Black Box LTD8B User Manual

LTD5  
LTD8  
LTD5B  
LTD8B  
Laptop Depot  
Mobile, secure, and powered storage for  
five or eight laptop computers.  
The perfect storage solution for institutional laptop computers.  
Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500)  
FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax  
Customer  
Support  
724-746-0746 • Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence,  
PA 15055-1018 • Web site: www.blackbox.com • E-mail: [email protected]  
Information  
Table of Contents  
Table of Contents  
1.0 Specifications..................................................................................................... 4  
1.1 Overview ............................................................................................. 4  
2.0 Whats Included................................................................................................. 5  
2.1 Front and Rear Views........................................................................... 6  
3.0 Precautions........................................................................................................ 7  
4.0 Configuration and Setup ................................................................................... 8  
4.1 Installing Power Bricks on the Dividers ................................................. 8  
4.2 Installing the Dividers......................................................................... 13  
LTD5  
Page 3  
724-746-5500 | blackbox.com  
Chapter 1: Specifications  
1.0 Specifications  
Capacity — Holds five or eight laptop computers  
Standards — UL  
Power Strip LTD5: (1) 5-outlet power strip, 0.75 amps per outlet max.;  
LTD8: (1) 8-outlet power strip, 0.75 amps per outlet max.  
Size LTD5: Top: 1.3"H x 14.8"W x 22.8"D (3.3 x 37.6 x 57.9 cm)  
;
Body: 17"H x 13.8"W x 21.9"D (43.2 x 35 x 55.6 cm);  
Base  
:
7.6"H x 13.8"W x 21.9"D (19.3 x 35 x 55.6 cm);  
Casters: 3.9"H (9.9 cm)  
;
Drawer: 5.4"H x 9.2"W x 16"D (13.7 x 23.4 x 40.6 cm)  
Door opening: 14"H x 11"W (35.6 x 27.9 cm)  
LTD8: Top: 1.3"H x 20.8"W x 22.8"D (3.3 x 52.8 x 57.9 cm)  
;
Body: 17"H x 20"W x 22"D (43.2 x 50.8 x 55.9 cm);  
Base  
:
7.6"H x 20"W x 22"D (19.3 x 50.8 x 55.9 cm);  
Casters: 3.9"H (9.9 cm)  
;
Drawer: 5.4"H x 15.8"W x 16"D (13.7 x 40.1 x 40.6 cm)  
Door opening: 14"H x 17"W (35.6 x 27.9 cm)  
Both: Netbook Slot: 12.5"H x 2"W x 17"D ( 31.8 x 5 x 27.9 cm)  
Weight — LTD5: Shipping: 35 lb. (15.9 kg);  
LTD8: Shipping: 45 lb. (20.4 kg);  
LTD5B: Shipping: 49 lb. (22.2 kg);  
LTD8B: Shipping: 59 lb. (26.8 kg)  
1.1 Overview  
The Laptop Depot (LTD) and Laptop Depot with Pedestal (LTDB) are designed to store,  
transport, and charge laptop computers and other similar devices. Units are available  
with capacities for five or eight separate storage bays. Each unit plugs into a typical  
120-volt 15-amp outlet.  
Page 4  
LTD5  
724-746-5500 | blackbox.com  
Chapter 2: What‘s Included  
2.0 What‘s Included  
Laptop Depot (LTD5 and LTD8)  
• Laptop Depot: five laptop capacity (LTD5) or eight laptop capacity (LTD8)  
• Power Strip: 5-outlet (LTD5) or 8-outlet (LTD8)  
• Power management dividers: 6 (LTD5) or 9 (LTD8)  
• Users manual  
• Pair of keys  
Laptop Depot Base (LTD5B and LTD8B)  
• Caster base with locking drawer  
• Laminate top  
• (6) 10 x 3/4" black particle board screws  
• (4) 10-24 x 1.5" steel screws  
• (4) 10-24 flange nuts  
• Users manual  
• Pair of keys  
LTD5  
Page 5  
724-746-5500 | blackbox.com  
Chapter 2: What‘s Included  
2.1 Front and Rear Views of the Laptop Depot  
Mounting Holes  
Reinforced Top  
Side Panel  
Ventilation  
Stowed Door  
Power Management  
Divider (PMD)  
Wire Grommet  
Reinforced Bottom  
Figure 2-1. LTD.  
