confined space, such  
as a bookcase or built-in cabinet.  
13) Unplug this apparatus during lightning storms or  
when unused for long periods of time.  
Time display  
12-hour System  
As the main plug is used to disconnect the unit from  
the mains, connect the unit to an easily accessible AC  
outlet. Should you notice an abnormality in the unit,  
disconnect the main plug from the AC outlet  
immediately.  
14) Refer all servicing to qualified service personnel.  
Servicing is required when the apparatus has been  
damaged in any way, such as power-supply cord  
or plug is damaged, liquid has been spilled or  
objects have fallen into the apparatus, the  
Dream Machine is a trademark of Sony Corporation.  
Frequency range  
4 Make sure the AM loop antenna is  
Band  
FM  
Frequency  
connected firmly by pulling softly.  
87.5 – 108 MHz  
530 – 1 710 kHz  
AM  
apparatus has been exposed to rain or moisture,  
does not operate normally, or has been dropped.  
Adjusting the AM loop antenna  
Find a place and an orientation that provide good  
reception.  
• Do not place the AM loop antenna near the unit or  
other AV equipment, as noise may result.  
• If you use an external polarized AM antenna, be  
You are cautioned that any changes or  
modifications not expressly approved in this manual  
could void your authority to operate this equipment.  
Speaker  
No Power No problem is a trademark of Sony Corporation.  
Approx. 5.1 cm (2 inches) dia., 12  
For the state of california, USA only  
Power output  
Perchlorate Material –special handling may apply, See  
Perchlorate Material: Lithium battery contains  
perchlorate  
3 W + 3 W (at 10% harmonic distortion)  
Power requirements  
sure to connect the ground cord to the terminal.  
U
120 V AC, 60 Hz  
For clock backup: 3 V DC, one CR2032 battery  
The supplied AM antenna cord has no polarity.  
Tip  
Dimensions  
Adjust the direction of the AM loop antenna for best  
AM broadcast sound.  
Approx. 300 × 130 × 139 mm (w/h/d)  
(11 13/16 × 5 1/6 × 5 1/2 inches) incl. projecting parts  
and controls  
Features  
© 2007 Sony Corporation Printed in China  
• Dual alarm FM/AM Clock radio with iPod dock.  
Various type of alarms- iPod, radio and buzzer.  
Mass  
• Automatic time set — When you plug the clock in  
for the first time, the current time will be shown in  
the display.  
Approx. 1.86 kg (4 lb 1.61 oz) incl. CR2032  
battery  
This symbol is intended to alert the  
user to the presence of uninsulated  
“dangerous voltage” within the  
product’s enclosure that may be of  
sufficient magnitude to constitute a  
risk of electric shock to persons.  
Supplied accessories  
Remote commander (1)  
Audio connecting cable (1)  
AM loop antenna (1)  
• Automatic Daylight Saving Time/Summer time  
adjustment.  
• CLOCK button to display month, day and year.  
• Brightness control (High/Middle/Low).  
• No Power No Problemalarm system to keep the  
clock and the alarm operating during a power  
interruption with a CR2032 battery installed.  
Design and specifications are subject to change  
without notice.  
This symbol is intended to alert the  
user to the presence of important  
operating and maintenance (servicing)  
instructions in the literature  
accompanying the appliance.  
Troubleshooting  
Should any problem occur with the unit, make the  
following simple checks to determine whether or not  
servicing is required.  
INFORMATION  
If the problem persists, consult your nearest Sony  
dealer.  
This equipment has been tested and found to comply  
with the limits for a Class B digital device, pursuant to  
Part 15 of the FCC Rules. These limits are designed to  
provide reasonable protection against harmful  
interference in a residential installation. This  
equipment generates, uses and can radiate radio  
frequency energy and, if not installed and used in  
accordance with the instructions, may cause harmful  
interference to radio communications. However, there  
is no guarantee that interference will not occur in a  
particular installation. If this equipment does cause  
harmful interference to radio or television reception,  
which can be determined by turning the equipment off  
and on, the user is encouraged to try to correct the  
interference by one or more of the following  
measures:  
The clock displays “AM 12:00” due to a  
power interruption.  
• The battery is low. Replace the battery. Remove the  
old battery and install a new one.  
When daylight saving time begins, the clock  
does not employ the daylight saving time  
automatically.  
• Make sure the clock is set correctly.  
• Press and hold CLOCK and TIME ZONE/ALARM  
DISPLAY simultaneously for at least two seconds  
to employ the DST function.  
The alarm does not sound at the preset alarm  
time.  
• Has the desired alarm been activated? (i.e., Does the  
ALARM A (or B) indicator light up?)  
— Reorient or relocate the receiving antenna.  
— Increase the separation between the equipment  
and receiver.  
— Connect the equipment into an outlet on a  
circuit different from that to which the receiver  
is connected.  
The radio or iPod alarm is activated but no  
sound comes on at the preset alarm time.  
• Has VOLUME been adjusted?  
— Consult the dealer or an experienced radio/TV  
technician for help.  
There is no sound from the iPod.  
• Make sure the iPod is securely connected.  
• Adjust the VOLUME.  
WARNING  
• Danger of explosion if battery is incorrectly  
replaced. Replace only with the same or equivalent  
type.  
The iPod cannot be operated with this unit.  
• Make sure the iPod is securely connected.  
• Replace the battery for the clock backup with a  
Sony CR2032 lithium battery, and the battery for the  
remote commander with a Sony CR2025 lithium  
battery. Use of another battery may present a risk of  
fire or explosion.  
The iPod cannot be charged.  
• Make sure the iPod is securely connected.  
• Battery may explode if mistreated. Do not recharge,  
disassemble or dispose of in fire.  
• Do not expose the battery to excessive heat such as  
direct sunlight, fire or the like.  
• Dispose of used battery promptly. Keep away from  
children.  
This unit includes a preinstalled Sony Lithium battery (CR2032) as back-up power source for the clock, which is preset  
to EST/EDT (Eastern Standard Time/Daylight Time) at the factory. And this battery is considered part of the product.  

WatchGuard Technologies Xtm 1520 Ha Livesec WG152071 User Manual
Wagan Coffee Genie User Manual
Sprint Nextel LX350 User Manual
Sony Ericsson XPERIA ACRO IS11S User Manual
Silvercrest KH 2189 User Manual
Seagate BARRACUDA ST3500841AS User Manual
Samsung Spinpiont HD403LJ User Manual
Samsung MD65C User Manual
Philips AJ3740 User Manual
Omnimount WS 1 User Manual