Black Box Computer Accessories USB to RS 232 DB9 Converter User Manual

IC188A  
USB to RS-232 DB9 Converter  
Converts a USB port into a DB9 male  
RS-232 serial port.  
• Perfect for PDAs, cameras, modems, and mobile phones.  
• Powered by the USB port.  
Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500)  
Customer  
Support  
Information  
FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746  
Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018  
FCC and IC RFI Statements/CE Notice/WEEE  
Federal Communications Commission and Industry Canada Radio Frequency Interference  
Statements  
This equipment generates, uses, and can radiate radio-frequency energy, and if not installed and used properly, that is, in strict  
accordance with the manufacturer’s instructions, may cause interference to radio communication. It has been tested and found to  
comply with the limits for a Class A computing device in accordance with the specifications in Subpart B of Part 15 of FCC rules,  
which are designed to provide reasonable protection against such interference when the equipment is operated in a commercial  
environment. Operation of this equipment in a residential area is likely to cause interference, in which case the user at his own  
expense will be required to take whatever measures may be necessary to correct the interference.  
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to  
operate the equipment.  
This digital apparatus does not exceed the Class A limits for radio noise emission from digital apparatus set out in the Radio  
Interference Regulation of Industry Canada.  
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de  
la classe A prescrites dans le Règlement sur le brouillage radioélectrique publié par Industrie Canada.  
This product complies with the EMC and Low Voltage directives of the European Community.  
RoHS/WEEE  
This product complies with the Restriction of Hazardous Substances (RoHS) and the Waste from Electrical and Electronic  
Equipment (WEEE).  
724-746-5500 | blackbox.com  
Page 3  
NOM Statement  
Instrucciones de Seguridad  
(Normas Oficiales Mexicanas Electrical Safety Statement)  
1. Todas las instrucciones de seguridad y operación deberán ser leídas antes de que el aparato eléctrico sea operado.  
2. Las instrucciones de seguridad y operación deberán ser guardadas para referencia futura.  
3. Todas las advertencias en el aparato eléctrico y en sus instrucciones de operación deben ser respetadas.  
4. Todas las instrucciones de operación y uso deben ser seguidas.  
5. El aparato eléctrico no deberá ser usado cerca del agua—por ejemplo, cerca de la tina de baño, lavabo, sótano mojado o cerca  
de una alberca, etc.  
6. El aparato eléctrico debe ser usado únicamente con carritos o pedestales que sean recomendados por el fabricante.  
7. El aparato eléctrico debe ser montado a la pared o al techo sólo como sea recomendado por el fabricante.  
8. Servicio—El usuario no debe intentar dar servicio al equipo eléctrico más allá a lo descrito en las instrucciones de operación.  
Todo otro servicio deberá ser referido a personal de servicio calificado.  
9. El aparato eléctrico debe ser situado de tal manera que su posición no interfiera su uso. La colocación del aparato eléctrico  
sobre una cama, sofá, alfombra o superficie similar puede bloquea la ventilación, no se debe colocar en libreros o gabinetes  
que impidan el flujo de aire por los orificios de ventilación.  
10. El equipo eléctrico deber ser situado fuera del alcance de fuentes de calor como radiadores, registros de calor, estufas u otros  
aparatos (incluyendo amplificadores) que producen calor.  
11. El aparato eléctrico deberá ser connectado a una fuente de poder sólo del tipo descrito en el instructivo de operación, o como  
se indique en el aparato.  
12. Precaución debe ser tomada de tal manera que la tierra fisica y la polarización del equipo no sea eliminada.  
13. Los cables de la fuente de poder deben ser guiados de tal manera que no sean pisados ni pellizcados por objetos colocados  
sobre o contra ellos, poniendo particular atención a los contactos y receptáculos donde salen del aparato.  
14. El equipo eléctrico debe ser limpiado únicamente de acuerdo a las recomendaciones del fabricante.  
15. En caso de existir, una antena externa deberá ser localizada lejos de las lineas de energia.  
16. El cable de corriente deberá ser desconectado del cuando el equipo no sea usado por un largo periodo de tiempo.  
17. Cuidado debe ser tomado de tal manera que objectos liquidos no sean derramados sobre la cubierta u orificios de ventilación.  