Closed locking door  
Door Lock  
Bottom Drawer Chassis  
Locking Drawer  
Casters  
Drawer Handle  
Figure 2-2. LTDB.  
Page 6  
LTD5  
724-746-5500 | blackbox.com  
Chapter 3: Precautions  
3.0 Precautions  
• The LTD and LTDB must ONLY be connected to a 120 volt AC 15- or-20 amp power  
supply.  
• The LTD and LTDB must always be used by adults or with adult supervision.  
• The LTD and LTDB are not designed for outdoor use. Indoor use only.  
• Always stow the power cord around the unit when transporting.  
• Never pull the LTD by the power cord.  
• Do not plug the LTD in if the switch, receptacle(s), or power cord have been  
damaged. All electrical components on this product must be repaired by a qualified  
technician.  
• Do not use an extension cord in conjunction with the LTD.  
• NO LIQUIDS in or around the LTD and LTDB environment.  
• Inadequate repair can create significant hazards to users and is not covered by the  
warranty.  
• For your safety, it is recommended that a qualified electrician test the circuit you  
will be plugging the LTD into. The circuit should be checked for ground integrity  
and appropriate branch circuit protection.  
• The LTD ground prong must be present for safe operation. If the plug is damaged  
or if the ground prong has been removed, it should be replaced by a qualified  
technician.  
• The use of the LTD including: plugging in or unplugging laptop computers,  
plugging in or unplugging the LTD and LTDB, and engaging or releasing the  
directional and total lock casters must be done with adult supervision.  
• The LTD can be very heavy when fully loaded with laptop computers and should be  
moved about by persons physically able to do so.  
• The LTD should only be used for storage, transport (LTDB), and charging of laptop  
computers, tablet PCs, ultra mobile PCs, and other similar devices.  
• Misuse, incorrect operation, or inadequate repair of the LTD will void the warranty.  
LTD5  
Page 7  
724-746-5500 | blackbox.com  
Chapter 4: Configuration and Setup  
4.0 Configuration and Setup  
Remove and discard all packaging materials. Open and inspect the LTD or LTDB to  
verify all doors, drawers, and locks are working properly.  
For the LTDB, lock the casters prior to setting up, loading, or unloading laptop  
computers to prevent the LTDB from moving.  
Feed the power strip cord through the grommet hole located on the side of the LTD.  
Do not plug the LTD into the wall outlet until all configurations and setup are  
complete.  
Attach power bricks to the dividers to create separate slots for the laptop computers.  
4.1 Installing Power Bricks on the Dividers  
Remove a divider to install a power brick on it. Follow these steps to install the power  
bricks on each divider:  
Step 1. Lay the divider flat on the work surface. Lay a laptop computer and a power  
brick on top of the divider, with the computer end of the power wire toward the top  
of the divider. Plug the power brick into the laptop computer. Lay the wire across the  
two holes at the top of the divider. Make sure that there is some slack between the  
front hole and the plug.  
Cord slack  
Note this point  
Make sure there  
Netbook  
Power Brick  
is slack at these  
two points  
Align the back of the notebook  
with the back of the divider  
Figure 4-1. How to thread the electrical cable through the dividers.  
Page 8  
LTD5  
724-746-5500 | blackbox.com  
Chapter 4: Configuration and Setup  
Step 2. Note the point where the power wire meets the rear hole in the divider.  
Measure back 6" toward the power brick and fold the wire in half to create a loop in  
the center of the wire. This loop will be used in Step 3, below. Unplug the power  
wire from the netbook and remove the netbook from the divider.  
Figure 4-2. Loop the electrical cord and push it through the circular hole at the top  
rear of the divider.  
