Legacy Car Audio LCD69DSX User Manual

LEGACY  
INSTRUCTION MANUAL  
USA  
EUROPE  
IMPORTANT:  
This radio is set to USA frequency by factory, if European  
frequency is required please flip the frequency step switch on  
the side of the unit.  
After the switchover of the frequency switch, the frequency convert  
function will not be valid until the RESET button has been pressed.  
REMOTE CONTROL BASICS BATTERY REPLACEMENT:  
1.Remove the battery holder as the direction indicated by the arrow.  
2.Replace the battery Set a new battery properly with (+)side up as illustrated.  
3.Insert the battery holder. Push in the holder to the original position.  
NOTE ON BATTERIES:  
Old batteries must immediately be removed and disposed.  
BATTERY INFORMATION:  
Designated Battery: CR2025 3V.  
Battery Life: 6 months with normal use (in normal room temperature)  
CAUTION:  
Improper use of batteries may cause overheating, explosion or ignition. Resulting in  
jury or fire .Battery leakage may cause damage to the unit.  
Do not disassemble or short the batteries. Do not throw the batteries into the fire.  
To avoid the risk of accident, keep the batteries out of reach of children.  
ANTI-THEFT FLIP DOWN DETACHABLE SYSTEM  
AUTO-LOADING COMPACT DISC PLAYER  
AM/FM STEREO WITH DIGITAL TUNING RADIO  
MODEL:LCD69DSX  
11  
TROUBLE SHOOTING  
DISC PLAY:  
Before going through the check list, wiring connection, should any of the  
problem persist after check list has been made, consult your nearest service  
dealer.  
Cleaning discs  
Before playing, clean the disc with a clean, lint-free.  
Flip the disc in the direction of the arrow.  
Symptom  
No power  
Cause  
Solution  
The car ignition is not on.  
If the power supply is properly  
connected to the car accessory  
switch the ignition key to " ACC "  
The fuse is blown  
Replace the fuse  
Presence of CD disc inside  
the player  
Remove the disc in the player  
then put a new upward  
Disc cannot  
be loaded or  
ejected  
NOTE:  
. Do not use so solvents such as benzine, thinners. Commercially available  
cleaners or anti static spray damage the unit.  
Inserting the disc in upside  
down  
Insert the compact disc with  
the label facing upward  
Compact disc is extremely  
dirty or defective  
Clean the disc or try to play a  
new one  
Insert a disc with the label surface down. Doing so may damage the unit.  
Temperature inside the  
car is too high  
Cool off until the ambient  
temperature returns to normal  
Label  
surface up  
Condensation  
Leave the player off for an  
hour or so, then try again  
Volume is in minimum  
Adjust volume to a desired level  
No sound  
Wiring is not properly  
connected  
Check wiring connection  
NOTE:  
. Do not try to insert another disc when one has been already inserted.  
Doing so may damage the unit.  
.Handle the disc by its edge. And to keep the disc clean, do not touch  
the surface.  
The operation  
keys do not  
work  
The built-in microcomputer  
is not operating properly  
due to noise  
Press the RESET button  
front panel is not properly  
fix into its place  
The installation angle  
is more than 30 degrees  
Adjust the installation angle  
to less than 30 degrees  
Sound skips  
The disc is extremely  
dirty or defective  
Clean the compact disc/try to  
play a new one  
The radio does  
not work  
the radio  
Insert the antenna cable firmly  
select a station manually  
The antenna cable is not  
connected  
the signals are too weak  
station  
.Do not stick paper or tape on the disc.  
automatic  
selection does  
not work  
.Do not expose the disc to direct sunlight or heat sources such as hot air  
ducts. Or leave it in a car parked in direct sunlight where there can be a  
considerable rise in temperature.  
2
9
SPECIFICATION  
GENERAL  
LOCATION AND FUNCTION OF CONTROL  
Power requirement..............................................................................................DC 13.8V.  
Current consumption..............................................................................................7A MAX.  
POWER OUTPUT.....................................................................................................4 X 40W.  
FM SECTION  
Frequency range..................................................................................87.5MHz -108.0MHz.  
Usable sensitivity.........................................................................................................3uV.  
I.F Frequency........................................................................................................10.7MHz.  
AM SECTION  
Frequency range.....................................................................................522KHz - 1620KHz.  
Frequency range.....................................................................................530KHz - 1710KHz.  
LINE - OUT [OPTION]  
Output...............................................................................1000mV @ FM 10% THD POWER.  
Impedance............................................................................................................600 ohm.  
CD PLAYER  
System........................................................................................compact disc audio system.  
Usable disc......................................................................................................compact disc.  
Signal format.............................................................................sampling frequency 44.1KHz.  
No of quantization bits 1bit.  
Frequency characteristics...............................................................................5-40Hz < 5dB  
10K-20KHz < 5dB.  
1. FOLDABLE SPEAKER  
Signal to noise radio................................................................70dB [1KHz] [IEC - A net work].  
Number of channels..............................................................................................2 STEREO.  
Chassis dimensions.......................................................................178[W] X 50[H] X 165[D].  
2.  
[TUNE/SEEK DOWN] BUTTON and TRACK DOWN BUTTON  
a. The frequency scans down by one step when pressing  
button once. Hold  
it for more than 2 seconds to seek for a station of lower frequency.  
b. During CD mode, press  
button allow you to track forwards.  
Hold the button allow you to skip forwards.  
c. To set minutes at time setting mode.  
[TUNE/SEEK UP] BUTTON and TRACK UP BUTTON  
a. The frequency scans up by one step when pressing  
button once. Hold  
it for more than 2 seconds to seek for a station of higher frequency.  
b. During CD mode, press button allow you to track backwards.  
Hold the button allow you to skip backwards.  
c. To set hour at time setting mode.  