18. Servicio por personal calificado deberá ser provisto cuando:  
A: El cable de poder o el contacto ha sido dañado; u  
B: Objectos han caído o líquido ha sido derramado dentro del aparato; o  
C: El aparato ha sido expuesto a la lluvia; o  
D: El aparato parece no operar normalmente o muestra un cambio en su desempeño; o  
E: El aparato ha sido tirado o su cubierta ha sido dañada.  
724-746-5500 | blackbox.com  
Page 4  
Table of Contents  
Table of Contents  
1. Specifications.......................................................................................................................................................................................... 6  
2. Overview ................................................................................................................................................................................................ 7  
2.1 Introduction .................................................................................................................................................................................. 7  
2.2 Features......................................................................................................................................................................................... 7  
2.3 What’s Included ............................................................................................................................................................................ 7  
2.4 System Requirements .................................................................................................................................................................... 7  
3. Installation ............................................................................................................................................................................................. 8  
3.1 Windows Vista/Windows 7 ........................................................................................................................................................... 8  
3.2 WIndows 2000/XP........................................................................................................................................................................ 9  
3.3 Verifying the Driver Installation on Windows ................................................................................................................................10  
3.4 Verifying the Driver Installation on Mac OS X................................................................................................................................11  
3.5 Connecting Serial Device ..............................................................................................................................................................13  
724-746-5500 | blackbox.com  
Page 5  
Chapter 1: Specifications  
1. Specifications  
Data Transfer Rate — 500 kbps  
Operating Systems Supported — Windows® 98 SE/Me/2000/XP/7, Windows Vista® 32/64-bit, Mac® 10.x  
Connectors — (1) USB Type A male, (1) DB9 male  
Power — Bus-powered  
Size — Length: 22" (55.9 cm)  
724-746-5500 | blackbox.com  
Page 6  
Chapter 2: Overview  
2. Overview  
2.1 Introduction  
Use the USB to RS-232 DB9 Converter to connect your RS-232 serial devices to the USB port on your PC. Just connect the cable  
to the PC or hub’s port, and connect the other end to an RS-232 device such as a PDA, scanner, or printer.  
2.2 Features  
• Complies with the USB 1.1 specification.  
• Supports an RS-232 serial interface.  
• Supports a 500-kbps data transfer rate.  
• USB suspend condition.  
• Plug-and-play compatible.  
• USB host device drivers available.  
• Draws its power from the USB connection—no extra power adapter required.  
• Supports Windows 2000/XP/7, Windows Vista32/64-bit, and Mac 10.x.  
2.3 What’s Included  
Your package should contain the following items. If anything is missing or damaged, contact Black Box Technical Support  
at 724-746-5500 or [email protected].  
• USB to RS-232 DB9 Converter  
• CD-ROM containing software drivers and this user’s manual  
2.4 System Requirements  
• IBM® compatible computer or Mac® computer  
• Windows 2000/XP/7, Windows Vista 32/64-bit, or Mac 10.x  
• An available USB port  
• 64 MB of RAM or more  
• Pentium® 233 MHz or higher  
724-746-5500 | blackbox.com  
Page 7  
Chapter 3: Installation  
3. Installation  
3.1 Windows Vista/Windows 7  
NOTE: Do not connect the USB to RS-232 DB9 Converter to your computer before you install the software drivers.  
1. Insert the product CD into your CD-ROM drive. Figure 3-1 appears. Run the Setup file under E:\Driver, where E: is your  
CD-ROM drive letter.  
Figure 3-1. AutoPlay screen.  
When the Welcome screen appears, click “Next.”  
Figure 3-2. Welcome screen.  
724-746-5500 | blackbox.com  
Page 8  
Chapter 3: Installation  
2. Click “Finish” to complete the installation. See Figure 3-3.  
Figure 3-3. Installation complete screen.  
Once the installation is complete, connect the USB to RS-232 DB9 Converter to a free USB port on your computer.  
3.2 Windows 2000/XP  
NOTE: Do not connect the USB to RS-232 DB9 Converter to your computer before you install the software drivers.  
1. Insert the provided CD into your CD-ROM drive. When the Welcome screen appears, click “Next.”  
Figure 3-4. Welcome screen.  
