WARNINGS AND PRECATIONS
•
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH
WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
WARNING: To prevent fire or shock hazards, do not expose this
unit to rain or moisture.
CAUTION: Use of controls or adjustments or performance of
procedures other than those specified may result in hazardous
radiation exposure.
WARNING: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
WARNING: Do not place the unit on top of any soft, porous, or
sensitive surfaces to avoid damaging the surface. Use a protec-
tive barrier between the unit and surface to protect the surface.
CAUTION: Danger of explosion if battery is incorrectly re-
placed. Replace only with the same or equivalent type.
PRÉCAUTION: Danger d’explosion si les piles sont remplacées
de façon incorrect. Remplacer les piles seulement par le même
type de pile ou l’équivalent.
FCC Warnings
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the in-
terference by one or more of the following measures:
•
•
USER’S GUIDE
V:1008-0414-09
•
•
C389B
Dual Alarm Clock Radio with Intelli Set™
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
•
•
•
•
Connect the equipment into an outlet on a circuit dif-
ferent from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV techni-
cian for help.
Do not mix old and new batteries.
No mezcle baterías viejas y nuevas.
Do not mix alkaline, standard (carbon-zinc), or
rechargeable (ni-cad, ni-mh, etc) batteries.
No mezcle baterías alcalinas, estándar (carbono-
zinc) o recargables (ni-cad, ni-mh, etc.).
For the most up-to-date version of this
POWERING THE UNIT
OPERATIONS
█
AC/DC ADAPTER
█
SETTING THE TIME USING INTELLI SET™
Connect the included AC/DC Adpater to
the DC Power Input on the unit and an
AC power source to power the unit.
When the unit is first powered on, the time will automatically be set to Eastern
Standard Time.
1. Plug the unit into a power source.
2. Press and hold the Clock Button.
3. While holding the Clock Button, press the Time Zone Button repeatedly to cycle
through the available time zones.
Refer to the Time Zone Chart below to find your specific time zone.
Abbr.
Full Name
Atlantic Standard Time
Time Zone
UTC - 4 hours
1
2
3
4
5
AST
EST
CST
MST
PST
Estern Standard Time
Central Standard Time
Mountain Standard Time
Pacific Standard Time
UTC - 5 hours
UTC - 6 hours
UTC - 7 hours
UTC - 8 hours
█
BATTERY BACKUP
Requires a CR2032 battery, pre-
installed.
6
7
AKST
HAST
Alaska Standard Time
UTC - 9 hours
UTC - 10 hours
Use a small, Phillips-head screwdriver
to open the backup battery
compartment.
Hawaii-Aleutian Standard Time
4. Release the Clock Button to finish setting the time.
If you are experiencing issues when attempting to use the Intelli Set™ feature, you can
set the clock manually by following the directions on the next page.
█
SETTING THE TIME MANUALLY
█
SETTING THE ALARMS
CR2032
1. Plug the unit into a power source.
1. With the unit powered off, press and
hold the AL 1/P- Button (Alarm 1) or
AL 2/P+ Button (Alarm 2).
2. Press and hold the Clock Button.
Only replace with same or equivalent
type battery.
3. While holding the Clock Button, press
the Tun+/Hr Button and Tun-/Min
Button to adjust the hour and minute.
2. While holding the AL 1/P- Button or
AL 2/P+ Button, press the Tun+/Hr
Button and Tun-/Min Button to adjust
the hour and minute.
GENERAL PRODUCT INFORMATION
4. Release the Clock Button to set the
█
IN THE BOX
adjusted time.
C389B
3. While holding the AL 1/P- Button or
AL 2/P+ Button, press the AM/FM/
AUX Button to set the alarm to wake to
the buzzer or the AM/FM radio.
AC/DC adapter
Pre-installed Backup Battery (CR2032)
Documentation
If set to AM/FM radio, the alarm will
sound to the current radio settings.
4. Release the AL 1/P- Button or AL 2/P+
Button to set the adjusted alarm time.
|