Melissa Take 2 ME2TMBCHR User Manual

READ AND SAVE THESE INSTRUCTIONS  
TM  
Coffee Maker  
ADDITIONAL IMPORTANT  
SAFEGUARDS  
WARNING: This appliance generates heat and escaping  
steam during use. Proper precautions must be taken to  
prevent the risk of burns, fires, or other injury to persons or  
damage to property.  
• All users of this appliance must read and understand this  
Owner’s Manual before operating or cleaning this appliance.  
• The cord to this appliance should be plugged into a 120V AC  
electrical outlet only.  
• Use water only in this appliance! Do not put any other liquids or  
food products in this appliance. Do not mix or add anything to  
the water placed in this appliance, except as instructed in the  
User Maintenance Instructions to clean the appliance.  
• DO NOT attempt to move an appliance containing hot liquids.  
Allow appliance to cool completely before moving.  
• Keep appliance at least 4 inches away from walls or other  
objects during operation. Do not place any objects on top of  
appliance while it is operating. Place the appliance on a surface  
that is resistant to heat.  
• If this appliance begins to malfunction during use, immediately  
unplug the cord. Do not use or attempt to repair the  
malfunctioning appliance.  
• If this appliance falls or accidentally becomes immersed in water  
or any other liquid, unplug it immediately. Do not reach into the  
water! Do not use this appliance after it has fallen into or has  
become immersed in water. Contact Consumer Service for  
examination and repair.  
• Do not leave this appliance unattended during use.  
• The appliance must be left to cool down sufficiently before  
adding more water to avoid splattering.  
• Always use fresh, cool water in your appliance.Warm water or  
other liquids, except as listed in cleaning section, may cause  
damage to the appliance.  
• DO NOT lift Filter Basket Lid until brewing is complete, and all  
parts have cooled.  
• The Mugs are designed for use with this appliance. They must  
never be used on a range top.  
• DO NOT put mugs into a microwave.  
3
SHORT CORD INSTRUCTIONS: A short power supply cord is  
provided to reduce the risk resulting from becoming entangled  
in or tripping over a longer cord.  
Do not use an extension cord with this product.  
POLARIZED PLUG: This appliance has a polarized plug, (one  
blade is wider than the other). To reduce the risk of electric  
shock, this plug is intended to fit into a polarized outlet only one  
way. If the plug does not fit fully in the outlet, reverse the plug. If  
it still does not fit, contact a qualified electrician. Do not attempt  
to modify the plug in any way.  
PLASTICIZER WARNING:  
CAUTION: To prevent Plasticizers from migrating from the finish  
of the countertop or tabletop or other furniture, place NON-  
PLASTIC coasters or placemats between the appliance and the  
finish of the countertop or tabletop.  
Failure to do so may cause the finish to darken, permanent  
blemishes may occur or stains can appear.  
ELECTRIC POWER: If the electric circuit is overloaded with  
other appliances, your appliance may not operate properly. It  
should be operated on a separate electrical circuit from other  
appliances.  
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC  
SHOCK, DO NOT REMOVE THE BOTTOM COVER. NO USER-  
SERVICEABLE PARTS INSIDE. REPAIR SHOULD BE DONE BY  
AUTHORIZED SERVICE PERSONNEL ONLY.  
Before Using Your  
Take 2 Coffee Maker  
Before using your Take 2™ Coffee Maker for the first time, we  
suggest you become familiar with all of its parts. Read all  
instructions and cautions carefully.  
CAUTION: Press the Power Switch with Indicator Light so  
that the light is off. Unplug from outlet.  
IMPORTANT: Never place Thermal Mugs on a hot stove or in  
a microwave. Never let Thermal Mugs stand in water.  
Before brewing coffee, follow instructions for cleaning. See “Care  
and Cleaning,” page 7.  
CAUTION: Do not immerse cord, plug, or coffee maker unit  
in water or other liquids.  
4
Your product may vary slightly from illustration.  