3
8
3. SEL( AUDIO MODE SELECT)/VOLUME +/- BUTTON  
Press SEL button to change the mode in the sequence of  
VOL  
BAS  
TRE  
BAL  
FAD  
Speaker Connection  
a. The volume level can be adjusted at any time by pressing the audio level+ or  
- button as select mode has been initially defaulted at volume mode.  
b. The volume level is also obtained by stepping through the SEL button until  
the function VOL is displayed and then press + or - button to adjust the  
sound level.  
ANTENNA PLUG  
12 P  
YELLOW  
MEMORY B+  
FUSED  
FILTER  
BOX  
c. Press and hold the + or - button to adjust the sound level.  
RCA LINE OUT  
RED R  
BLACK(GND)  
0.5A &7A  
FUSES  
WHITE L  
BASS CONTROL  
a. Press the SEL button to select the bass mode until BAS appears on the display.  
b. Press + or - to adjust the bass effect.  
RED (B+)  
BLUE AUTO ANT  
+
+
FRONT  
GRAY  
WHITE  
FRONT  
RIGHT  
SP  
TREBLE CONTROL  
a. Press the SEL button to select the treble mode until TRE appears on the display.  
b. Press + or - to adjust the treble effect.  
WHITE/BLACK  
GRAY/BLACK  
VIOLET  
LEFT  
SP  
+
+
GREEN  
REAR  
REAR  
GREEN/BLACK  
VIOLET/BLACK  
BALANCE CONTROL  
Note:  
Make sure use a 4-ohms impedance speaker in spite of having any kinds  
of speaker system. So that reduce the distortion during high volume level.  
a. Press the SEL button to select the balance mode until BAL appears on the display.  
b. Press the + button or - button to increase or decrease the sound level of  
left or right speaker.  
FADER CONTROL  
NOTE: SOMETIMES THE DISC CANNOT BE LOADED  
WHEN THE YOU CONNECT THE MEMORY WIRE AT THE  
FIRST TIME AND THE DISC MARK WILL BE DISPLAYED  
ON LCD. PLEASE PRESS RESET BUTTON AND RESTART  
THE UNIT, THE UNIT WILL RESTORE TO NORMAL STATE.  
a. Press the SEL button to select the fader mode until FAD appears on the display.  
b. Press the + button or - button to increase or decrease the sound level of  
front or rear speaker.  
4. INFRA-RED RECEIVE WINDOW  
5. LCD ( LIQUID CRYSTAL DISPLAY)  
6. MUTE BUTTON  
Press it to reduce the volume level temporarily.  
7. POWER BUTTON  
Press the button to turn on or off the unit.  
8. OPEN(EJECT) BUTTON  
Push it to slide the panel then you can insert or eject the disc from  
the compartment.  
7
4
9. RELEASE BUTTON  
Press it to flip down the front panel when you want to take away.  
17. PRESET STATION [ 1-6 ] / 2RPT, 3INT, 4RDM.  
A]. To memorize the current frequency, press and any one of the six preset  
buttons for more than 2 seconds.  
10. LOUDNESS BUTTON  
Press it to enhance the bass effect.  
B]. To recall the preset memory, press one of the preset button [1-6].  
C]. REPEAT BUTTON  
During CD mode. Press 2 RPT button to repeat a single track.  
D]. During CD mode press 3 " INTRO "button.  
11. CLOCK ADJUSTMENT BUTTON  
During frequency display, press it to change to clock function.  
Press the button for more than 2 seconds, until time flashes. and you can adjust  
time now.  
It play individually tune for 10 seconds.  
If this key is pressed in intro scan mode, it display " INTRO ".  
E]. During CD mode press 4 " RDM " button.  
If this key is pressed, and at the end of the tune random tuning function  
performs.  
To adjust hour:  
with time on display, push the tune  
completed, release the button.  
To adjust minute:  
with time on display, push the tune  
completed, release the button.  
button adjust hour, when adjustment is  
button adjust minute. When adjustment is  
If this key is pressed, in random play mode, it display " RDM ".  
12. MONO/STEREO BUTTON  
Press it to select mono/stereo mode.  
13. LOCAL/DISTANCE BUTTON  
When in the radio mode, press them to select local or distance broadcast  
station receive sensitivity. The word LOC will appear on LCD during local  
state.  
14. BAND BUTTON  
Press it to select your desired radio band.  
15. AS/PS [ AUTOMATIC STORE AND PRESET MEMORY] BUTTON  
Press it to perform all stations memory for 5 seconds each time. While memory  
digital and frequency will flash on LCD. If the button is pressed for more than 2  
seconds, it will seek station on current band, then write to the preset memories  
and word ART will appear on LCD. When the auto-storage operation is completed,  
it will automatically perform for 5 seconds each time, during the memory station  
performing, press 1-6 digital buttons to select and stop scanning function.  
a. SCAN BUTTON  
Press it to scan the memorized stations 10 seconds each. Stop scanning  
function and return to playback as long as your desired station has been  
found.  
b. POWER BUTTON  
Press it to turn on or off the unit.  
16. CD  
[CD PLAY, PAUSE] BUTTON  
button to switch to CD mode. At CD mode,  
At tuner mode, press  
press it to pause the CD program and press it again to resume CD  
playback.  
6
5

Lava Computer Lava 2SP 550 User Manual
Kenwood KDC 2029 User Manual
JVC GET0624 003A User Manual
Iomega 250MB Zip User Manual
GE ZBD6400 User Manual
Fujitsu MHZ2160BJ User Manual
DeLonghi Coffee Maker DCF6212TTC User Manual
Carcomm DSP PDA 02 XDA User Manual
Bloomfield 8543 User Manual
2Wire ThermalVision PRO SW ND 7609 3UK User Manual