USER’S GUIDE
V:1036-0209-10
ICP200B
Clock Radio for iPhone/iPod
fcc Warnings
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equip-
ment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
•
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for
help.
additional Warnings
•
The apparatus shall not be exposed to dripping or splashing and
that no objects filled with liquids, such as vases, shall be placed
on apparatus.
L’appareil ne doit pas être exposé aux écoulements ou aux écla-
boussures et aucun objet ne contenant de liquide, tel qu’un vase,
ne doit être placé sur l’objet.
•
Main plug is used as disconnect device and it should remain
readily operable during intended use. In order to disconnect the
apparatus from the mains completely, the mains plug should be
disconnected form the mains socket outlet completely.
La prise du secteur ne doit pas être obstruée ou doit être facile-
ment accessible pendant son utilisation. Pour être complètement
déconnecté de l’alimentation d’entrée, la prise doit être débran-
chée du secteur.
•
•
Battery shall not be exposed to excessive heat such as sunshine,
fire or the like.
Les piles ne doivent pas être exposées à de forte chaleur, tel qu’à
la lumière du soleil, au feu ou autres choses de semblable.
The marking information is located on the bottom of apparatus.
Les précautions d’emploi sont inscrites en bas de l’appareil.
CUstOmeR HeLPLINe | 1-314-621-2881
iLive | ICP200B
3
clock radio With dock for iPod and iPhone
features
• Works with iPhone
• Made for iPod
• FM radio
• Station memory presets (20 FM)
• Dual alarms
• Digital clock
• Snooze
• Sleep timer
• Wake to iPhone/iPod, radio, or buzzer
• Gradual wake
• Line input (3.5mm)
• Video output
• Basic iPhone/iPod controls
• Built-in speakers
• White dot-matrix display
• Supports Universal docking brackets
• DC power input: requires an AC/DC power adapter (included)
• Battery backup
included
• ICP200B
• Docking brackets for iPhone/iPod (5)
• AC/DC power adapter
4
iLive | ICP200B
taBle of contents
introduction
6
setuP
8
iPod/iPhone and radio
9
clock and alarms
other
10
11
12
comPany information
CUstOmeR HeLPLINe | 1-314-621-2881
iLive | ICP200B
5
introduction
Play/Pause
Press to play or pause a
docked iPhone or iPod.
clock/alarm set
In off mode, press to set
the clock. In on mode,
press to set the alarm.
sleeP
Press repeatedly to set
the sleep timer.
mem
Press and hold to save
the current radio station
as a preset. Press to
cycle through current
radio presets.
PoWer/source
Press to power the clock
radio on. Press and hold
to power the clock radio
off. While on, press to
switch between Radio,
iPod, and AUX modes.
dock for iPod/iPhone
Plays and charges a
docked iPhone or iPod.
alarm
Press to activate alarm 1
or alarm 2.
POWER/
SOURCE
CLOCK/ALARM
SET
SLEEP
PLAY/PAUSE
MEM
ALARM
– TUNE/HR +
VOLUME/MIN
SNOOZE/DIM
skiP/search/
tuning/hr
snooZe/dim
After the alarm sounds,
press to delay the alarm
for an additional 10
minutes.
Volume/min (+/-)
Press to adjust the
volume. Press to adjust
the minute when
setting the time or
alarm time.
Press to skip between
tracks on a docked
iPhone or iPod. Press
and hold to search
through an individual
track on a docked
iPhone or iPod.
Press to tune the FM
radio. Press to adjust
the hour when setting
the time or alarm time.
6
iLive | ICP200B
reset
Video outPut
Use to output video
form a docked iPhone
or iPod to a connected
television.
fm antenna
Press to reset the clock
radio to it’s original
settings.
dc PoWer inPut
auXiliary inPut
Use to connect an MP3
player to the clock
radio.
CUstOmeR HeLPLINe | 1-314-621-2881
iLive | ICP200B
7
setuP
PoWer
Plug the included AC/DC power
adapter into the DC POWER
INPUT on the clock radio and an
AC power outlet to power the
clock radio
BackuP Battery
Requires 2 AAA batteries (not
included)
The backup battery is meant for
short-term power outages.
The clock radio cannot run off of
the backup alone.
8
iLive | ICP200B
iPod/iPhone and radio
tuning the fm radio
docking an iPhone or iPod
1
2
3
Press the PoWer/source button
to power on the clock radio.
1 Locate the numbered bracket
that fits the iPod/iPhone
model that will be docked.
Each included bracket has a
number on it, indicating which
iPod/iPhone model that bracket
is compatible with. See the
Press the PoWer/source button
to switch to RADIO mode.
Press the skiP/search/tuning/
hr buttons to tune the FM radio.
saVing a Preset
separate bracket chart page to
identify which bracket is needed.
1
Follow the instructions for TUNING
THE FM RADIO.
2 Snap the bracket into
place over the iPod/iPhone
connector in the dock for iPod/
iPhone.