Parts Identification  
Water Chamber Lid  
Filter  
Basket  
(P/N 31131)  
Water Chamber  
with Water Level  
Indicator  
Flow  
Nozzle  
(P/N 31130)  
Filter Basket  
Holder  
Thermal Mug  
Lids  
(P/N 30909)  
FIGURE B  
Thermal  
Mugs  
(P/N  
30911CHR)  
Drip Tray  
(P/N 31064)  
Overflow  
Tray  
(P/N 31065)  
Base  
Power Switch with  
Indicator Light  
FIGURE A  
FIGURE C  
FIGURE D  
5
Brewing  
1. Plug into 120V ~ 60 Hz outlet.  
2. Make sure unit is in the OFF position. The Indicator Light will  
be off.  
IMPORTANT: Place coffee maker on a level surface.  
3. Markings on the Water Level Indicator indicate the amount of  
water required to brew the desired number of Thermal Mugs.  
Lift up the hinged Water Chamber Lid and fill to desired level  
with cold, fresh water for the number of Thermal Mugs (one  
or two), using the Water Level Indicator on the Water Window.  
WARNING: When making one Thermal Mug, do not fill  
above level 1.  
IMPORTANT: If cream or milk will be added to Thermal  
Mugs, use less water for brewing.  
4. For optimal holding temperature, rinse the inside of Thermal  
Mugs with warm water before brewing. Place Lids securely  
on tops of Thermal Mugs. Press down on the Lids to ensure  
proper fit.  
NOTE: You can brew either one Thermal Mug or two  
Thermal Mugs at once. Place Thermal Mugs snugly on  
Base of unit as shown in Figure A (for two Thermal Mugs)  
or Figure D (for one Thermal Mug). The contoured design  
on the Base should be used as a guide for Thermal Mug  
alignment.  
5. Insert a #2 paper cone filter into the Removable Filter Basket  
and add coffee grounds. Use approximately 1-1/2 to 2  
tablespoons for each Thermal Mug of coffee. Close Water  
Chamber Lid.  
6. Press Power Switch ON. The Indicator Light will turn on.  
CAUTION: Avoid contact with heated water.  
IMPORTANT: Do not remove Thermal Mugs until the  
Indicator Light has turned OFF. The Indicator Light will  
turn OFF approximately two minutes after brewing is  
complete. This delay will allow the last drops of coffee to  
flow into the Thermal Mugs.  
7. After Indicator Light turns off, Thermal Mugs may be safely  
removed.  
8. If brewing more than one cycle, allow unit to cool for 10  
minutes between cycles.  
6
Helpful Hints for Brewing  
• Always use fresh, cold water for brewing. In areas with hard  
water or where water contains a high mineral content, use  
cold filtered water for optimal coffee taste.  
• For best results, use Melitta® #2 paper cone filters and  
Melitta® Premium Fine Grind Roast Coffee.  
• The markings on the Water Level Indicator reflect the quantity  
of fresh water to be used. The quantity of brewed coffee is  
less because the coffee grounds absorb water.  
Care and Cleaning  
1. Make sure Power Switch is in the OFF position. The Indicator  
Light will be off.  
2. Unplug and allow to cool completely before cleaning.  
3. Open Water Chamber Lid and lift up on the tab of Filter  
Basket. Discard any paper filter and coffee grounds.  
4. Remove Flow Nozzle by pulling down away from the Filter  
Basket Holder.  
5. Wash removable Filter Basket, Drip Tray and Overflow Tray,  
Flow Nozzle, Mugs and Mug Lids in warm, soapy water. Rinse  
and dry thoroughly. Or, you may wash the Mugs and Lids in  
the top rack of a dishwasher.  
6. Clean the outside of the coffee maker with a damp cloth.  
CAUTION: DO NOT IMMERSE CORD, PLUG OR COFFEE  
MAKER UNIT IN WATER OR OTHER LIQUID.  
7. Replace Filter Basket, Flow Nozzle, Drip Tray and Overflow  
Tray for next use.  
7
Descaling  
We recommend that you descale your coffee maker once a month  
because mineral deposits can form a coating in the coffee maker,  
causing slower brewing time and possibly an off flavor in the  
coffee. Use a cleaner recommended for coffee makers. To  
descale your unit:  
1. Pour two ounces of vinegar or coffee cleaner into the Water  
Chamber. Add cold water to the level 2 indicator.  