724-746-5500 | blackbox.com  
Page 9  
Chapter 3: Installation  
2. When the screen shown in Figure 3-5 appears, click “Finish.”  
Figure 3-5. Installation complete screen.  
Once the installation is complete, connect the USB to RS-232 DB9 Converter to a free USB port on your computer.  
3.3 Verifying the Driver Installation on Windows  
To verify the converter installation, follow the instructions below to launch Device Manager.  
• On Windows 2000/XP: Right-click the “My Computer” icon on the desktop and select “Properties > System > (Hardware) >  
Device Manager.”  
• On Windows Vista/Windows 7: Right-click the “Computer” icon on the desktop and select “Properties > Device Manager.”  
In the Ports (COM & LPT) group, a string similar to “USB to Serial Port” or “Prolific USB to Serial Comm Port” displays.  
NOTE: If there is a question or exclamation mark next to that item, then the driver is not properly installed. Delete the item and  
repeat the installation steps.  
Figure 3-6. Selecting the ports.  
724-746-5500 | blackbox.com  
Page 10  
Chapter 3: Installation  
3.4 Verifying the Driver Installation on Mac OS X  
The provided Mac X driver supports:  
• Mac OS 10.1 and above for PowerPC based Mac  
• Mac OS 10.4 and above for Intel® based Mac  
To install the drivers:  
1. Insert the provided driver CD into your CD-ROM drive. Double-click the CD icon on the desktop and navigate to the  
\Driver\MacX directory. Copy and paste the PL2303_1.1.1r2.dmg file to the desktop.  
2. Double-click the dmg file on the desktop to extract the file. Then double-click the PL2303_1.2.1 file that is extracted.  
3. When the Welcome screen appears, click “Continue.” See Figure 3-7.  
Figure 3-7. Welcome screen.  
4. Select a destination disk to install the driver and click “Continue.” See Figure 3-8.  
Figure 3-8. Select a Destination screen.  
724-746-5500 | blackbox.com  
Page 11  
Chapter 3: Installation  
5. Click “Install.”  
Figure 3-9. Install screen.  
6. When the Authenticate screen appears, enter your password in the provided field and click “OK.” See Figure 3-10.  
Figure 3-10. Authenticate screen.  
7. Click “Continue Installation.” See Figure 3-11.  
Figure 3-11. Continue Installation screen.  
724-746-5500 | blackbox.com  
Page 12  
Chapter 3: Installation  
8. Click “Restart” to finish installing the driver and reboot your Mac.  
Figure 3-12. Restart button.  
9. Connect the converter to a free USB port on your Mac.  
10. To verify the installation: Go to Apple System Profiler > Extensions.” You should find ProlificUSBSerial among the list.  
This means that the installation is successful.  
3.5 Connecting the Serial Device  
Now you can connect your RS-232 device to the converter. If prompted to install the driver for your serial device, follow the  
instructions in the manual that you received with your serial device to complete the installation.  
PC  
IC188A  
Notebook  
Printer  
Scanner  
Figure 3-13. Serial device connection.  
724-746-5500 | blackbox.com  
Page 13  
NOTES  
724-746-5500 | blackbox.com  
Page 14  
NOTES  
724-746-5500 | blackbox.com  
Page 15  
Black Box Tech Support: FREE! Live. 24/7.  
Tech support the  
way it should be.  
Great tech support is just 30 seconds away at 724-746-5500 or blackbox.com.  
About Black Box  
Black Box provides an extensive range of networking and infrastructure products. You’ll find everything from cabinets and racks  
and power and surge protection products to media converters and Ethernet switches all supported by free, live 24/7 Tech support  
available in 30 seconds or less.  
© Copyright 2011. Black Box Corporation. All rights reserved.  
IC188A, version 1  
724-746-5500 | blackbox.com  

MTD 248 650 000 User Manual
Marantz DR6000 User Manual
LG Electronics 3280 User Manual
LaCie 14FB User Manual
Kenwood CD Player 382md User Manual
Hitachi Computer Drive HTS541680J9SA00 User Manual
Grindmaster 8306 User Manual
D Link DMP CD100 User Manual
ASA Electronics VOYAGER AWM900S User Manual
Airlink101 ANAS550 User Manual