Sony Dream Machine 3 873 060 34(1) User Manual

3-873-060-34(1)  
A
B
1
RESET  
FM/AM Clock Radio  
ICF-C1iPMK2  
Operating Instructions  
2
There is a tactile dot on the VOL +,  
N/X, M and PRESET + button.  
RESET  
1
FM wire aerial  
AC power cord  
CR2032  
Dream Machine is a trademark of Sony Corporation.  
3
2
No Power No Problem is a trademark of Sony Corporation.  
T
RESE  
CR2025  
There is a tactile dot on the VOLUME +, N/X and PRESET TUNING 3 button.  
©2008 Sony Corporation Printed in China  
Disposal of waste batteries  
3 Insert the battery compartment back into the  
unit and secure it with the screw.  
(See Fig. A-3)  
WARNING  
(applicable in the  
Precautions  
Connecting the  
About the backup  
battery  
European Union and other  
• Operate the unit on the power source specified in  
“Specifications”.  
To reduce the risk of fire or electric shock, do  
not expose this apparatus to rain or moisture.  
To reduce the risk of fire, do not cover the ventilation  
of the apparatus with newspapers, tablecloths,  
curtains, etc. And do not place lighted candles on the  
apparatus.  
The apparatus shall not be exposed to dripping or  
splashing and no objects filled with liquids, such as  
vases, shall be placed on the apparatus.  
European countries with  
separate collection  
systems)  
aerial  
Note  
• To disconnect the power cord (mains lead), pull it  
out by the plug, not the cord.  
• The unit is not disconnected from the AC power  
source (mains) as long as it is connected to the wall  
outlet, even if the unit itself has been turned off.  
• Allow adequate air circulation to prevent internal  
heat build-up. Do not place the unit on a surface (a  
rug, blanket, etc.) or near materials (a curtain) that  
might block the ventilation holes.  
• Should any solid object or liquid fall into the unit,  
unplug the unit and have it checked by a qualified  
personnel before operating it any further.  
• To clean the casing, use a soft cloth dampened with  
a mild detergent solution.  
• Do not connect the aerial lead to the external aerial.  
• To reduce the risk of fire, do not cover the  
ventilation of the apparatus with newspapers,  
tablecloths, curtains, etc. And do not place lighted  
candles on the apparatus.  
To keep good time, as a backup power source, this  
unit has one CR2032 battery inside of the unit in  
addition to the house current.  
To connect the AM loop  
When you replace the battery, keep the AC plug  
connected to a wall outlet. Otherwise, current time  
and alarms will be initialized if the replacement is not  
completed within around one minute.  
aerial  
This symbol on the battery or on the packaging  
indicates that the battery provided with this product  
shall not be treated as household waste.  
By ensuring these batteries are disposed of correctly,  
you will help prevent potentially negative conse-  
quences for the environment and human health which  
could otherwise be caused by inappropriate waste  
handling of the battery. The recycling of the materials  
will help to conserve natural resources.  
The battery keeps the clock and the alarm operating in  
the event of a power interruption.  
Note that the backlight will not light up during a  
power interruption.  
The shape and the length of the aerial is designed to  
receive AM signals. Do not dismantle or roll up the  
aerial.  
If the time in the display is  
incorrect after the battery  
is changed (RESET)  
1 Remove only the loop part from the plastic  
stand.  
2 Set up the AM loop aerial.  
Do not install the appliance in a confined space, such  
as a bookcase or built-in cabinet.  
Note for customers in the UK  
The clock is preset at the factory, and its memory is  
powered by the preinstalled Sony CR2032 battery. If  
the “AM 12:00” appears in the display when the unit  
is connected to AC outlet for the first time, the battery  
may be weak. In this case, consult a Sony dealer. The  
preinstalled CR2032 battery is considered part of the  
product, and is covered by the warranty.  
You are required to show “Note for customers in the  
UK” (in this instruction) to a Sony dealer in order to  
validate the warranty for this product.  
As the main plug is used to disconnect the unit from  
the mains, connect the unit to an easily accessible AC  
outlet. Should you notice an abnormality in the unit,  
disconnect the main plug from the AC outlet  
immediately.  
Push the Reset switch with the pointed device. The  
Reset switch is in the small hole located in the battery  
compartment.  
In case of products that for safety, performance or  
data integrity reasons require a permanent connection  
with an incorporated battery, this battery should be  
replaced by qualified service staff only. To ensure that  
the battery will be treated properly, hand over the  
product at end-of-life to the applicable collection  
point for the recycling of electrical and electronic  
equipment.  
Notes  
You cannot reset unless the lithium battery is  
installed.  
• Set the clock again after the unit is reset.  
Notice for the customer in the countries  
applying EU Directives  
3 Connect the cords to the AM aerial  
The manufacturer of this product is Sony Corporation,  
1-7-1 Konan, Minato-ku, Tokyo, Japan. The  
Authorized Representative for EMC and product  
safety is Sony Deutschland GmbH, Hedelfinger  
Strasse 61, 70327 Stuttgart, Germany. For any service  
or guarantee matters please refer to the addresses  
given in separate service or guarantee documents.  
terminals.  