3 Connect the iPhone or iPod to
the connector inside the Dock
for iPod.
When the speaker is plugged
in, using AC power, the docked
iPod/iPhone will charge.
2
Tune to the desired station, and
press and hold the mem button.
The preset channel number will begin
to blink.
3
4
Press the mem button to select a
preset channel to save the current
radio station to.
Press and hold the mem button to
save the current radio station to the
selected preset channel.
listening to a Preset
Playing an iPhone or iPod
1
Follow the instructions for SAVING
A PRESET.
1 Follow the instructions for
DOCKING AN iPod.
2
Press the mem button to cycle
through FM radio presets.
2 Press the PoWer/source
button to switch to iPod mode.
3 Press the Play/Pause button
to begin playing music from
the docked iPhone or iPod.
CUstOmeR HeLPLINe | 1-314-621-2881
iLive | ICP200B
9
clock and alarms
setting the clock
setting the alarms
1
Press and hold the
PoWer/source
button to power the
clock radio off.
1
Press the PoWer/source button to power the
clock radio on.
2
Press the clock/alarm set button.
The time on the display will begin to blink and AL1
will appear to indicate you are setting alarm 1.
2
3
Press the clock/
alarm set button.
3
4
Press the PoWer/source button to switch
between waking to iPod, Radio, or Buzzer.
Press the skiP/
search/tuning/
hr buttons to adjust
the hour. Press
the Volume/min
buttons to adjust the
minute.
Press the skiP/search/tuning/hr buttons to
adjust the hour. Press the Volume/min buttons
to adjust the minute.
5
Press the clock/alarm set button.
The time on the display will begin to blink and AL2
will appear to indicate you are setting alarm 2.
4
Press the clock/
alarm set button
to finish setting the
clock and alarms.
6
7
Press the PoWer/source button to switch
between waking to iPod, Radio, or Buzzer.
Press the skiP/search/tuning/hr buttons to
adjust the hour. Press the Volume/min buttons
to adjust the minute.
8
9
Press the clock/alarm set button to set the
volume.
The volume indicator on the display will begin
flashing.
Press the clock/alarm set button to finish
setting the alarms.
actiVating the alarms
1
2
3
Follow the instructions for SETTING THE CLOCK
AND ALARMS.
Press the PoWer/source button to turn the
clock radio off.
Press the alarm button repeatedly to activate
alarm 1, alarm 2, or both alarms.
When the AL1 or AL2 indicator appears on the
display, that alarm is active and will sound at the set
alarm time.
10 iLive | ICP200B
other
using the auX inPut
sleeP timer
1
With the clock radio powered
on and playing, press the sleeP
button repeatedly to set the sleep
timer.
1
Connect an MP3 player or other
audio source to the auXiliary
inPut using a 3.5mm line input
cable (not included).
2
After the set amount of time
has expired, the clock radio will
automatically power off.
2
3
Press the PoWer/source button
to switch to AUX mode.
Use the connected MP3 player
or other audio source’s native
controls to play music through the
boombox.
setting the dimmer
1
Press the snooZe/dim button
repeatedly to adjust the brightness
of the display.
using the Video outPut
1
Connect a television to the Video
outPut using a RCA video cable
(not included).
2
Adjust the connected television
to the input setting used when
connecting the television to the
clock radio.
3
4
Adjust the settings on your iPod or
iPhone to allow TV OUT.
Video played from a docked iPhone
or iPod will now play through the
connected television.
CUstOmeR HeLPLINe | 1-314-621-2881
iLive | ICP200B 11
comPany information
green initiatiVe
environmental Commitment to ‘Protect for
today and sustain for tomorrow’
2009 marked the official launch of DPI, Inc.’s
corporate campaign for a greener and cleaner
world. DPI is building upon environmental
initiatives introduced at all of their facilities to help
formulate and sustain significant and important
conservation efforts within its manufacturing and
marketing communities. In addition to targeting
and selecting energy efficient product features, and
structuring ‘green office’ procedures, other initial
program efforts include:
•
•
Reduction of all packaging sizes
Recyclable plastics for clamshell packages,
with a plan to eventually replace plastic with
recyclable paper
•
•
Recycled fiber board in place of the polyfoam in
packing boxes
Recycled plastics in place of the virgin material
in product construction
international suPPort
To download this User’s Guide in English,
Spanish, or French, visit the support section at
Para transferir esta guía de usuario en inglés,
español, o francés, visite la sección de la ayuda en
Pour télécharger ce guide de l’utilisateur en
anglais, espagnol, ou français, visitez la section de
contact information
Address: 2116 Carr Street, St. Louis MO, 63106
Phone: 1-314-621-2881
Fax: 1-314-588-1805
Email: [email protected]
Parts Email: [email protected]
© 2009 Digital Products International (DPI, Inc.) | All other trademarks appearing herein are the property of their respective owners.
Specifications are subject to change without notice
|