Step 3. Insert the loop created in Step 2 through the rear small hole at the top of the  
divider (Figure 4-2). Then, place the plug end of the wire through the loop (Figure  
4-3). Make sure that the loop is on the side of the divider (not on top of it—see  
Figure 4-4). This will ensure that the divider will slide back into the cart. Then, tighten  
the loop down to the divider, tightening the knot.  
Figure 4-3. Insert the plug end of the wire through the loop.  
Keep the loop here  
Power brick end  
Figure 4-4. Make sure the loop is on the side of the divider, not on top of it.  
Step 4. Run the wire along the top of the divider and repeat the process of creating  
a loop in the power cord. Place this loop through the small hole at the front of the  
divider (Figure 4-5). Now place the plug end of the wire through the loop (Figure  
4-6). Pull the end of the cable, tightening the loop (Figure 4-7).  
LTD5  
Page 9  
724-746-5500 | blackbox.com  
Chapter 4: Configuration and Setup  
Figure 4-5. Create a loop from the power cable and feed it through the hole at the  
top front of the divider.  
Figure 4-6. Insert the plug end of the wire through the loop.  
Keep the loop  
on top  
Figure 4-7. Pull the cable taught to secure the loop.  
Step 5. Wrap the remaining length of power cord around the power brick (see Figure  
4-10, page 12).  
Page 10  
LTD5  
724-746-5500 | blackbox.com  
Chapter 4: Configuration and Setup  
Step 6. Wrap the plug wire around the brick. Leave at least 7" of extra cable if the  
divider will be inserted into the bottom shelf, or at least 21" of extra cable if the  
divider will be inserted into the top shelf.  
Lower shelf: 7"  
Upper shelf: 21"  
Figure 4-8. Wrap the remaining electrical cable around the power brick.  
Step 7. Hold the brick and cords in place by strapping them down using a zip tie or a  
hook-and-loop tie.  
Strap  
Figure 4-9. Strap the brick and cord in place using a zip tie or  
hook-and-loop tie (not included).  
LTD5  
Page 11  
724-746-5500 | blackbox.com  
Chapter 4: Configuration and Setup  
Step 8. Install the assembled divider into the cart using the following steps.  
Figure 4-10. A divider with a power brick properly attached.  
NOTE: For proper installation, make certain that all power bricks are installed on the  
same side of every divider.  
Page 12  
LTD5  
724-746-5500 | blackbox.com  
Chapter 4: Configuration and Setup  
4.2 Installing the Dividers  
Step 1. Working from left to right, insert the power cord of a laptop power brick  
that is mounted on a divider into the farthest left open outlet and then insert the  
divider into the LTD.  
Figure 4-11 Begin to insert dividers into the top row of the cart.  
Step 2. Repeat until all dividers are installed.  
Figure 4-12. Netbook Cart dividers with attached power bricks.  
Step 3. Load one laptop computer into each storage bay.  
LTD5  
Page 13  
724-746-5500 | blackbox.com  
Notes  
Page 14  
LTD5  
724-746-5500 | blackbox.com  
Notes  
LTD5  
Page 15  
724-746-5500 | blackbox.com  
Black Box Tech Support: FREE! Live. 24/7.  
Tech support the  
way it should be.  
Great tech support is just 30 seconds away at  
724-746-5500 or blackbox.com.  
About Black Box  
Black Box Network Services is your source for an extensive range of networking  
and infrastructure products. You’ll find everything from cabinets and racks and  
power and surge protection products to media converters and Ethernet switches  
all supported by free, live 24/7 Tech support available in 30 seconds or less.  
© Copyright 2011. Black Box Corporation. All rights reserved.  
LTD5, rev. 1  
724-746-5500 | blackbox.com  

Nokia 5125 User Manual
Nokia 002F4W8 User Manual
Mr Coffee 109041 User Manual
LG Electronics Green Rumor User Manual
Lenovo 40Y8637 User Manual
HP Hewlett Packard PC Comm Station Pro P8814A Europe User Manual
Dynex DX IF101 User Manual
Bunn AXIOM Twin APS User Manual
Black & Decker SmartBrew DCM2500K User Manual
Aiwa XP SP910 User Manual