Battery Warning  
For all other batteries, please view the section on how  
to remove the battery from the product safely. Hand  
the battery over to the applicable collection point for  
the recycling of waste batteries.  
The cords (A and B) can be connected to either  
terminal.  
When the unit will be left unplugged for a long time,  
remove the battery to avoid undue battery discharge  
and damage to the unit from battery leakage.  
Knowing when to replace  
the battery  
If the battery runs out during the interruption, the  
current time and alarm functions will be initialized.  
NOTES ON LITHIUM BATTERY  
• Wipe the battery with a dry cloth to assure a good  
contact.  
• Be sure to observe the correct polarity when  
installing the battery.  
Insert the cord while  
pushing down the  
terminal clamp.  
For more detailed information about recycling of this  
product or battery, please contact your local Civic  
Office, your household waste disposal service or the  
shop where you purchased the product.  
• Do not hold the battery with metallic tweezers,  
otherwise a short-circuit may occur.  
Preparing the  
WARNING  
Replace the battery with a Sony CR2032 lithium  
battery. Use of another battery may present a risk of  
fire or explosion.  
• Danger of explosion if battery is incorrectly  
replaced. Replace only with the same or equivalent  
type.  
• Replace the battery for the clock backup with a  
Sony CR2032 lithium battery, and the battery for the  
remote commander with a Sony CR2025 lithium  
battery. Use of another battery may present a risk of  
fire or explosion.  
• Battery may explode if mistreated. Do not recharge,  
disassemble or dispose of in fire.  
• Do not expose the batteries (battery pack or  
batteries installed) to excessive heat such as  
sunshine, fire or the like for a long time.  
remote commander  
Disposal of Old Electrical &  
Electronic Equipment  
(Applicable in the European  
Union and other European  
countries with separate  
collection systems)  
Before using the card remote commander for the first  
If you have any questions or problems  
concerning your unit, please consult your  
nearest Sony dealer.  
Only insert up  
time, remove the insulation film. (See Fig. B-1)  
to here.  
Replacing the backup  
battery  
B
A
When to replace the battery  
1 Keep the AC plug connected to the AC  
outlet, remove the screw that secures the  
battery compartment at the bottom of the  
unit using a screwdriver, and remove the  
battery compartment. (See Fig. A-1)  
2 Insert a new battery in the battery  
With normal use, the battery (CR2025) should last for  
about six months. When the remote commander no  
longer operates the unit, replace the battery with new  
ones. (See Fig. B-2)  
Features  
This symbol on the product or on its packaging  
indicates that this product shall not be treated as  
household waste. Instead it shall be handed over to the  
applicable collection point for the recycling of  
electrical and electronic equipment. By ensuring this  
product is disposed of correctly, you will help prevent  
potential negative consequences for the environment  
and human health, which could otherwise be caused  
by inappropriate waste handling of this product. The  
recycling of materials will help to conserve natural  
resources. For more detailed information about  
recycling of this product, please contact your local  
Civic Office, your household waste disposal service  
or the shop where you purchased the product.  
• Dual alarm FM/AM Clock radio with iPod dock.  
Various type of alarms- iPod, radio and buzzer.  
4 Make sure the AM loop aerial is connected  
• Automatic time set — When you plug the clock in  
for the first time, the current time will be shown in  
the display.  
• Automatic Daylight Saving Time/Summer time  
adjustment.  
• CLOCK button to display month, day and year.  
• Brightness control (High/Middle/Low).  
• No Power No Problemalarm system to keep the  
clock and the alarm operating during a power  
interruption with a CR2032 battery installed.  
Notes  
firmly by pulling softly.  
• Do not charge the battery.  
• When you are not going to use the remote  
commander for a long time, remove the battery to  
avoid any damage caused by leakage and corrosion.  
compartment with the e side facing up.  
To remove the battery from the battery  
compartment, push it out from the side marked  
PUSH. (See Fig. A-2)  
• Dispose of used battery promptly. Keep away from  
children.  
Adjusting the AM loop aerial  
Find a place and an orientation that provide good  
reception.  
• Do not place the AM loop aerial near the unit or  
other AV equipment, as noise may result.  
• If you use an external polarized AM aerial, be sure  
to connect the ground cord to the terminal. The  
U
supplied AM aerial cord has no polarity.  
Tip  
Adjust the direction of the AM loop aerial for best  
AM broadcast sound.  

Toshiba XM 6802B User Manual
Toastmaster MECF5 User Manual
Sunbeam Programmable Coffemaker 6397 User Manual
Sunbeam Coffeemaker ARX23 User Manual
Seagate BARRACUDA GREEN ST1500DL003 User Manual
Samsung SW 206 User Manual
Samsung SGH E610 User Manual
Samsung SGH D806 User Manual
Philips AJ290 User Manual
Optimus 14 546A User Manual