2. Place a clean #2 paper cone filter in the filter basket and close  
Water Chamber Lid. Place both Mugs in proper position on  
Base of unit.  
3. Follow “Brewing” instructions (without coffee).  
4. When the Indicator Light turns off, wait 15 minutes and pour  
solution from Mugs back into coffee maker. Be sure that the  
Filter Basket is still in proper position.  
5. Turn unit on again. Allow all solution to empty into Mugs.  
When Indicator Light turns off, discard solution.  
6. Allow unit to cool 10 minutes. To rinse unit, fill Water Chamber  
with fresh, cold water up to the level 2 indicator. Insert a fresh  
paper filter into Filter Basket. Close Water Chamber Lid.  
Place both Mugs in proper position on Base of unit and turn  
Power Switch on.  
7. At end of cycle, allow unit to cool, discard water and paper  
filter.Wash and dry Mugs and other removable parts.  
8. Unplug coffee maker from outlet. When coffee maker has  
cooled, wipe exterior with a damp cloth.  
8
LIMITED ONE-YEAR WARRANTY  
Warranty Coverage: This product is warranted to be free from defects in  
materials or workmanship for a period of one (1) year from the original purchase  
date. This product warranty is extended only to the original consumer  
purchaser of the product and is not transferable. For a period of one (1) year  
from the date of original purchase of the product, our Repair Center will, at its  
option, either (1) repair the product or (2) replace the product with a  
reconditioned comparable model. These remedies are the purchaser's exclusive  
remedies under this warranty.  
Warranty Service: To obtain warranty service, you must call our warranty  
service number at 1-800-233-9054 for return instructions on how to deliver the  
product, in either the original packaging or packaging affording an equal degree  
of protection to the Repair Center specified below. You must enclose a copy of  
your sales receipt or other proof of purchase to demonstrate eligibility for  
warranty coverage.  
To return the appliance, ship to:  
To contact us, please write to, call, or email:  
ATTN: Repair Center  
708 South Missouri Street  
Macon, MO 63552 USA  
Consumer Relations Department  
PO Box 7366  
Columbia MO 65205-7366 USA  
1-800-233-9054  
What Is Not Covered: This warranty does not cover damage resulting from  
misuse, accident, commercial use, improper service or any other damage  
caused by anything other than defects in material or workmanship during  
ordinary consumer use. This warranty is invalid if the serial number has been  
altered or removed from the product. This warranty is valid only in the United  
States and Canada.  
LIMITATION ON DAMAGES: THERE SHALL BE NO LIABILITY FOR ANY  
INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY  
EXPRESS OR IMPLIED WARRANTY OR CONDITION ON THIS PRODUCT.  
DURATION OF IMPLIED WARRANTIES: EXCEPT TO THE EXTENT  
PROHIBITED BY APPLICABLE LAW, ALL IMPLIED WARRANTIES AND  
CONDITIONS, INCLUDING, WITHOUT LIMITATION, IMPLIED WARRANTIES  
AND CONDITIONS OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR  
PURPOSE OR USE ON THIS PRODUCT ARE LIMITED IN DURATION TO THE  
DURATION OF THIS WARRANTY.  
Some jurisdictions do not allow the exclusion or limitation of incidental or  
consequential damages, or allow limitations on how long an implied warranty  
lasts, so the above limitations or exclusions may not apply to you. This  
warranty gives you specific legal rights and you may have other rights under the  
laws of your jurisdiction.  
For more information on our products, visit our website:  
©2005 All rights reserved.  
Made in China  
P/N 61384CHR  
7/05  

Motorola USBW 100 User Manual
JVC KD G111 User Manual
IBM 190000 User Manual
Hamilton Beach BrewStation Deluxe 47454 User Manual
Elta 6688 User Manual
Corsair 700D User Manual
Clickfree C6 User Manual
Cisco Systems Computer Accessories User Manual
Cecilware 2000 Series User Manual
Casio DQ 745 User Manual